HI-FAN-DRUM24-1P - Household Fan TORNADO - Free user manual and instructions

Product Type	24-inch Metal Portable Tilt Blower Drum Fan
Brand	Tornado
Model	HI-FAN-DRUM24-1P
Fan Diameter	24 inches (61 cm)
Power Supply	120V AC, 60Hz
Power Consumption	600W (max, based on fuse rating)
Weight	Approximately 35 lbs (16 kg)
Speed Settings	3 speeds (off, low, high)
Tilt Adjustment	Yes, with included knob wrench
Material	Metal construction with powder-coated finish
Plug Type	3-prong grounded plug (NEMA 5-15P)
Cord Length	6 ft (1.8 m) (estimated)
Safety Features	Grounded plug, overload protection (fuse), tip-over stability, blade guard
Assembly Required	Yes, castors and cradle base must be installed before use
Intended Use	Industrial or commercial applications, dry indoor environments
Maintenance	Clean grille with damp cloth; vacuum periodically; sealed motor requires no lubrication
Warranty	1 year limited warranty for the whole fan
California Proposition 65	Warning: Contains chemicals known to cause cancer and reproductive harm

Frequently Asked Questions - HI-FAN-DRUM24-1P TORNADO

What is the voltage and frequency requirement for the Tornado HI-FAN-DRUM24-1P fan?

The fan operates on 120V AC, 60Hz electrical supply. Always plug directly into a properly grounded wall outlet.

How do I adjust the tilt angle of the fan?

Use the supplied knob wrench to loosen the adjustment screw, tilt the fan to the desired angle, then retighten the screw. Save the wrench for future adjustments.

Can I use an extension cord with this fan?

Avoid extension cords due to fire risk. If necessary, use a minimum 14 AWG cord rated at least 1875 watts. Never run the cord under carpets or in traffic areas.

How do I replace the fuse in the plug?

First unplug the fan. Open the fuse cover on the plug by sliding it toward the blades. Carefully remove the blown fuse and replace it with an identical 2.5 or 5.0 Amp, 125 Volt fuse (3.6mm x 10mm). Close the cover securely.

Is the fan suitable for outdoor use?

No, this fan is not for outdoor use. It should only be used in dry indoor environments. Do not place in bathrooms, near water, or in damp areas.

What cleaning and maintenance is required?

Always unplug before cleaning. Clean the grille with a damp cloth and vacuum periodically to prevent dust buildup. Do not immerse in water. The motor is sealed and requires no lubrication.

Does the fan have a warranty?

Yes, the fan comes with a 1-year limited warranty covering defects in material and workmanship. Proof of purchase is required for claims.

Can I use a solid-state speed controller with this fan?

No, do not use any solid-state speed control device as it may cause fire or electric shock. Use only the built-in mechanical switch.

What is the California Proposition 65 warning?

This product can expose you to chemicals including lead and phthalates, known to cause cancer and birth defects. For more info, visit www.P65Warnings.ca.gov.

What should I do if the fan stops working or blows a fuse repeatedly?

A blown fuse indicates overload or short circuit. Replace the fuse once. If it blows again, unplug the fan and do not use it. Contact the place of purchase or an authorized service facility for inspection.

USER MANUAL HI-FAN-DRUM24-1P TORNADO

24" METAL PORTABLE TILT BLOWER DRUM FAN

Model: HI-FAN-DRUM24-1 P

Front view of a large industrial fan with visible blades and mounting base (no text or symbols)

PLEASE READ AND SAVE THIS INSTRUCTION.

Attention: Pictures in the IM are for reference only.

Intended Use:

This product is intended for industrial or other commercial applications. Use only with electrical wiring that is in good working order and that meets applicable codes and ordinances. If you have any questions whether your wiring is adequate, consult a qualified electrician.

While using your fan, you should follow the IMPORTANT INSTRUCTIONS listed below. As part of those instructions, we have used the word "WARNING" to indicate the level of hazard: WARNING indicates a hazard which, if not avoided, could result in injury or death.

IMPORTANT INSTRUCTIONS

As with all electrical appliances, basic safety precautions should always be followed to reduce the risk of electric shock, fire, or injury to persons, including the following precautions:

• Read all the instructions before using this fan.
• Use this fan only as described in this manual. Any other use not recommended by the manufacturer may cause electrical shock, fire or injury to persons.
• Do not operate the fan with a damaged power cord or after the fan malfunctions or has been dropped in any manner.
• Use of extreme caution is necessary when any fan is used by or near children, disabled persons or pets and whenever the fan is left operating unattended.
• Do not place the fan on a small, unlevel, uneven or any surface which might allow fan to tip or fall.

- For proper operation, fan should be placed on a smooth, non-combustible, level surface.

- Always unplug fan when not in use, when moving from place to place, when assembling or disassembling parts, and before cleaning.

- The use of attachments, not recommended or sold by the manufacturer, may cause hazards.

- Do not use outdoors.

- Do not use fan in window. Rain may cause electrical hazard (for non-window models).

- Do not operate the fan with blade guards or any safety device removed.

- Avoid the use of extension cords due to risk of fire. If an extension cord must be used, the cord must be minimum 14 AWG and rated not less than 1875 watts.

- Do not run power cord under carpeting. Do not cover cord with throw rugs, runners or the like. Arrange cord away from traffic area where it will not be tripped over.

- Do not insert or allow any object to enter any openings on the fan. Doing so may cause electric shock and/or fire hazard. Avoid contact with moving parts.

- This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.

- Children should be supervised to ensure they do not play with the appliance.

READ & SAVE THESE INSTRUCTIONS

WARNING: Shock Hazard

Use your fan only in dry environments. This fan is not intended for use in a bathroom, laundry area, or similar locations, or near sinks, washing machines, swimming pools or other sources of water. Never locate fan where it may fall into a bathtub or other water receptacle. Do not use in damp environments such as flooded basements.

WARNING: Hot Surfaces

Do not touch fan motor when in use. This motor is hot when in use, to avoid burns, do not let bare skin touch hot surfaces.

WARNING: Fire Hazard

Fans have arcing or sparking parts inside. Do not use near combustible materials or flammable gases or sources of heat. DO NOT USE in areas where gasoline, paint or flammable materials are used or stored. To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock, fire, or damage the fan.

WARNING: Electrical Shock Hazard

Do not use with damaged cord or plug. Use with adequate electrical system that is up to code.

⚠️ CAUTION: to Prevent ElectricShock, this product has a three prong grounded plug that must be inserted into a matching properly grounded outlet to reduce the risk of electrical shock. Do not attempt to defeat this safety feature.

WARNING: to Reduce the Risk of Fire or Electric Shock, do not use this product with any solid-state speed control device.

Usage:

Fan Operation: Always operate the fan in the upright position following all instructions and recommendations listed in this manual.

Fan Location: Place the fan in the area of the room that will provide proper fan cooling.

Fan Connection: Plug fan directly into 120 volt A.C., 60 Hz wall outlet. Be sure plug fits tightly in outlet. A loose connection may cause overheating and damage to the plug or fan. NOTE: To prevent overloading a circuit, do not plug the fan into a circuit that is servicing other electrical needs.

Turning Fan On: Place fan on stable level surface. Plug fan into properly grounded outlet. To start the fan, turn the switch from the OFF position to the desired fan speed.

Turning Fan Off: To turn the fan off, turn the switch from the current fan speed setting to the off position. Remove plug from outlet.

Adjusting Fan Tilt: To adjust the tilt angle, use supplied knob wrench to loosen the adjustment screw. After adjustment, retighten the adjustment screw. Save knob wrench for future use.

Fan Assembly

Illustration of a hand holding a screwdriver next to a circular component, with no text or symbols present.

Line drawing of a mechanical tool with two wheels and a handle (no text or symbols)

Illustration of a hand using a tool to adjust a mechanical component, with no visible text or symbols

Line drawing of a mechanical bracket or support structure (no text or symbols)

We are happy to help, contact us : [e-mail]

⚠ WARNING: There is one small hole on each side of the two cradle bases. The two small holes should be kept inner side and at the same directions.

⚠ WARNING: Castors must be installed before use.

For Detailed Step By Step Assembling video please go to: https://www.tornado-fans.com/drumfan/

Care and Maintenance

Cleaning: CAUTION-Before cleaning the fan be sure to disconnect power cord from the plug. Clean the grille surface with a clean damp cloth. Do not use harsh chemical or abrasive cleaners. DO NOT IMMERSE THE FAN OR ANY WIRES IN WATER. Replace front grille before fan use. Allow fan to dry completely before use. Periodic grille cleaning with a vacuum will prevent dust build up. The motor is sealed and does not require any interior maintenance, cleaning or lubrication.

Maintenance: The Internal motor bearings are permanently lubricated at the factory and do not require any additional lubrication.

Repair: DO NOT OPERATE THE FAN WITHOUT THE GRILLE IN PLACE. DO NOT USE THE FAN IF IT HAS MALFUNCTIONED OR BECOME DAMAGED IN ANY WAY.

Storage: Keep original carton for storage of the fan. Coil and tie the power cord to avoid damage during storage.

This product employs overload protection (fuse). A blown fuse indicates an overload or short-circuit situation. If the fuse blows, unplug the product from the outlet. Replace the fuse as per the user servicing instructions (follow product marking for proper fuse rating) and check the product. If the replacement fuse blows, a short-circuit may be present and the product should be discarded or returned to an authorized service facility for examination and/or repair.

Fuse Replacement:

1. Grasp plug and remove from the receptacle or other outlet device. Do not unplug by pulling on cord.
2. Open fuse cover by sliding open fuse access cover on top of attachment plug towards blades. See Fig. 2.
3. Remove fuse carefully. Use a small tool to pry the end of the fuse from holder cavity. Be careful not to break glass window.
4. Replace fuse. WARNING: Risk of fire. Replace fuse only with identical 2.5 or 5.0 Amp, 125 Volt fuse (3.6mm x 10mm). Be sure fuse is properly seated within its cavity.
5. Close fuse cover by sliding it back to its original closed position.

Fig 1 Fig 2
Fig 3

LIMITED ONE-YEAR WARRANTY

Hexago LLC warrants this product to be free of defects in material and workmanship for the applications specified in the Owner's Manual for a period of 12 months for the whole fan from date of purchase. This warranty only applies to the original purchaser of this product.

This warranty excludes damage, accidental or otherwise, to the unit not caused by a defect in material or workmanship.

The warranty also excludes damage caused by misuse, tampering, modification, missassembly, repairs or alternations, or failure to adequately maintain and care for the unit. Operating this product under any conditions others than those recommended or at voltages other than indicated will also void this warranty. For warranty issues, contact the place of purchase for repair/ replacement opportunities. The original dated receipt or proof of purchase must accompany all returns.

All warranties, expressed or implied, are limited for 12 months for the whole fan from the date of purchase. Please contact us at www.tornadofans.com if you have any questions. Tornado is a registered trademark of Hexago LLC.

Some states do not allow for the limitation or exclusion of incidental or consequential damages, or do not allow limitation on implied warranties. The above limitations and exclusions may not apply to you. This warranty gives you specific legal rights, and may also include other rights that vary state by state.

Customer service email: [e-mail]

Website: www.tornadofans.com

202112

FOR CALIFORNIA CONSUMERS ⚠ WARNING: This product can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.