Question 1

How to remove the water inlet hose from the CAMTECH ZBS-20 ice maker?

Accepted Answer

To remove the water inlet hose from your CAMTECH ZBS-20 ice maker, follow these simple and safe steps:

Steps to remove the water inlet hose

Unplug the machine: Make sure the device is unplugged from the electrical outlet to avoid any risk of electric shock or accidental startup.
Shut off the water supply: Locate the valve or faucet that supplies water to the machine and turn it off to prevent any leaks while removing the hose.
Access the back of the machine: Carefully move the machine to access the back where the water inlet hose connection is located.
Loosen the connection: Depending on the type of connection, use a wrench or your hands to unscrew the hose. Turn counterclockwise to unscrew it. If the connection is a quick connect, press the release ring before pulling the hose.
Remove the hose: Once the connection is loosened, gently pull the hose out of the machine.
Check for leaks: Place a container under the connection area to catch any residual water and ensure there are no leaks.

By following these steps, you can safely remove the water inlet hose without damaging your CAMTECH ZBS-20 ice maker.

Question 2

Where should I put the water in the CAMTECH ZBS-20 ice maker?

Accepted Answer

Your CAMTECH ZBS-20 ice maker has a removable water tank with a capacity of 1.8 liters. You have two options to fill this tank: by manual method or by automatic connection to the water supply of your installation.

For manual filling, open the top cover of the machine, remove the ice basket, and then pour drinking water or spring water directly into the water tank located inside. Never fill the tank beyond the maximum fill line indicated, and ensure that the water does not cover the bottom of the ice basket after filling. This is important for the proper functioning of the freezing system.

If you prefer automatic filling, you can connect a water hose to the water inlet located at the back of the machine. This inlet uses a standard 3/4" thread. The system will then automatically supply water as needed during ice production.

Important: only use drinking water or spring water to fill the tank. Absolutely avoid pure water or fruit juices and other beverages, which would damage the machine. To ensure the purity and quality of your ice cubes, replace the water in the tank every 24 hours if you are using manual filling.

Once the tank is filled and the cover is closed, plug in the machine and press the ICE button to start the production. If the ADD WATER light comes on during operation, it means that the amount of water is no longer sufficient. Remove the basket, add water up to the maximum line, and then press the ADD WATER button twice to restart the cycle.

User manual CAMTECH : user manuals and guides in PDF

Models CAMTECH most viewed

Browse manuals CAMTECH by appliance type

Recent questions about devices CAMTECH