929-071 - Paper shredder Marquant - Free user manual and instructions

Product Type	Paper Shredder
Brand	Marquant
Model	929-071
Shredding Type	Strip Cut
Strip Width	6.8 mm
Shredding Capacity	5 sheets (A4, 80 g/m²)
Infeed Width	220 mm
Dimensions	281 x 150 x 310 mm
Rated Voltage	220–240 V AC, 50 Hz
Rated Current	0.8 A
Power Cord Length	Not specified (standard approx. 1.5 m)
Duty Cycle	2 minutes on / 45 minutes off
Motor Overheat Protection	Automatic shut-off, requires 45 min cool-down
Reverse Function	Yes (REV position)
Auto Start/Stop	Yes (ON/AUTO mode)
Collection Tray Capacity	Not specified (approx. 10-15 litres estimated)
Safety Features	Overheat protection, reverse function for jams
Material Safety	Avoid staples, paper clips, plastic, wet paper
Cleaning	Unplug, wipe casing with mild detergent, no abrasives
Intended Use	Small and medium-sized home offices
WEEE Recycling	Do not dispose with household waste; recycle at designated station
Manufacturer	Jula AB, Box 363, 532 24 SKARA

Frequently Asked Questions - 929-071 Marquant

What is the shredding capacity of the Marquant 929-071?

The shredder can handle up to 5 sheets of A4 paper (80 g/m²) at a time. Do not exceed this to avoid jamming or damage.

Can I shred staples or paper clips?

It is recommended to avoid shredding staples, paper clips, laminated sheets, photos, plastic pockets, or textiles. Staples can damage the shredding system.

What should I do if the paper gets jammed?

Switch off the machine, then move the mode selector to the REV position to feed out the jammed paper. You may need to gently pull the stuck material. Avoid switching between ON/AUTO and REV too quickly.

Why does the shredder stop suddenly?

The motor may have overheated due to prolonged use. The shredder has an overheat protection that shuts off the motor. Allow it to cool for at least 45 minutes before restarting.

How do I clean the shredder?

Unplug the power cord first. Clean the casing with a cloth moistened with mild detergent. Do not use strong or abrasive cleaners, and avoid getting moisture inside the machine.

Can children use this shredder?

This appliance can be used by children aged 8 years and above if supervised and instructed on safe use. Children should not play with it, and cleaning/maintenance should not be done by children under 8.

What is the maximum number of sheets per session?

Do not run more than 50 sheets in one session to prevent overheating. For best results, limit each shredding session to 2 minutes, then allow a 45-minute cool-down.

Can I shred wet or damp paper?

No, wet or damp paper can wind around the shredding unit and damage the machine. Only shred dry paper.

How do I empty the collection tray?

Switch off the machine and unplug the power cord. Lift off the top part of the shredder and empty the tray. Ensure the tray is not overfilled to avoid paper jams.

What should I check if the shredder doesn't work?

Check that the power cord is plugged in, the mode selector is in ON/AUTO, there is no paper jam, the motor has not overheated, and the paper is stiff enough to activate the mechanism. Contact dealer if issues persist.

USER MANUAL 929-071 Marquant

Black rectangular electronic device with control panel and indicator lights (no visible text or symbols)

Värna om miljön!

Care for the environment!

Must not be discarded with household waste! This product contains electrical or electronic components that should be recycled. Leave the product for recycling at the designated station e.g. the local authority's recycling station.

SE - Bruksanvisning i original

EN - Operating instructions (Translation of the original instructions)

Jula reserves the right to make changes. In the event of problems, please contact our service department. www.jula.com

Tillverkare/ Produsent / Produenci/ Manufacturer

Jula AB, Box 363, 532 24 SKARA

Importör/ Importör/ Importer/ Importer

Read the Operating Instructions carefully before use.

• Read these instructions carefully before use, and save them for future reference.
  • Follow all the safety instructions and pay attention to all the warnings on the machine.
• This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children unless they are older than 8 and supervised.
• Keep the appliance and its cord out of reach of children less than 8 years.
• Unplug the power cord before cleaning. Clean the casing with a cloth moistened with a mild detergent. Do not use strong or abrasive detergents or solvents.
• Connect the machine to an easily accessible mains outlet near the machine.
• Do not use the machine near water.
• Do not place the machine near or above heat sources.
• Do not expose the machine to water or any other liquid.

• Unplug the power cord and contact qualified service personnel if any of the following occurs.

• If the power cord or plug is damaged.

• If the machine has been exposed to liquid.
• If the machine is not working properly.

- Never place any objects on the power cord. Place the power cord so that it cannot be stood on or clenched.

• Check that the mains voltage corresponds to the rated voltage on the type plate. Consult an authorised electrician if in doubt.
• Never try to open the machine casing – risk of electric shock.
• Keep children and pets at a safe distance from the machine when it is in use.
• Connect the machine to an easily accessible mains outlet near the machine.

IMPORTANT:

• Loose clothing, long hair, and jewellery etc. can be pulled into the infeed opening – risk of personal injury.
• Do not run paper clips, laminated sheets, photos, plastic pockets or textiles through the machine. Avoid if possible running staples through the machine – they can damage the shredding system.
• Do not run wet or damp paper through the machine, it can wind round the shredding unit and damage the machine.
• For best results, do not run more than 5 sheets of paper through the machine at once. Overloading can damage the machine.

• Do not run more than 50 sheets through the machine in one session. Prolonged loading can cause overheating, which will switch off the motor. Switch off the machine immediately if paper gets jammed, otherwise the machine can overheat and the motor switch off. If the motor switches off as a result of overheating, switch off the machine, unplug the power cord and allow the machine to cool for at least 45 minutes before starting it again.
  • Leave the machine switched off for at least 45 minutes every time it is used for 2 minutes.

• Do not use the reversing function REV unnecessarily, it can cause particles to collect round the infeed opening and reduce the capacity of the machine.

• Switch off the machine and pull out the plug before cleaning and/or servicing, and before moving the machine.

TECHNICAL DATA

Shredding	Strips
Strip width (mm)	6,8
Shredding capacity (A4, 80 g/m2)	5 sheets
Infeed width (mm)	220
Dimensions (mm)	281 x 150 x 310
Rated voltage/frequency	220–240 VAC, 50 Hz
Rated current	0.8 A

USE

The machine is intended for destroying small quantities of documents in small and medium-sized home offices.

1. Plug in the power cord. Set the power switch/mode selector to ON/AUTO. The machine goes into standby mode.
2. Insert the document straight into the infeed opening. The machine starts automatically.
3. Switch off the machine and unplug the power cord before emptying the collection tray. Lift off the top and empty the collection tray.
4. If material fastens, move the mode selector to the REV position to feed out the jammed material. It may be necessary to carefully pull the stuck material to remove it.

TROUBLESHOOTING

Check the following points if the machine does not work properly.

• That the power cord is plugged in.
• That the power switch/mode selector is in the ON position.
• That paper has not fastened in the machine.
• That the motor has not switched off as a result of overheating.
• That the paper is sufficiently stiff to activate the mechanism.
• Contact the dealer if the machine still does not work properly.

- Paper blockage

- Check that the collection tray is not full. Empty the collection tray, if necessary.

- Remove the paper that has been fed in. Divide the paper into smaller bundles (no more than 5 sheets).

- If it is difficult to remove the paper, move the mode selector slowly between the ON/AUTO and REV positions. Allow the mode selector to rest in the ON/AUTO position for a moment each time. Do not switch between the ON/AUTO and REV positions too quickly, this can damage the machine.