Question 1

How to access the receiver of the CHAMBERLAIN LM60R-128 garage door opener?

Accepted Answer

To access the receiver of your CHAMBERLAIN LM60R-128 garage door opener, you must first disconnect the power supply to the device for safety reasons before any handling.

The receiver is located directly on the motor, under the light bulb lens (the transparent plastic cover). Open this lens by gently tilting it downwards. You will then discover the orange "LEARN" button, which is the main component of the programmable receiver.

This orange "LEARN" button allows you to program your remote controls or your keyless entry system. When you press this button, a learning indicator lights up continuously for 30 seconds. You have this time to transmit the code from your remote control. Once the code is received, the garage door light blinks, confirming the code has been registered (or two beeps if you have not installed the light).

Important note: you generally should not remove the main cover of the garage door opener. Simply accessing the light lens is sufficient to program the receiver or perform basic maintenance. If you need to access the circuit board itself, we recommend contacting a professional.

Question 2

How to program two universal remotes with the CHAMBERLAIN LM60R-128 garage door opener?

Accepted Answer

To program two universal remotes with your CHAMBERLAIN LM60R-128 garage door opener, follow the steps below:

Programming Steps

Preparation: Ensure that the garage door opener is powered on and that you have both universal remotes within reach.
Access the receiver: Open the motor housing of the garage door opener to locate the receiver. You may need to remove a few screws to access the programming button.
Activate programming mode: Find the button marked "Learn" or "Program" on the receiver. Press this button once. A LED will light up to indicate that the receiver is in programming mode.
Program the first remote: Press the button on the first remote you want to program. The LED on the receiver will blink and then turn off, indicating that the remote has been registered.
Program the second remote: Repeat the process: press the "Learn" button on the receiver again, then press the button on the second remote. The LED will confirm the programming.
Test the remotes: Check that both remotes work correctly by opening and closing the garage door.
Close the housing: Once programming is complete, close the motor housing to protect the components.

This procedure allows you to add multiple universal remotes to your CHAMBERLAIN LM60R-128 system to easily control your garage door.

User manual CHAMBERLAIN Garage door opener : user manuals and guides in PDF

Models CHAMBERLAIN Garage door opener most viewed

Other categories CHAMBERLAIN

Recent questions about Garage door opener CHAMBERLAIN