Question 1

What is the battery life of the NUTRIBULLET Flex?

Accepted Answer

The NUTRIBULLET Flex is equipped with a rechargeable lithium-ion battery. Although the manual does not specify an overall battery life in hours, it states that each blending cycle lasts up to 30 seconds and that the device can support up to 4 consecutive cycles in 3 minutes.

The battery fully charges in up to 2 hours via USB-C (5 V - 2 A). The charge status is visible thanks to the 4-level LED bar integrated, allowing you to check the available battery life before use.

Note: the battery is not user-replaceable and must be recycled in accordance with current regulations.

Question 2

How long does it take to fully charge the NUTRIBULLET Flex battery?

Accepted Answer

The lithium-ion battery of the NUTRIBULLET Flex fully charges in up to 2 hours. The exact time depends on the power supply used and the initial state of the battery.

Charging procedure:

Lift the silicone cap at the back of the motor block to access the hidden USB-C port
Connect the supplied USB-C cable to the charging port
Plug the other end of the cable into a UL-certified power supply delivering 5 V – 2 A maximum
Do not use a fast charger or non-certified power supply, as they may damage the battery

Safety instructions: Before charging, ensure that the device and the USB-C port are not wet. Do not charge in a very hot or very cold environment. The recommended charging temperature is 10 °C to 40 °C. Always unplug the power supply when the device is not charging.

Charge monitoring: A 4-level LED bar indicates the battery status. The LEDs light up progressively and display a steady white line when charging is complete. You can see the detailed status: red (0-25 %), orange (25-50 %), orange (50-75 %), white (75-99 %), steady white (100 %).

Use during charging: Once the first LED (LED 1) turns white, the device can perform a full blending cycle even while plugged in. Charging temporarily pauses while the motor is running, then resumes after stopping.

Question 3

How to effectively clean the NUTRIBULLET NB907MACL blender?

Accepted Answer

To effectively clean your NUTRIBULLET NB907MACL blender, follow these simple steps:

1. Disassemble the blender

Always unplug the device before starting the cleaning process. Remove the cup from the base and gently unscrew the blade from the cup.

2. Rinse the parts

Immediately rinse the cup and blade under warm water to remove any ingredient residues.

3. Wash the removable parts

Wash the cup and blade with soapy hot water.
Use a soft sponge or a non-abrasive cloth to avoid scratching the surfaces.

4. Clean the base

Wipe the motor base with a damp cloth. Be careful not to let water enter the electrical part to avoid any damage.

5. Drying

Allow all parts to air dry completely before reassembling the blender.

6. Additional tips

Avoid putting the cup and blade in the dishwasher, as this may damage the components.
Clean your blender after each use to prevent residue buildup.

User manual NUTRIBULLET Blender : user manuals and guides in PDF

Models NUTRIBULLET Blender most viewed

Other categories NUTRIBULLET

Recent questions about Blender NUTRIBULLET