Machete MA-5500.1D Sport - Receiver Deaf Bonce - Free user manual and instructions
Find the device manual for free Machete MA-5500.1D Sport Deaf Bonce in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | Car Audio Amplifier |
| Model | Machete MA-5500.1D Sport |
| Brand | Deaf Bonce |
| Amplifier Class | D |
| Number of Channels | 1 (Monoblock) |
| RMS Power (1 ohm) | 1500W x 1 |
| Peak Power | 5500W |
| Frequency Response | 20Hz - 250Hz |
| Low Pass Filter | 50Hz - 250Hz |
| Subsonic Filter | 10Hz - 50Hz |
| Bass Boost | 0 - 12dB |
| Input Sensitivity | 0.2V - 6V |
| Dimensions (L x W x H) | 12.6 x 7.2 x 2.2 inches |
| Weight | 8.5 lbs |
| Power Supply | 12V DC |
| Fuse Rating | 250A |
| Minimum Impedance | 1 ohm |
| Signal to Noise Ratio | >100 dB |
| Damping Factor | >200 |
| Remote Sub Level Control | Included |
| Protection Circuits | Thermal, Overvoltage, Short Circuit |
| Recommended Fuse | 250A |
Frequently Asked Questions - Machete MA-5500.1D Sport Deaf Bonce
What is the recommended wire gauge for power and ground connections?
For the MA-5500.1D Sport, use 1/0 AWG copper wire for power and ground to ensure sufficient current capacity. Always fuse the power wire within 18 inches of the battery.
Can this amplifier run at 2 ohms?
Yes, the amplifier is stable into 2 ohms, but it will deliver less power than at 1 ohm. For maximum performance, use a 1 ohm load if supported by your subwoofer.
What type of subwoofer is compatible?
This monoblock amplifier is designed for subwoofers with a dual voice coil configuration to achieve a 1 ohm load. Ensure the subwoofer's RMS rating matches the amplifier's output.
How do I adjust the gain setting?
Set the gain using a multimeter or oscilloscope to match the preamp voltage. Start with the gain at minimum, play a 50Hz test tone at 3/4 volume, and adjust until you reach the desired voltage (square root of power times impedance). Never use gain as volume control.
What is the purpose of the subsonic filter?
The subsonic filter removes frequencies below a set point (usually around 20-30Hz) to prevent the subwoofer from trying to reproduce very low frequencies that can cause damage, especially in ported enclosures.
Does the amplifier include a remote bass knob?
Yes, it comes with a remote sub level control that allows you to adjust the bass volume from the driver's seat.
What is the recommended enclosure type?
Both sealed and ported enclosures are suitable. For maximum SPL, use a ported box tuned around 30-35Hz. For tighter bass, use a sealed box. Ensure the enclosure volume matches the subwoofer specifications.
How do I troubleshoot if the amplifier goes into protect mode?
Check for short circuits in speaker wiring, ensure the power and ground connections are secure, verify the impedance load is not too low, and check for overheating. Also, confirm the battery voltage is between 10-16V.
What is the maximum input voltage?
The input sensitivity ranges from 0.2V to 6V, so it can accept high-voltage RCA signals from aftermarket head units. If your head unit has high-voltage preouts (up to 6V), set the gain accordingly to avoid clipping.
How do I clean and maintain the amplifier?
Regularly dust the heatsink with a soft brush or compressed air. Avoid liquids. Ensure proper ventilation. Periodically check all connections for corrosion and tighten screws. Do not block the cooling fan if present.
User questions about Machete MA-5500.1D Sport Deaf Bonce
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Receiver in PDF format for free! Find your manual Machete MA-5500.1D Sport - Deaf Bonce and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. Machete MA-5500.1D Sport by Deaf Bonce.