How to pair a Tyxia 2331 remote control with actuators?

Question

Accepted Answer

The pairing of a Tyxia 2331 remote control is done in two main steps depending on the number of actuators (shutters, lighting, etc.) you wish to control.

Standard network mode (up to 16 actuators)

Prepare the actuators: Press and hold the button on each actuator for 3 seconds to put it in pairing mode. The motor will perform a brief up-down movement to confirm.
Activate the search on the remote control: Press and hold the ∧ (up) and ∨ (down) buttons simultaneously for 3 seconds. The indicator light will start flashing red.
Confirm the pairing: When the indicator light flashes slowly in red, press and hold ∧ and ∨ again for 3 seconds. The motors will perform a brief movement to confirm the pairing. The indicator light will briefly flash green with each actuator detected.

Extended network mode (17 actuators and more)

Prepare the new actuators in pairing mode (same procedure as above).
Activate the extended mode: Press the T2 button once. The orange indicator light will start flashing.
Confirm the pairing: Press and hold ∧ and ∨ for 3 seconds to confirm the addition of the new actuators.

The pairing is complete when the indicator lights stop flashing or when the motors perform a brief confirmation movement.

User manual DELTA DORE Switch : user manuals and guides in PDF

Models DELTA DORE Switch most viewed

Other categories DELTA DORE

Recent questions about Switch DELTA DORE