How to unlock and change a program stuck at 40 degrees on the DARTY DWF4812SL dishwasher?

Question

Accepted Answer

If your DARTY DWF4812SL dishwasher is stuck on the 40-degree program and you cannot change the program, here are several steps to follow to resolve this issue:

1. Check the door closure

Make sure that the dishwasher door is properly closed and locked. A poor lock can prevent the program from being changed.

2. Cancel or reset the current program

Look for a Cancel or Stop button on the control panel and press it to try to interrupt the current cycle.
If the dishwasher does not respond, try holding the start or cancel button for a few seconds to force a reset.

3. Perform a power cut

Unplug the appliance from the electrical outlet for about 5 minutes, then plug it back in. This operation may allow the electronic system to reset and unlock the program.

4. Check the control panel

Ensure that no button is stuck or pressed down, which could prevent the selection of another program.

5. Try selecting another program

After following the previous steps, attempt to choose another program to check if the issue is resolved.

If despite these manipulations the problem persists, it may be a technical defect requiring intervention from a professional or customer service.

User manual DARTY Dishwasher : user manuals and guides in PDF

Models DARTY Dishwasher most viewed

Other categories DARTY

Recent questions about Dishwasher DARTY