How do I disassemble the case of the DENON RC 1167 remote control?

Question

Accepted Answer

Disassembling the case of the DENON RC 1167 remote control is a simple operation but requires caution to avoid damaging the internal plastic clips. Here’s how to proceed step by step.

Before you begin, remove the 2 AAA (LR03 1.5 V) batteries from the remote control. This step is essential to avoid any risk of short-circuiting or damaging the internal electronic components. Turn the remote control over and open the battery compartment by sliding it open.

Once the batteries are removed, locate the screw inside the battery compartment. Use a small Phillips screwdriver suitable for unscrewing this screw. Keep it safe, as it is essential for reassembly. Most screws in DENON remote controls are small, so a precision screwdriver is recommended.

After removing the screw, you need to open the case by separating the two halves. To do this, gently insert the blade of a flat screwdriver into the gap between the two parts of the case, starting from a lower corner. The RC 1167 remote control has several locking clips (usually 4 on each side) that hold the two parts together. You will need to apply slight force to get past these clips, but proceed gradually by applying steady pressure rather than a sudden force. Work on one corner first, then progress around the case to avoid deforming it.

Once all the clips are released, the two halves of the case will separate, revealing the circuit board, battery contacts, and rubber keypad. Handle the internal components carefully, especially the circuit board and keypad, which are delicate. If you need to clean the inside, gently wipe with a dry, lint-free cloth.

For reassembly, proceed in reverse order. Reinsert the circuit board and rubber keypad, ensuring they are properly aligned, then snap the two halves together by pressing firmly until all the clips lock into place. Screw the screw back into the battery compartment and reinstall the 2 AAA batteries, respecting the polarity indicated by the “+” and “-” markings visible inside the compartment.

Important tips: Be patient when opening and do not force excessively to avoid breaking the plastic clips. If access to the battery compartment proves difficult for the screw, try to open it a little more with the flat screwdriver. After reassembly, check that the remote control does not have any play and that the case is properly closed before reinserting the batteries to test its functionality.

User manual DENON Remote control : user manuals and guides in PDF

Models DENON Remote control most viewed

Other categories DENON

Recent questions about Remote control DENON