RE119 - Uncategorized Alula - Free user manual and instructions
Find the device manual for free RE119 Alula in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | Wireless Motion Sensor |
| Model | RE119 |
| Brand | Alula |
| Dimensions (mm) | 80 x 60 x 25 |
| Weight (g) | 45 |
| Power Source | 1x CR123A 3V Lithium Battery |
| Battery Life | Up to 5 years (typical) |
| Detection Range | 12 meters (40 ft) |
| Detection Angle | 90 degrees |
| Wireless Protocol | Z-Wave |
| Operating Temperature | -10°C to 50°C |
| Operating Humidity | 5% to 95% non-condensing |
| Installation | Wall mount using included brackets |
| LED Indicator | Red/Green for status |
| Tamper Protection | Yes, anti-tamper switch |
| Certifications | FCC, IC, CE |
| Color | White |
| Package Contents | Sensor, mounting kit, battery, manual |
Frequently Asked Questions - RE119 Alula
How do I pair the RE119 with my hub?
Put the hub into pairing mode. Insert the battery into the RE119 while holding the tamper switch. The LED will flash rapidly to indicate successful pairing.
What type of battery does the RE119 use?
The RE119 uses a CR123A 3V lithium battery. Do not use rechargeables.
How do I replace the battery?
Remove the sensor from its mount, press the tamper switch to release the cover, then replace the old battery with a new CR123A. Reattach cover and remount.
How do I clean the RE119?
Wipe the exterior with a soft dry cloth. Do not use water, solvents, or abrasives.
What is the wireless range of the RE119?
In open space, the range is up to 30 meters (100 ft). Walls and obstacles may reduce this.
How do I mount the RE119?
Use the included mounting brackets and screws. Mount at a height of 2 meters (7 ft) for optimal detection.
What do the LED flashes mean?
Red flash indicates alarm or low battery. Green flash indicates normal operation or successful communication.
How do I reset the RE119 to factory defaults?
Remove the battery, press and hold the tamper switch for 10 seconds, then reinsert the battery. The LED will blink red twice.
Can the RE119 work with other smart home systems?
The RE119 uses Z-Wave protocol and is compatible with any Z-Wave certified hub or controller.
How do I test the RE119?
Walk across the detection area. The LED should flash green and the hub should trigger an event. If not, check placement and battery.
User questions about RE119 Alula
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Uncategorized in PDF format for free! Find your manual RE119 - Alula and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. RE119 by Alula.
