Question 1

How to reset the LEXMAN 2 indoor surveillance camera to factory settings?

Accepted Answer

To reset your LEXMAN 2 indoor surveillance camera to factory settings, follow these simple steps:

Locate the reset button: It is usually found at the back or underneath the camera, often in a small hole marked "Reset".
Prepare a sharp object: Use a straightened paperclip, a pin, or a similar small tool to reach the button.
Press and hold the button: Press the reset button for about 10 to 15 seconds. You should see the indicator lights flashing, indicating that the reset is in progress.
Release the button: Once the lights are flashing, release the button. The camera will automatically restart and return to its factory settings.

After this operation, the camera will be like new, and you will need to reconfigure it, including connecting to the Wi-Fi network and custom settings.

Question 2

How to solve a Wi-Fi connection problem with the LEXMAN 2 surveillance camera when the box password does not work?

Accepted Answer

If you are having trouble connecting your LEXMAN 2 surveillance camera to your Wi-Fi network despite entering the password for your box, here are several steps to follow to resolve this issue:

1. Check the Wi-Fi password

Make sure the password is entered correctly, respecting uppercase, lowercase, and special characters.
Try entering the password on another device to verify its validity.

2. Proximity and signal quality

Place the camera close to the router during setup to avoid a weak or unstable connection.
Check that the Wi-Fi network is functioning properly with other devices.

3. Wi-Fi network compatibility

The LEXMAN 2 camera is generally compatible with 2.4 GHz Wi-Fi networks. Ensure that you are trying to connect it to a 2.4 GHz network and not a 5 GHz one.
Check that the router's security mode is compatible, ideally WPA2. Some modes like WEP may not be supported.

4. Restarting and resetting

Restart the camera to reset the connection.
If the problem persists, perform a factory reset according to the specific procedure for your model, then start the setup again.

By following these tips, you should be able to connect your LEXMAN 2 camera to your Wi-Fi network. If the problem continues, it may be helpful to check the advanced settings of your router or contact technical support.

User manual LEXMAN Indoor security camera : user manuals and guides in PDF

Models LEXMAN Indoor security camera most viewed

Other categories LEXMAN

Recent questions about Indoor security camera LEXMAN