EH-KA42 - Styler PANASONIC - Free user manual and instructions
Find the device manual for free EH-KA42 PANASONIC in PDF.
| Product Type | Hair Styler (Straightener / Curler) |
| Brand | Panasonic |
| Model | EH-KA42 |
| Dimensions | Approx. 28.5 cm (L) x 3.5 cm (W) x 4.0 cm (H) |
| Weight | Approx. 290 g (without cord) |
| Power Supply | AC 100-240 V, 50/60 Hz, 25 W |
| Cord Length | 1.8 m swivel cord |
| Plate Material | Ceramic coated floating plates |
| Temperature Range | 130°C – 200°C (adjustable with dial) |
| Heat-Up Time | Approx. 30 seconds to maximum temperature |
| Ionic Function | Yes, nanoe™ technology for moisture balance |
| Auto Shut-Off | Yes, activates after 60 minutes of non-use |
| Safety Lock | Slide lock to close plates for storage |
| Overheat Protection | Yes, built-in thermostat |
| Heat-Resistant Tip | Yes, for safe styling near scalp |
| Maintenance | Wipe plates with a dry or slightly damp cloth after use; do not use chemicals |
| Cleaning Frequency | After each use |
| Spare Parts Available | None (non-replaceable plates); replace unit if damaged |
| Repairability | Not user-serviceable; contact Panasonic service center |
| Country of Origin | Japan |
| Certifications | CE, UL, etc. |
Frequently Asked Questions - EH-KA42 PANASONIC
User questions about EH-KA42 PANASONIC
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
Download the instructions for your Styler in PDF format for free! Find your manual EH-KA42 - PANASONIC and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. EH-KA42 by PANASONIC.
USER MANUAL EH-KA42 PANASONIC
natural_image
Line drawing of a hair styling brush with a textured handle and comb (no text or symbols)Panasonic
Operating Instructions
(Household) Hair Styler
Model No. EH-KA42/EH-KA22
English 2
Before operating this hair styler, please read these instructions completely and save this manual for future use.
Thank you for choosing a Panasonic hair stylist. Please read all instructions before use.
Parts identification

A Main Body
B Attachment Release
Button
© Air Outlet
Power Switch/Speed Selector
2: Dry mode
1: Set mode
0: Off
E Cord
F Hang Ring
© Air Inlet
| Attachments | Blow Brush | Slim Roller Brush | Roller Brush | Nozzle |
| [2WWA] | ![]() | ![]() | ![]() | |
| EH-KA42 | √ | √ | √ | √ |
| EH-KA22 — | — | √ | √ |
2

Important
Please read the safety instructions before using this hair styler. The safety instructions explained here are to help you use this hair styler safely and correctly, and also to prevent you from injuring yourself or others.
WARNING: Not following the instructions below may cause fire, burns, explosion, short circuiting or electric shock.
Electrical Conditions

WARNING: This symbol on the hair styler means "Do not use this hair styler near water". Do not use this hair styler near bathtubs, showers, basins or other vessels containing water.
- Always switch off the hair styler ("0" position) after use and before unplugging it from the power socket. Unplug it from the power socket when not in use. Always grasp the plug while unplugging. Failure to do so may lead to fire and/or an accident.
- Before connecting the hair styler, check that the voltage of the hair styler corresponds to the local voltage.

- Do not cut, damage or modify the cord. Do not pull, twist or bend the cord with unnecessary force. Do not place heavy objects on the cord or allow it to get pinched in between objects. Do not wrap the cord around the hair styler as it may cause fire and/or electric shock. If the cord is damaged or becomes hot, stop using it immediately.

- When the hair styler is used in a bathroom, unplug it after use since the proximity of water presents a hazard even when the hair styler is switched off.
- For additional protection, the installation of a residual current device (RCD) having a rated residual operating current not exceeding 30mA is advisable in the electrical circuit supplying the bathroom. Ask your installer for advice.
●Using the Hair Styler
- Stop using it immediately if the hair styler does not produce air constantly and the cord or plug is damaged or becomes hot, or the plug fits loosely in the outlet.
- Never insert foreign objects into either the air inlet or outlet.
- Do not use the hair styler near inflammable material such as benzine, paint thinner, sprays, etc.
- Do not use the hair styler while your hands are wet.
- Do not use or place the hair styler in an area with high humidity. Do not submerge the hair styler in water.
- This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.
● Repairing the Hair Styler
- Only qualified personnel should repair or disassemble the hair styler.
- If the cord is damaged, it must be replaced by the manufacturer, its service agent, or similarly qualified persons in order to avoid a hazard.
- When the hair styler is blowing hot air, occasionally it may turn off or sparks may be seen. In such cases, dust may have accumulated at the air inlet and/or the air outlet. Also, the air inlet may be being blocked by your hair, hands, etc. (This phenomenon is the result of the hair styler's thermal switch. It is a protective device. The sparks do not pose a danger in and/or themselves.) Slide the main switch to the "0" position and remove the dust if dust has accumulated, or if air inlet was blocked by your hair or hand, cool down the hair styler for approximately 5 minutes before using it again.
CAUTION
- Do not put your hands on the air outlets or use them if they are damaged. You may get burned.
- Only use the hair styler for drying and styling human hair. Do not use it for children.
- Do not use the hair styler if it is damaged.
- Do not touch the attachments as they become hot during and after use.
• Make sure hair does not get sucked into the air inlets. - Do not use thinner, benzine or any other solvent to clean the hair styler.
- This hair styler is equipped with an automatic overheating protective device. If the hair styler overheats, it will be turned off. Switch off the hair styler and unplug it from the power socket. Allow it to cool down for approximately 5 minutes before using it again. Check that no dust, hair etc. is in the air inlets and outlets before switching it on again.
How to Use the Hair Styler
Fixing the Attachment
- Align the attachment with the hair styler as shown. Ensure that the groove of the attachment and the hook of the body are aligned with each other. Insert the hair styler in the attachment until it clicks.

- Press the attachment release button and pull out the attachment to remove it.
Do the following to prevent tangled hair while using the Roller Brush.
• Take only a small amount of hair when rolling and roll the hair at a right angle (90°) as shown.
- Do not do more than one and a half rolls at a time.
- Keep the roller as far away as possible from your head and unroll the roller at the same angle as your hair.
- Do not roll or unroll your hair at an incline angle.

Introduction of the Attachments
Blow Brush
Use for a natural hair style.
EH-KA42


Take a small amount of hair and brush from the inside pulling it down gently. Use your free hand to support the motion.
Slim Roller Brush
Use for volume and waves or curls.
EH-KA42

1

2

3

Take a small amount of hair and curl from the end of the hair.
Roller Brush
Use for natural straight hair or big curls.
EH-KA42 EH-KA22

1

2

...>
3

Blow dry the hair from the roots to the end and then curl the end of the hair.
Nozzle
Use for overall drying.
EH-KA42 EH-KA22


Repair and maintenance of the Hair Styler
Clean the air inlets and outlets to prevent blockages that may cause overheating.
The hair styler should be cleaned at least once a month.
To clean the hair styler, turn the power switch to [0] and unplug the hair styler from the power outlet.
- Clean the air outlet using a brush as shown.
- To clean the air inlet, remove the filter by turning it counterclockwise direction and pull the filter towards your direction.
Remove dust or hair by using a brush or a vacuum cleaner. To re-attach the filter, ensure that the groove of the connector and the projection of the filter are in line. Twist to fit.


Specifications
Model No.: EH-KA42/EH-KA22
| Voltage | 220 V~50-60 Hz | 230 V~50-60 Hz | 240 V~50-60 Hz | 240 V~50 Hz* |
| Power consumption | 550 W 6 | 00 W 650 W | 650 W |
*Only available in Kuwait and Qatar.
This product is intended for household use only.

MEMO





MEMO
natural_image
Technical line drawing of a pipe joint with two cylindrical components and mounting holes (no text or symbols)natural_image
Line drawing of a hairbrush with a textured brush and comb (no text or symbols)Panasonic
دُقْتَرِجِه راهنما
تعليمات التشفيل
سشوار حالت دهنده مو
مصف الشعر


