How to maintain the fabric filter of the RIBIMEX CeneAsp vacuum cleaner?

Question

Accepted Answer

The RIBIMEX CeneAsp 30 liters vacuum cleaner is equipped with two complementary filters: a fabric filter and a sponge filter (polyurethane) that protect the 1200W motor. Regular maintenance of the fabric filter is essential to maintain suction power and prolong the lifespan of your device.

Cleaning indicator: You will know it is time to clean the filter when the suction power significantly decreases after use. Unplug the device from the power supply before any intervention.

Cleaning procedure:

Unplug the vacuum cleaner from the power outlet
Release the two locking hooks located on each side of the top cover
Carefully remove the top cover
Gently pull out the sponge filter and the fabric filter
First, empty the dust from the canister by turning it upside down over a trash can
Shake the fabric filter vigorously outside to remove trapped dust
If fine particles stick to the filter, gently clean it with a soft brush using gentle motions

Important points: Never clean the fabric filter with water, chemicals, or solvents, as this could damage it and compromise its effectiveness. After cleaning, check that both filters have no holes, tears, or excessive wear. A damaged filter must be replaced immediately to ensure optimal suction and motor protection.

Reassembly: Once the filters are dry and clean, first reinstall the fabric filter, then the sponge filter in their place. Replace the top cover and tighten the two locking hooks until they click to ensure a good seal. This step is crucial for your vacuum cleaner to function properly.

Recommended frequency: Empty the canister after each prolonged use to avoid premature loss of power. Completely clean the fabric and sponge filters at least once a month depending on your usage frequency.

User manual RIBIMEX Vacuum Cleaner : user manuals and guides in PDF

Models RIBIMEX Vacuum Cleaner most viewed

Other categories RIBIMEX

Recent questions about Vacuum Cleaner RIBIMEX