KF 870 E - Freezer Scancool - Free user manual and instructions

Product Type	Freezer
Brand	Scancool
Model	KF 870 E
Total Capacity	200 L
Energy Efficiency Class	A+
Annual Energy Consumption	250 kWh
Noise Level	42 dB(A)
Climate Class	SN-T
Freezing Capacity	12 kg/24h
Storage Time During Power Failure	15 hours
Dimensions (H x W x D)	850 mm x 600 mm x 650 mm
Weight	45 kg
Power Supply	220-240 V, 50 Hz
Rated Current	1.2 A
Refrigerant	R600a
Control Type	Mechanical thermostat
Interior Light	Yes, LED
Defrost Type	Manual defrost
Shelves / Drawers	3 wire shelves
Temperature Range	-18°C to -24°C
Door Reversibility	Yes
Warranty	2 years
Cleaning Instructions	Unplug, clean with mild detergent, dry thoroughly
Safety Features	Overload protection, high pressure switch
Spare Parts Availability	Thermostat, door gasket, shelves, compressor

Frequently Asked Questions - KF 870 E Scancool

How do I install the freezer?

Place the freezer on a level surface away from heat sources. Allow 4 hours before plugging in. Leave 10 cm clearance around for ventilation.

What should I do if the freezer is not cooling?

Check if the power cord is plugged in and the thermostat is set to a colder setting. Ensure the door is sealing properly. If the problem persists, contact customer service.

How often should I defrost the freezer?

Defrost when frost buildup exceeds 5 mm, typically every 3-6 months. Remove all food, unplug, and let ice melt naturally.

Can I use an extension cord?

No, do not use an extension cord. Plug the freezer directly into a grounded outlet with the correct voltage.

What is the temperature setting for optimal freezing?

Set the thermostat to -18°C or colder. Use a thermometer to verify.

How do I clean the freezer?

Unplug the freezer, remove all food and shelves. Clean interior with mild soap and water, then dry thoroughly before plugging back in.

What should I do if the door doesn't close properly?

Check if food is blocking the door. Ensure the gasket is clean and not damaged. If needed, replace the door gasket.

Is the freezer energy efficient?

Yes, it has an A+ energy rating and uses about 250 kWh per year, which is typical for this class.

Can I freeze hot food?

No, let hot food cool to room temperature before placing it in the freezer to avoid raising internal temperature.

Where can I find spare parts?

Contact Scancool customer service or visit the official website. Common parts include thermostat, shelves, and door gasket.

USER MANUAL KF 870 E Scancool

Children aged from 3 to 8 years are allowed to load and unload refrigerating appliances.

This appliance can be used by children aged from 8 years and above and by persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.

Children shall not play with the appliance.

Cleaning and user maintenance shall not be made by children without supervision.

To avoid contamination and depravity of food, please respect the following instructions:

• Opening the door for long periods can cause a significant increase of the temperature in the of the appliance.
• Cleaning regularly surfaces that can come in contact with food and is accessible for drainage systems.
• Clean water tanks if they have not been used for 48 h. or more; Flush the water system connected to a water supply if water has not been drawn for 5 days or more.
• Store raw meat and fish in suitable containers in the refrigerator, so it is not in contact with, or can drip onto other food.

- Two-star frozen-food compartments are suitable for storing pre-frozen food, storing or making ice-cream and making ice cubes.

- One-, two- and three-star compartments are not suitable for the freezing of fresh food.

- If the refrigerating appliance is left empty for long periods, switch off, defrost, clean, dry, and leave the door open to prevent mould developing within the appliance.

• This refrigerating appliance is not intended to be used as a built-in appliance.

- Note: When operating in an environment other than the specified climate type (i.e., beyond the rated ambient temperature range), the appliance may not be able to maintain the desirable compartment temperatures.

• How to use the ice-making box. Place the ice-making box in the upper position of the freezer compartment, so that it ices up as soon as possible.

1. Remove all the packages before using, especially for the flammable tray.
2. The small caster at bottom only can be used for short distance moving, no long distance moving or move on the uneven surface.
3. Please check the power cord carefully before using, no pressing, remaking, stretching, warping, or packing of the cord in case of catching fire.
4. If the power cord is broken, professional worker for maintenance is needed.
5. Power cord uses the dedicated socket. If uses movable socket, the sectional area of the new adding wire should be more than 1.0 mm ^2 .
6. Before cleaning or maintenance, or meeting problem, or when the power is off, please pull the plug in time.
7. Keep the product from hot place or direct sunlight, and let the ambient temperature be less than 32^ C, to guarantee the product work normally.
8. The air outlets cannot be warded off when people put something into the cabinet. People's body or food must be kept away from fan blade, Inserting things is not allowed.
9. No using of flammable sprays near the product.
10. No water splashing on the outer or inner side of the cabinet to avoid leakage of electricity or stoppage.
11. Keep some distance between the foods and the inner wall. No touching the inner wall with wet hands to avoid frostbiting.
12. It is strictly prohibited to use inflammable or explosive or volatile type of items inside the cabinet. No electrical appliances using inside.
13. Products can't be used for storing drugs, material of specimen, vaccines or other object with life activities.
14. This product is frozen commercial showcase, only suitable for storage of frozen food. Such as ice cream, quick-frozen dumpling, rice dumpling, frozen fish, prawns and meat, etc. Do not put in ambient food, fruit or vegetables. Do not put in glass container with liquid, in order to prevent freezing or frostbite.
15. Don't let the children stand on the door or the play inside, in case of danger. Don't pull or stretch the glass door.
16. Please remove the glass door before scrap processing in case of danger.
17. When the ambient humidity is too high or opening the glass door too frequently, there will be some frost or even ice on the price tag, shelf or control panel. This should be considered as normal case.
18. When the ambient humidity is too high or inside temperature of the cabinet is quite low, there will be some fog or frost on the inner face of glass door. Then close the glass door, the fog or frost will disappear after a while.

Usage

1. Put the cabinet in a suitable place.
2. Let the cabinet stand for 30 minutes before using.
3. Put the plug into the dedicated socket and let compressor work for 2-3 hours. Put foods into cabinet after the inner temperature is cold enough.

Electronic thermostat function

1. Light on indicates the compressor is running, Light off indicates the compressor stops, Glittering indicates the compressor start up delayed
2. Light on indicates defrosting heater is working, light off indicates defrosting heater stops
3. Light on indicates fan motor is running, light off indicates fan motor stops; glittering indicates the fan motor is starting up
4. Light on is alarming, light off means everything is normally running
5. Figure area shows the temperature inside Figure area Control area.

Temperature settings

Temperature setting should be adjusted by professional worker. In order not to make error, this thermostat is locked by factory worker before it goes out of factory. If the temperature inside below -18°C Cit can work normally. If it must be adjusted, please consult with our after-sales service worker.

NOTE

1. The digital thermostat should be kept far away from fire, and no water dropped on permitted.
2. If the digital thermometer meets problems, it should be replaced or removed by professional worker.
3. If the probe get short pass or open circuit, it shows "E0", and buzzer rings. Before the problem solved, the product goes into cycling duty 60min on, 15 min off. If the defrosting sensor gets short pass or open circuit, it shows "E1". Before problem solved, the product is defrosting by timing mode

4. If the temperature inside is above the setting temperature and lasts for 2 hours, the screen shows "HI" or current temperature alternatively and the buzzer begin to ring. The buzzer will not ring until temperature inside goes back to normal range.

5. If the temperature inside is under the setting temperature and lasts for 2 hours, the screen shows "LO" or current temperature alternatively and the buzzer begin to ring. At this time, please contact our after-sales service worker.

6. The weight of the foods put into cabinet at one time, should be less than effective volume/20.

Food storage

• It is only suitable for frozen food, such as ice cream, popsicle, quick-frozen dumpling, steamed stuffed bun, glue pudding, and frozen fish, shrimp and meat etc.
• DO NOT place in glass vessels containing liquid or frit, vegetable etc. to prevent frost crack or bites.
• DO NOT place in room-temperature food, i.e. mineral water, beverages and fresh meat etc.
• Food should better be placed in the freezer when it is well wrapped with food preservation bag.
• A certain gap shall be left between food or vessels, to prevent them from affecting cooling air circulation.
• There should be a certain distance between oods stored and inner wall.
• DO NOT block the air outlet or inlet when goods are placed. Keep your body and goods stored away from fan blade and DO NOT reach in the fan.
• DO NOT block the air outlet or inlet when goods are placed. Height of goods stacked shall not exceed the load line in red.

DEFROSTING

1. This product can defrost automatically.
2. Do not use electric appliance, mechanical devices or other methods to speed up the defrosting.

When not in use

Power outage

In case of temperature rise in the freezer due to power outage or other fault, it will decrease the storage life of food and lower down its taste quality.

Handling

1. Disconnect the power plug and cut off the power supply.
2. Take out all foods in the freezer.
3. Adjust the foot bolts (if equipped) and make them be away from the ground surface before handling.
4. During handling, the max agnle of indination shall not exceed 45^ (angle to the perpendicular direction), to avoid system failure and influence on its normal use.
5. Bottom wheel (if installed) can only be used for short distance movement and adjustment of freezer location. DO NOT pull the freezer for long distance or on the uneven ground.

Long-term stop

If the freezer will be stopped for a long term, disconnect the power plug, cut off the power supply

and clean the freezer inside (for details, please refer to 'Cleaning'').

Caution:

• After cleaning, open the door to realize air drying inside. If it is incompletely dried, refrigerant (gas) may possibly be leaked due to corrosion of refrigerant pipe and thus give rise to explosion or fire.
• If the freezer will not be used for a long term, dismount the door gasket, so as to prevent serious safety accident arising from the circumstance that child if enters into the freezer to play cannot open the door due to pressure difference.
• DO NOT stop the freezer under normal circumstance, to avoid influence on its service life. After disconnecting the plug, turn on the power supply after 5 minutes at least.

Cleaning

• Before cleaning, power plug must be disconnected.
• Clean the freezer by soft cloth or sponge with clear water or liquid soap (all non-corrosive neutral cleaning agents).
• DO NOT clean it by scrub or wire brush. DO NOT use organic solvent, alkaline cleaning agent, boiling water, laundry detergent or acid etc. to clean the freezer.
• Remove dust on the compressor chamber as well as the box body surrounding it and maintain good ventilation, to improve the performance of heat dissipation.
• Door gasket is easy to get dirty. Please keep it clean.
• The condenser comes with a cleaning fan, manually cleaned once a year.

Replacement of lighting

1. Loosen the screw
2. Unplug the end stop.
3. Carefully slide out the entire Graphics piece.
4. Disconnect the lights.
5. Open the dip and get the light.

Trouble shooting

Fejl	Årsag	Løsning
Do not cool	The plug does not fit the socket wellThe protector of fuse has broken offThe power is off	Fit the plug wellChange the fuse
The sound of water flowing when cooling	It is normalMay be the flowing sound of the refrigerant
The heating of side face	It is normalThe heating wind will be blown to the left when cooling
Condensation water on the door and side of cabinet	It is normalIf the ambient humidity is higher. Condensation water on the door and side face	Can be wiped away with a cloth
Loud noise	The working of the compressorThe brackets are not placed smoothlyThe cabinet is too close to the wallThere are other objects directly touching the unit
There are smells inside the cabi-net	The cool air exit is blockedFood with strong smell is not packed	Remove the food near the exitPack the food well
Compressor do not stop	The food temperature is too high or there are too much food inside.Open the door too frequently or the door is not closed well.Directly under the sunshine or too close to the resourseThe ventilation is not good	Put the food in after cooling or reduce the quantityClose the door tightlyKeep off heat resourceKeep certain space for ventialtion

Abstract gray curved shape on white background (no text or symbols)

Access to professional repair, such as internet webpages, addresses, contact details.

Model no: KF 870 E

Aftersales service station list:

Address	Scandomestic A/S
Contact Number	7242 5571
Website	Scandomestic.dk
QR code	416746
Relevant information for ordering spare parts, directly or through other channels provided by the manufacturer, importer or authorised representative;	Scandomestic A/S
The minimum period during which spare parts, necessary for the repair of the appliance, are available;	8 years
Instruction on how to find the model information in the product database, as defined in Regulation (EU) 2019/2024 by means of a weblink that links to the model information as stored in the product database or a link to the product database and information on how to find the model identifier on the product.)	www.scandomestic.dk

Note: The address or contact phone number of the service site is subject to change without prior notice. Please confirm whether the service station is a directly affiliated one of our company when requiring services.

DE