NM-1FE1CE1U= - Router CISCO - Free user manual and instructions
Find the device manual for free NM-1FE1CE1U= CISCO in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | Router Network Module |
| Brand | Cisco |
| Model | NM-1FE1CE1U= |
| Interfaces | 1 x Fast Ethernet (10/100), 1 x Channelized E1 (CE1U) |
| Compatibility | Cisco 2600, 3600, 3700 series routers |
| Form Factor | NMM (Network Module) |
| Dimensions | 1.8 x 7.1 x 7.2 in (4.6 x 18.0 x 18.3 cm) |
| Weight | 1.5 lb (0.7 kg) |
| Power Consumption | 12 W (typical) |
| Operating Temperature | 32°F to 104°F (0°C to 40°C) |
| Storage Temperature | -4°F to 149°F (-20°C to 65°C) |
| Operating Humidity | 10% to 90% non-condensing |
| LED Indicators | Link/Act (Ethernet), Carrier (E1) |
| Network Management | SNMP, Telnet, Console |
| Safety Compliance | UL, CE, FCC Class A |
| Warranty | 1 year limited hardware warranty |
Frequently Asked Questions - NM-1FE1CE1U= CISCO
What is the Cisco NM-1FE1CE1U=?
The Cisco NM-1FE1CE1U= is a network module that provides one Fast Ethernet port and one channelized E1 (CE1U) port for Cisco routers, enabling WAN connectivity.
Which routers are compatible with this module?
This module is compatible with Cisco 2600, 3600, and 3700 series routers that have a network module slot.
How do I install the NM-1FE1CE1U=?
Power off the router, insert the module into an available network module slot, secure with screws, and power on. The router will auto-detect the module.
What is the purpose of the CE1U interface?
The CE1U interface provides a channelized E1 connection, allowing multiple logical channels (like DS0s) over a single E1 line, commonly used for TDM or ISDN PRI.
Can I use this module for voice traffic?
Yes, the CE1U interface can carry voice channels when configured appropriately with Cisco IOS voice features.
How do I configure the Fast Ethernet port?
Use Cisco IOS commands like interface FastEthernet0/0 and assign an IP address, or configure VLAN settings as needed.
What cables are required for the CE1U port?
The CE1U port uses a RJ-48C connector with a 120-ohm balanced cable for E1 connections.
Does the module support hot swapping?
No, you must power off the router before installing or removing the module to avoid damage.
What LED indicators are present on the module?
There is a Link/Act LED for the Ethernet port and a Carrier LED for the E1 port to indicate connection status.
Where can I find the latest driver or firmware?
Firmware is included in Cisco IOS releases. Download the appropriate IOS version from Cisco's support site for your router.
User questions about NM-1FE1CE1U= CISCO
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Router in PDF format for free! Find your manual NM-1FE1CE1U= - CISCO and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. NM-1FE1CE1U= by CISCO.