23550 - Microphone Konig & Meyer - Free user manual and instructions

Product Type	Microphone Stand with Boom Arm
Brand	Konig & Meyer
Model	23550
Material	Steel, zinc die-cast
Finish	Black powder-coated
Height Range	1050 - 1850 mm (41.3 - 72.8 in)
Boom Length	820 mm (32.3 in)
Base Diameter	250 mm (9.8 in)
Weight	2.5 kg (5.5 lbs)
Load Capacity (Boom End)	1.5 kg (3.3 lbs)
Thread Adaptability	3/8" and 5/8" thread (adapter included)
Clutch Type	Two-piece clutch for tilt and rotation
Boom Fixation	Locking screw and slip ring
Leg Design	Folding tripod with rubber caps
Included Accessories	Foldable boom arm, quick release clutch, plastic adapter for 5/8"
Maintenance	Clean with soft damp cloth; avoid solvents
Spare Parts Availability	Yes (contact K&M or authorized dealers)
Safety Notice	Always extend legs fully and tighten all locks before use
Intended Use	Studio and stage microphones, lighting accessories
Warranty	2 years (manufacturer defects)

Frequently Asked Questions - 23550 Konig & Meyer

How do I assemble the K&M 23550 microphone stand?

1. Unfold the tripod legs. 2. Attach the boom arm to the clutch using the locking screw. 3. Insert the boom assembly into the main shaft and tighten the clutch. 4. Adjust height by loosening the shaft lock, sliding to desired height, and re-tightening.

What is the maximum weight the boom can hold?

The boom end can support up to 1.5 kg (3.3 lbs). Exceeding this may cause instability.

Can I use this stand for a lighting fixture?

Yes, it can hold light accessories up to 1.5 kg, but ensure the stand is placed on a stable surface and all locks are tightened.

How do I adjust the angle of the boom?

Loosen the tilt screw on the clutch, tilt the boom to the desired angle, then re-tighten the screw securely.

What microphone threads are compatible?

The stand includes a plastic adapter for 5/8" thread and also supports 3/8" directly. Most standard microphones fit.

How do I prevent the stand from tipping over?

Always place the stand on a level surface. Extend the legs fully and avoid hanging heavy loads beyond the capacity. For outdoor use, use sandbags if needed.

Can I replace the boom arm?

Yes, replacement boom arms and clutches are available. Contact Konig & Meyer or an authorized dealer for spare parts.

How do I clean the K&M 23550 stand?

Use a soft, damp cloth to wipe the surface. Do not use abrasive cleaners or solvents that may damage the powder coating.

The clutch is slipping. What should I do?

First, ensure the tightening screw is fully tightened. If it still slips, check for wear or debris. Contact K&M support for possible clutch replacement.

Does the stand come with a carrying bag?

The standard package does not include a bag. However, K&M offers optional bags (e.g., model 23050) for transport.

USER MANUAL 23550 Konig & Meyer

Number of knurled 2 pieces screws

Spacing of holes from 60 to 172 mm

Special features no parts to lose;
connects to top of mic stands with 3/8" thread

Threaded connector 3/8"

Type black

Weight 0.06 kg

Connects to top of mic stands for holding 2 microphones or boom arms. 3/8" locking screws, adjustable from 60 to 172 mm.

Close-up of a black adjustable T-shaped stand with two metallic clips and a central vertical pole (no text or symbols visible)