Question 1

How do I adjust the display brightness on the TECHNISAT Digitradio 360 CD IR radio?

Accepted Answer

To adjust the display brightness of your TECHNISAT Digitradio 360 CD IR radio, access the dedicated menu by following this path: MENU > Main menu > System settings > Brightness.

Once in this menu, you must first select the adjustment mode:

Mode: to adjust the brightness during normal operation of the radio
Standby: to set the brightness when the device is in standby

Depending on the selected mode, you can choose from the following brightness levels:

In Mode (operation): three levels available - High, Medium, or Low
In Standby: three levels available - Medium, Low, or Off (disabled)

In Standby mode, you also have the option to adjust the Display Duration. This setting controls the delay after which the screen lighting automatically dims to the set brightness after the device is turned off. This allows you to tailor the screen behavior to your preferences, keeping the display visible for more or less time before the brightness decreases.

Question 2

How to set the alarm time on the TECHNISAT DIGITRADIO 51 digital radio receiver?

Accepted Answer

To set the alarm time on your TECHNISAT DIGITRADIO 51 digital radio receiver, follow these simple steps:

Steps to set the alarm time

Turn on the device: Make sure your DIGITRADIO 51 is powered on.
Access the main menu: Press the Menu button to open the available options.
Select the alarm option: Use the navigation buttons to find and select Alarm or Alarm Settings.
Set the alarm time: Once in the alarm menu, adjust the hours and minutes using the navigation buttons to the desired alarm time.
Confirm the setting: Validate your choice by pressing the OK or Confirm button to save the alarm time.
Repeat if necessary: If your device allows programming multiple alarms, repeat these steps for each one.

After these settings, your alarm will be programmed to sound at the set time. You can also choose the sound or source of the alarm according to the options available on your DIGITRADIO 51.

Question 3

How to save a station as a preset on the TECHNISAT DIGITRADIO 51 digital radio receiver?

Accepted Answer

On your TECHNISAT DIGITRADIO 51 digital radio receiver, you can save up to 10 stations as presets for quick access to your favorite stations. The saving procedure is simple and works in both DAB+ and FM modes.

Procedure to save a station:

First, select the radio station you want to save by using the navigation buttons to browse the available stations in DAB+ or FM.
Once the station is found and playing, press and hold one of the numbered preset buttons (from 1 to 10).
Continue to hold until you hear a beep confirming the saving or until a confirmation message appears on the device's screen.
The station is now saved in that preset location.

Accessing your saved stations:

To listen to a saved station, simply press (without holding) the corresponding preset button.
The device will immediately switch to the saved station.

Replacing a station:

To change an already saved station, select a new station and hold down the same preset button for a few seconds until the confirmation beep.
The old station will be replaced by the new one, without affecting the other presets.

This feature allows you to quickly save your favorite stations and easily access them at any time by simply pressing the corresponding preset button.

User manual TECHNISAT : user manuals and guides in PDF

Models TECHNISAT most viewed

Browse manuals TECHNISAT by appliance type

Recent questions about devices TECHNISAT