How to replace the cleaning rollers of the EUREKA RapidWash NEW630 broom?

Q: How to replace the cleaning rollers of the EUREKA RapidWash NEW630 broom?

To replace the cleaning rollers of your EUREKA RapidWash NEW630 broom, follow these simple steps. First, ensure that the device is turned off and unplugged. Start by pressing the latch located on the side of the roller brush cover to remove it. Once the cover is removed, you will access two roller brushes: one small and one large. Remove the old rollers by turning them in the direction indicated on the diagram in the manual until they release from the motor's driven shaft. Installing the new rollers : Begin by installing the small roller brush by aligning it with the driven shaft, then insert it by turning it in the appropriate direction. You will hear a distinct click when the roller clicks into place correctly. Repeat this process with the large roller brush, ensuring it is also securely locked. After installing both rollers, align the roller brush cover with the motor shaft and click it into place by aligning the latches. A click confirms that the cover is securely attached. The rollers should be cleaned and dried regularly after each use to maintain optimal broom performance. If you notice debris or hair wrapped around the roller shaft, remove the rollers and clean this part with a dry cloth before reinstalling.

Question

Accepted Answer

To replace the cleaning rollers of your EUREKA RapidWash NEW630 broom, follow these simple steps. First, ensure that the device is turned off and unplugged.

Start by pressing the latch located on the side of the roller brush cover to remove it. Once the cover is removed, you will access two roller brushes: one small and one large. Remove the old rollers by turning them in the direction indicated on the diagram in the manual until they release from the motor's driven shaft.

Installing the new rollers: Begin by installing the small roller brush by aligning it with the driven shaft, then insert it by turning it in the appropriate direction. You will hear a distinct click when the roller clicks into place correctly. Repeat this process with the large roller brush, ensuring it is also securely locked.

After installing both rollers, align the roller brush cover with the motor shaft and click it into place by aligning the latches. A click confirms that the cover is securely attached.

The rollers should be cleaned and dried regularly after each use to maintain optimal broom performance. If you notice debris or hair wrapped around the roller shaft, remove the rollers and clean this part with a dry cloth before reinstalling.

User manual EUREKA Broom : user manuals and guides in PDF

Models EUREKA Broom most viewed

Other categories EUREKA

Recent questions about Broom EUREKA