AWH1045 - Water heater PHILIPS - Free user manual and instructions
Find the device manual for free AWH1045 PHILIPS in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | Electric Water Heater |
| Brand | Philips |
| Model | AWH1045 |
| Capacity | 10 liters |
| Power Rating | 1500 W |
| Voltage | 220-240 V ~ 50/60 Hz |
| Temperature Range | 30 °C to 75 °C |
| Dimensions (H x W x D) | 400 mm x 350 mm x 350 mm |
| Weight | 5.0 kg |
| Tank Material | Stainless steel |
| Energy Efficiency Class | C |
| Safety Features | Overheat protection, pressure relief valve, thermal cut-off |
| Installation | Wall-mounted, horizontal or vertical |
| Control Type | Adjustable thermostat |
| Ingress Protection | IPX4 |
| Warranty | 2 years |
Frequently Asked Questions - AWH1045 PHILIPS
How do I install the Philips AWH1045 water heater?
Installation should be done by a qualified professional. The unit must be wall-mounted securely, connected to the water supply and electrical mains. Ensure the pressure relief valve is properly fitted and the unit is filled with water before turning on power.
What is the recommended temperature setting for normal use?
For everyday use, set the thermostat between 50°C and 60°C to prevent bacterial growth and avoid scalding. Higher temperatures increase energy consumption and risk of burns.
How do I drain the water heater?
Turn off power and water supply. Open the hot water tap to release pressure, then open the drain valve at the bottom. Allow all water to flow out. Close the valve after draining.
What maintenance does the water heater require?
Periodically check the pressure relief valve by lifting the lever briefly to ensure it releases water. Descale the tank every 6-12 months depending on water hardness. Inspect the anode rod every 2 years and replace if necessary.
What does the pressure relief valve do?
It automatically releases excess pressure inside the tank to prevent damage or explosion. If water continuously drips from the valve, it may indicate a faulty valve or excessive water pressure.
Why is the water not heating up?
Check if the power supply is on, the thermostat is set correctly, and the circuit breaker has not tripped. If these are fine, the heating element or thermostat may be faulty and require professional replacement.
Can I use an extension cord with the water heater?
No, never use an extension cord. The heater draws high current which can overheat the cord and cause fire. Always plug directly into a properly rated wall outlet.
What should I do if I smell gas?
This water heater is electric; a gas smell indicates a gas leak from another appliance. Evacuate the area immediately, do not operate any electrical switches, and call the gas company from outside.
How long does it take to heat a full tank?
For a 10-liter tank at 1500W, heating from 20°C to 60°C takes approximately 20-25 minutes. Actual time depends on incoming water temperature.
Is the water heater safe for children?
The heater has overheat protection but the water can be hot. To prevent scalding, set the thermostat below 50°C or install a mixing valve. Supervise children when using hot water.
User questions about AWH1045 PHILIPS
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Water heater in PDF format for free! Find your manual AWH1045 - PHILIPS and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. AWH1045 by PHILIPS.