How to use the BESTRON AIRP200UV air purifier?

Question

Accepted Answer

To properly use your BESTRON AIRP200UV air purifier, start by removing the device from its box and plastic packaging. Ensure that no grille is obstructed. Then place the device on a stable, flat surface, keeping it away from walls and furniture to ensure good air circulation around the device. Before turning it on, remove the 3-in-1 filter, take it out of its plastic packaging, and put it back in place in the device.

Connect the purifier to a suitable electrical outlet with a voltage of 220 V. Then press the ON/OFF button to turn on the device. Use the FAN button to adjust the filtration speed among the 3 available levels: one press activates the lowest speed (indicator light turns on), a second press activates the medium speed, and a third press activates the maximum speed.

If your model is equipped with a UV-C lamp, you can activate it by pressing the UV-C LAMP button. Press this same button again to deactivate it. This lamp has a lifespan of about 20,000 hours and has a long-lasting protection before replacement.

To use the timer function, press the TIMER button: one press programs the shutdown after 2 hours, two presses after 4 hours, three presses after 8 hours. A fourth press disables the timer. You can also activate the SLEEP MODE by pressing the SLEEP RESET button for very quiet operation (the indicator blinks 10 times) which allows you to sleep peacefully while the device continues to purify the air.

The 3-in-1 filter (microfilter + activated carbon + HEPA H-13) has a lifespan of about 6 months. When the FILTER RESET indicator lights up, it is time to replace or clean the filter. To do this, turn off the device, open the cover by pulling it forward, then pull the filter forward from both sides. You can clean it with the small brush of your vacuum cleaner to remove dust and dirt. For optimal cleaning, carefully remove the membrane from the microfilter, clean it, and then put it back in place. You can also install a completely new filter (reference AIRP200FILT in a pack of 3). Replace the cover and press the SLEEP RESET button for 3 to 5 seconds to reset the filter replacement indicator.

Do not cover the device while it is operating and ensure that the power cord (180 cm) is not damaged. Regularly clean the device after use to maintain optimal purification efficiency.

User manual BESTRON Air purifier : user manuals and guides in PDF

Models BESTRON Air purifier most viewed

Other categories BESTRON

Recent questions about Air purifier BESTRON