IW75 - Pregnant Pure Acoustics - Free user manual and instructions
Find the device manual for free IW75 Pure Acoustics in PDF.
User questions about IW75 Pure Acoustics
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
Download the instructions for your Pregnant in PDF format for free! Find your manual IW75 - Pure Acoustics and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. IW75 by Pure Acoustics.
USER MANUAL IW75 Pure Acoustics
PREPARING THE LOCATION PREPARING THE LOCATION the paint is dry, remove the paint mask and replace the grill.
To mount your speaker, you need the following items (not supplied, available following items (not supplied, available at your local electronics store).
• drywall or keyhole saw
. wire stripper
• Phillips screwdriver
- pencil or marker
18-20 gauge speaker wire
-
Be sure the mounting surface is Between 3/8" (9.5mm) and 1 1/4" (31mm) Thick, with at least a 2 3/4" (69mm) clearance behind the Mounting surface and no wall studs or other objects to block the back of the speaker.
-
Remove the inner cardboard disc from the supplied template/paint mask and keep it for later. Use the outer portion as a template to mark the cutout hole size and location for mounting the speaker.
natural_image
Line drawing of a hand holding a blank rectangular object with a pencil, no text or symbols present- Use a drywall or keyhole saw to cut the hole.
PREPARING THE SPEAKER
If you choose to paint the frame and grille, paint them and let them dry before you connect the speaker wire or mount the speaker.
To remove the grille for painting, insert a paper clip into one of the grille openings then pull up. Or, you can carefully twist the plastic frame back and forth until the grille edge becomes exposed, then lift the grille to remove it. or use the grill remover to remove the grille.
natural_image
Line drawing of two hands holding a rectangular object with a mesh pattern (no text or symbols)Carefully remove the dust cloth from behind the grill and replace it after you are finished painting.
You can also paint the frame to match your wall or ceiling. To prevent paint from entering the speaker, remove the grill and insert the supplied cardboard paint mask. After
CONNECTING THE SPEAKER WIRES CONNECTING
Your local electronics store sells a wide selection of speaker wire. We recommend you use wire that is color-coded or marked on one side to help you connect the wire correctly
- Route the speaker wire to the speaker from the receiver.
- Separate about 4"(101mm) of Speaker wire at each end.
- Using a wire stripper, remove about 1/4"(6mm) of insulation from each wire. Then twist the ends of each wire.
- Connect the marked wire to a red Speaker terminal by pressing the release tab, inserting the wire into the hole, and then releasing the Tab. Repeat this procedure to connect the unmarked wire to the balck terminal.
- Connect the marked wire coming from the speaker to the left channel of the receiver's positive (+) terminal. Then connect the unmarked wire to the left Channel of the amplifier's negative (-) terminal.
MOUNTING THE SPEAKER MOUNTING THE SPEAK
- Remove the grill to expose the mounting screws.
- Be sure the mounting tabs are turned in, allowing the speaker to fit into the hole. Then insert the speaker into the mounting hole.
- Use the four screws to tighten the mounting tabs to the wall or ceiling. Be careful not to over tighten the screws.
- Replace the grille.
To remove the speaker from the wall or ceiling, loosen the screws only far enough to remove the speaker. This will prevent loss of the mounting tabs.