DT3012 - Pest control Dynatrap - Free user manual and instructions

USER MANUAL DT3012 Dynatrap

DYNATRAP INSECT TRAP

MODEL: DT3012

OWNERS MANUAL

Thank you for purchasing this

DYNATRAP ^9 Insect Trap!

This product may be covered by one or more U.S. patients

or passing patient applications. See www.eptestp.com/patient

IMPORTANT SAFETY INSTRUCTIONS

WARNING! When using electric applicants, basic precautions should always be followed, or asking the following

to turn off, remove ping from callel.

- Display from outlet when not in use and before servicing or cleaning. - To reduce the risk of a network switch, do not not distinguish in water or

— This procedure is provided with double insulation, also by isolation replacement as

See instructions for Survicing of Double-mediated Appliances.

INSTRUCTIONS FOR DOUBLE-INSULATED, CORD-CONNECTED APPLIANCES:

In a double-included application, two systems of simulation are provided instead of grounding. No grounding reason is provided

on a double-controlled appliance, nor should a means for grounding be added to the appliance. Servicing of a double-controlled appliance requires extreme care and knowledge of the system; and should be done only by qualified service personnel. Replacement parts for a double-controlled appliance must be identical to these parts in the appliance.

IMPORTANT SAFETY INSTRUCTIONS

Please read these instructions before using the DynaTrap® Insert Trap and keep for future releases.

1. Always turn unit off and disconnect plug before surviving, closing, or changing balls.

2. Suppose the tool is not a closed, so that

3. De net perman the and fact first, gets, on

4. Mount product out of much from this use.

5. Never operate this product if it has a damaged cord or plug, if it is not working properly, if it has been dropped or

dorsuped, or if it has been dropped into water

1. This product is equipped with 2-conductor cord and 2-prove polarized plug on a safety feature. This plug will fit in a polarized outlet only one way. If the plug does not fully fit in the outlet, then reverse the plug. If it still does not fit, then contact a qualified electrician to reduce the risk of electrical shock, only plug into a properly installed outlet. Do not attempt to defeat this safety feature.

2. This appliance is provided with double insulation. Use only identical replacement parts.

3. Do not insert fingers at any foreign objects into the unit while it is connected to an electrical outlet.

4. Collected fingers within the unit are attached to five or seven inches from the unit boundary.

5. Continue effects when the air may influence it now, to catch effects from the air sequence y.

6. Do part a sea this product with some words. Do not place where it can fall into water or near Fungmable patterns.

7. Avoid prolonged eye contact with the light

8. Do not obese cord—never carry or being until by cord or yenck it to disarmact from receptacle. Keep cord every from heart,

al, at sharp edges.

1. Keep every from all sources of resources. Do not operate the cell near any water source. Do not expose the oil and water sources or liquid at one hour.

PARTS LIST

HOW IT WORKS

"Sales would be replaced every 4 months (100 tons) to maintain required effectiveness."

INSTALLATION

11 for all two at a single of 8-4" to 8-4" from the floor,
210ml fresh bales with 1/7/8" bite a depth of 1-1/8". Insert

2. Incar the army into the wall and short living
3/18" of the second training out of coming the trap of
4. Hold the 3p rings on both sides and align the mounting holes with the
Now calling the best, that coming to be the best.

HOW TO USE

1. Use bottom of inner and call flow v low end.
   It is to cover up and book supported instead take out.
   

2) Push horc in of the board Folder down down
4) Remove line from 1st-2nd-3rd-5 on board and insert into hold to share or shift with side motion, (Stride Sola Ua)

Soil 30th bundle of the pie board holder spooks with you have a "fill".
4.2.10.10.10.10.10.10.10.10.10.10.10.10.10.10.10.10.10.10.
The Great 18 front cone and disengage the support bucket from the past.
Slowly beat the front panel and push to box street.
TIPS
Bying Water needs, as often from any other task in the environment, we recommend to adjust the 1-in-based every two weeks.

Being familiar or when to act on platform, we recommend to replace with a fresh glass board wolly.
- If more than 2/1 of the glue board is covered with marks, we recommend to replace with a fresh glue board.
REPLACING THE LIGHT BULBS

11. Use the top before replacing light beams
2) Add both ends of the right hook, rotate it 50 degrees. It up and serve nearly, insert a new left hook into the socket, hold both ends and turns it 70 degrees in the opposite direction
TIP
Barrow plus Board before replacing light bulbs

MAINTENANCE

1) light factor recommendations to be sold every 4 months [2,000 Board for optimal results] 2) light factor recommendations to be sold every 4 months (the light factor

If a result may be able to do it, the best of the best is being done.

TROUBLESHOOTING

Problem	Possible reason	Correction
Dental Work	1. No Power	1. Check the number of being in property connected to contact
It is done and illuminates	1. Use is damaged2. Plug is not connected3. Beaker is damaged	1. Replace with new bath2. Check using and re-connected3. Replace Beaker (contact customer service)
Has care not being required	1. Installed correctly2. Light use of contracting lines3. Glass band has required	1. Refer to removed for proper installation2. Replace with new light bars3. Replace with new glass band

LIMITED WARRANTY

DYNAMIC warranties to the original purchaser that this product is from defective materials and workmanship. This warranty is limited to remedy any defective part for a period at one year from date of original date of purchase. Return on your original receipt to proof of purchase. This warranty does not apply to the light bell, nor to, in our judgment, refuse or abatement. This unit has been altered, as warranty is its force. This warranty does not apply if this unit is purchased outside the United States, Canada and Mexico. In a case shall DYNAMIC to liable for any accidental, punitive, consequential, or any other damages of any kind for breach of this or any other warranty, expressed or implied, whatsoever. Some states do not allow limitation on how long an implied warranty lasts, so the above limitation or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have other rights that very from state to state.

PARTS & ACCESSORIES AVAILABLE

PART DESCRIPTION

330123 StickyTech™ G an Board Replacement Park for DTSC12 (pack # 1)

32050 CN Replacement 18 Sub (set of 2)

DYNAMIC

Dynamic Solutions Worldwide LLC

Dynamet Sorensen Worldwide, LLC

12247 6 100000

Phone: [phone]

Tel: [phone] (3727)

101 free fee: 877-403-2292

Email: [e-mail]

Visit as online of www.dyeating.com

20.16.14. 田小卫 US

SAVE THESE INSTRUCTIONS

Intertek

MODELO: DT3012

MANUAL DEL PROPIETARIO

Dynamic Solutions Worldwide, LLC

12247 W Fairview Lee, Milwaukee, WI 53226

Telephone: [phone]

Lamada Grels: 1-877-403-182P (3727)

Fachill 177 403-3251

CRI OYHOPHIOKUK