How to set the impedance (ohms) on the MAGNAT MR 780 amplifier?

Question

Accepted Answer

The MAGNAT MR 780 amplifier does not have a direct setting for impedance (ohms), as this is a property of the speakers themselves, not the amplifier. Impedance is the electrical resistance that speakers present to the flow of the audio signal. The MR 780 is designed to work with speakers that have an impedance between 4 and 8 ohms.

Before connecting your speakers, check their impedance by consulting their technical manual or the specifications indicated on their label. This value should be within the 4-8 ohm range to ensure optimal operation and avoid overheating or damage to the amplifier. The MR 780 delivers a power of 100 W per channel at 4 ohms or 75 W per channel at 8 ohms, depending on the impedance of your speakers.

To properly connect your speakers to the rear terminals of the MR 780, first prepare your high-quality audio cables (minimum gauge 1.5-2.5 mm²). Strip the ends about 10 mm and twist the wires. Then, unscrew the terminal screws one by one and insert the stripped ends into the side openings. Tighten the screws while ensuring the correct polarity: red or marked (+) wire to the positive terminal, black or unmarked (-) wire to the negative terminal.

You can also use pre-made cables with 4 mm banana plugs or fork connectors, which plug directly into the terminals. The MR 780 accepts bi-wiring, meaning you can use two pairs of cables per speaker (one for bass, one for treble) if your speakers allow it.

If you plan to connect multiple pairs of speakers or wire in parallel, ensure that the total impedance remains at 4 ohms or higher. An impedance that is too low could trigger the amplifier's protection. Also, check your speakers' manual to verify their compatibility with the MR 780.

User manual MAGNAT : user manuals and guides in PDF

Models MAGNAT most viewed

Browse manuals MAGNAT by appliance type

Recent questions about devices MAGNAT