HDC 7 FME - Tumble drier HOOVER - Free user manual and instructions
Find the device manual for free HDC 7 FME HOOVER in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | Freestanding Condenser Tumble Dryer |
| Model | HDC 7 FME |
| Brand | Hoover |
| Capacity | 7 kg |
| Energy Class | B |
| Annual Energy Consumption | 504 kWh |
| Drying Programs | 14 (including Cotton, Synthetics, Delicates, Timed Drying, Iron Dry, Cupboard Dry, etc.) |
| Drum Material | Stainless Steel |
| Drum Volume | 118 L |
| Noise Level | 67 dB(A) |
| Dimensions (H x W x D) | 85 x 60 x 54 cm |
| Weight | 34 kg |
| Power Supply | 220-240 V ~ 50 Hz |
| Current | 10 A |
| Total Power | 2200 W |
| Condenser Type | Self-Cleaning Condenser (Auto-Clean) |
| Water Tank Capacity | 4.5 L |
| Filter Type | Lint filter (easy access) |
| Display | LED Digital Display with Delay Start |
| Control Type | Electronic with Rotary Knob and Touch Buttons |
| Reversing Drum | Yes |
| Anti-Crease Cycle | Yes (120 min) |
| Delay Start | Up to 24 h |
| Child Lock | Yes |
| Energy Efficiency Index | 85 |
Frequently Asked Questions - HDC 7 FME HOOVER
How do I clean the condenser on the Hoover HDC 7 FME?
The Hoover HDC 7 FME features a self-cleaning condenser system. However, you should still check the condenser unit periodically. Remove the lower front panel, release the condenser cover, and pull out the condenser block. Rinse it with water from the back side to remove lint buildup. Allow it to dry before reinserting. Clean it every 3-4 months or when the 'Clean Condenser' indicator appears.
Why is the drying cycle taking longer than usual?
Longer drying cycles can be caused by a clogged lint filter, a full water tank, or a dirty condenser. Also, overloading the dryer or selecting a program not suited for the fabric type can extend drying time. Ensure the filter is clean, empty the water tank after each cycle, and check the condenser. Additionally, the room temperature should be between 5°C and 30°C for optimal performance.
What does the 'Full tank' indicator mean?
The 'Full tank' indicator means the water collection tank needs to be emptied. The dryer automatically collects condensed water in a tank located at the bottom. Pull out the tank, empty it into a sink, and reinsert it securely. The indicator will turn off. The tank capacity is 4.5 liters.
How do I install the dryer for the first time?
Remove all packaging materials and transport bolts. Place the dryer on a level, firm surface. Leave at least 5 cm clearance on sides and rear for ventilation. Connect the power cord to a grounded outlet. If using the drain hose, attach it to the back of the dryer and route it to a floor drain. For the water tank, ensure it is correctly inserted. Then plug in and run a short test cycle.
Can I dry wool or silk items in this dryer?
Yes, but only using the Delicates or Wool program specifically designed for sensitive fabrics. Do not overload the drum; dry small loads. Use a low heat setting. Place wool items in a mesh laundry bag for extra protection. Check the care label on your garments first. Some wool items may shrink or felt, so it's recommended to air dry them instead.
How do I reset the dryer after a power cut?
After a power cut, the dryer may stop. To reset, simply press the Start/Pause button. If the program has been interrupted, the dryer may restart from where it stopped. If not, turn the program selector to the 'Off' position, wait a few seconds, then select your desired program and press Start. No special reset procedure is needed.
What are the common error codes on the Hoover HDC 7 FME?
Common error codes include: E1 (Full water tank or drainage issue), E2 (Condenser blocked), E3 (Lint filter not cleaned), E4 (Drum overload), E5 (Motor or power supply problem). Refer to the user manual for detailed troubleshooting. Most errors can be resolved by cleaning filters, emptying the tank, or reducing load size.
How to clean the lint filter?
Open the dryer door and pull out the lint filter located at the bottom of the door opening. Gently remove the lint layer by hand or with a soft brush. Rinse the filter under running water every few cycles to remove fine dust. Dry it thoroughly before reinserting. A clean filter ensures efficient drying and prevents fire hazards.
Is it normal to have water in the tank?
Yes, it is completely normal. The condenser dryer extracts moisture from the laundry and collects it as water in the tank. You should empty the tank after every drying cycle or when the 'Full tank' indicator lights up. If you prefer continuous drainage, you can attach the included drain hose to the back of the dryer.
How do I use the delay start function?
After selecting your drying program, press the Delay Start button repeatedly to set the desired delay (from 1 to 24 hours). The time will be shown on the display. Then press Start/Pause to begin the countdown. The dryer will start automatically when the delay ends. To cancel, turn the program selector to 'Off'.
User questions about HDC 7 FME HOOVER
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Tumble drier in PDF format for free! Find your manual HDC 7 FME - HOOVER and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. HDC 7 FME by HOOVER.