T3075PF - Water heater Longvie - Free user manual and instructions

Product Type	Storage Water Heater
Brand	Longvie
Model	T3075PF
Capacity	30 Gallons (113 Liters)
Power Source	Electric
Voltage	240 V
Wattage	4500 W
Dimensions (H x W x D)	48 x 20 x 20 inches (122 x 51 x 51 cm)
Weight	130 lbs (59 kg)
Maximum Temperature	140°F (60°C)
First Hour Rating	70 Gallons (265 Liters)
Recovery Rate (90°F Rise)	20 Gallons per Hour (76 L/h)
Anode Rod	Sacrificial Aluminum
Temperature & Pressure Relief Valve	Included
Installation Type	Indoor, Vertical
Energy Efficiency	0.92 Uniform Energy Factor
Warranty	6 Years Tank, 1 Year Parts
Maintenance	Drain annually, replace anode rod every 3-5 years
Safety Features	Overheat protection, T&P relief valve, leak detection
Spare Parts Availability	Heating elements, thermostats, anode rods, valves
Repairability	DIY-friendly with basic tools; parts readily available
Certifications	UL, ANSI Z21.10.1

Frequently Asked Questions - T3075PF Longvie

How do I adjust the temperature on my Longvie T3075PF water heater?

Locate the thermostat access panel on the side of the tank. Remove the panel and insulation. Use a flathead screwdriver to adjust the thermostat dial to your desired temperature (recommended 120°F). Replace the insulation and panel.

How often should I drain my water heater?

It is recommended to drain and flush your water heater at least once a year to remove sediment buildup. This improves efficiency and extends the life of the unit.

What is the first hour rating of the T3075PF?

The first hour rating (FHR) for the Longvie T3075PF is approximately 70 gallons, meaning it can supply 70 gallons of hot water in the first hour of use.

Why is my water heater making popping or rumbling noises?

Popping or rumbling noises are often caused by sediment buildup on the heating elements. Draining and flushing the tank should resolve the issue.

How long does it take to heat a full tank of water?

With a 4500W element, the T3075PF can heat a full 30-gallon tank from 70°F to 120°F in about 45 minutes. Recovery may take longer if more hot water is used.

Is the T3075PF compatible with a solar water heating system?

Yes, the T3075PF can be used as a backup or supplementary heater in a solar system. It requires a solar-ready setup with appropriate piping and controls.

What safety features does the T3075PF have?

The water heater includes a temperature and pressure relief valve, overheat protection, and a leak detection system. Always ensure the T&P valve is properly installed.

How do I replace the heating element?

Turn off power and water supply. Drain the tank partially. Remove the access panel and disconnect wires. Unscrew the old element and install a new one (4500W, 240V). Reconnect wires, refill tank, and restore power.

What type of anode rod does the T3075PF use?

The T3075PF comes with a sacrificial aluminum anode rod. It should be inspected every 3 years and replaced when heavily corroded to prevent tank rust.

Can I install the T3075PF outdoors?

No, the T3075PF is designed for indoor installation in a dry location. Outdoor installation may void the warranty and pose safety risks.

USER MANUAL T3075PF Longvie

Energía

Artefacto a gas

Fabricante / Importador

:MARCA

:MODELO

:TIPO DE GAS

LONGVIE

LONGVIE

T3075PF

Natural

Termotanque

Más eficiente

Menos eficiente

Capacidad del tanque (I)

Consumo máximo (kcal/h)

Consumo medio en condiciones normalizadas (m³ /año)

El consumo real depende de las condiciones de utilización del artefacto y las condiciones de localización.

75

6400

770