RM410 - Thermometer Grado - Free user manual and instructions

Product Type	Infrared Thermometer
Model	RM410
Brand	Grado
Measurement Range	-50°C to 380°C (-58°F to 716°F)
Accuracy	±1.5°C or ±1.5% of reading
Resolution	0.1°C / 0.1°F
Response Time	< 500 ms
Display Type	Backlit LCD
Distance to Spot Ratio	12:1
Emissivity	0.95 fixed
Auto Power Off	Yes, after 15 seconds
Power Source	1 x 9V battery (not included)
Battery Life	Approximately 12 hours continuous use
Dimensions	152 x 101 x 38 mm (6.0 x 4.0 x 1.5 in)
Weight	165 g (5.8 oz) without battery
Material	ABS plastic
Color	Black with yellow accents
Operating Temperature	0°C to 50°C (32°F to 122°F)
Storage Temperature	-20°C to 60°C (-4°F to 140°F)
Safety Certifications	CE, RoHS
Included Accessories	User manual, battery (for demo purposes only)

Frequently Asked Questions - RM410 Grado

How do I change the battery in my Grado RM410 thermometer?

To change the battery, slide the battery cover off the back of the thermometer. Remove the old 9V battery and replace it with a new one, ensuring correct polarity. Slide the cover back on until it clicks.

What is the measurement range of the RM410?

The Grado RM410 has a measurement range of -50°C to 380°C (-58°F to 716°F). It can measure both low and high temperatures accurately.

How accurate is the Grado RM410 thermometer?

The accuracy is ±1.5°C or ±1.5% of the reading, whichever is greater. For most applications, this provides reliable results.

Can I use the RM410 to measure body temperature?

No, the RM410 is designed for industrial and surface temperature measurements, not for human body temperature. It is not a medical device.

How do I clean the lens of the infrared thermometer?

Use a soft, dry cloth to gently wipe the lens. Avoid using abrasive cleaners or solvents. If necessary, a mild lens cleaning solution can be used with a microfiber cloth.

Why does the thermometer display 'Err' or '---'?

An 'Err' or '---' message usually indicates that the measurement is out of range, the target is too reflective, or there is a malfunction. Ensure the target is within the specified temperature range and that the lens is clean.

What does the distance to spot ratio mean?

The distance to spot ratio of 12:1 means that for every 12 units of distance from the target, the measured spot diameter is 1 unit. For example, at 12 inches away, the spot diameter is 1 inch.

How do I switch between Celsius and Fahrenheit?

Press and hold the 'MODE' button for about 3 seconds to toggle between °C and °F. The current unit will be displayed on the screen.

Does the RM410 have a backlight?

Yes, the thermometer features a backlit LCD display for easy reading in low-light conditions. The backlight turns on automatically when a button is pressed.

Can I replace the battery with a rechargeable 9V?

Yes, you can use a standard 9V rechargeable battery. Make sure it is fully charged before use. Battery life may vary depending on the battery type.

USER MANUAL RM410 Grado

RM400

RM410

RM420

TERMOMETRO DIGITALE MANUALE DI ISTRUZIONI

DIGITAL THERMOMETER INSTRUCTION MANUAL

MA RM400-RM410-RM420_01 B_09-2012

MORETTI

MORETTI S.P.A.

Via Bruxelles 3 - Meleto

MANUTENZIONE

Class IIa medical and measuring device in accordance with EEC directive 93/42 and its amendments

CODE

RM400- Rigid digital thermometer, 60 sec. RM410- Rigid digital thermometer, 30 sec. RM420- Flex digital thermometer, 30 sec.

INTRODUCTION

Thank you for purchasing GRADO by Moretti S.p.A. product range. This user's manual provides some suggestions as how to correctly use the product you have chosen and gives some valuable advice for your safety. Please read through the manual carefully before using the product. Should you have any queries, please contact your retailer for advice and assistance. In case of doubts, we recommend to contact the dealer who can help and advice you properly.

INTENDED USE

The thermometer is an instrument designed to measure body temperature

CAUTION!

• Do not use the product for a purpose not indicated in this manual
- Moretti S.p.A declines all responsibilities for any consequences resulting from an incorrect use of this product and from unauthorized alteration to the frame of the product.
- The manufacturer reserves the right to change the information contained in this document without previous notice

DECLARATION OF CONFORMITY

The GRADO thermometers by Moretti S.p.A complies with directive 93/42/EEC, medical devices and further modifications and complies with EN 12470-3: Clinical thermometers. Part 3: performance of compact electrical thermometers.

GENERAL WARNINGS

• DO NOT use this product or any available optional equipment without first completely reading and understanding this instruction manual.
• Keep the packed thermometer away from heat sources
• Do not store or keep in direct sunlight, or in high temperature
  • Service life - the thermometer use limit is defined by the wear of the parts
• Do not allow children to play on or operate the thermometer
• Do not use in the ear

GENERAL DESCRIPTION

The digital thermometers provide a fast and accurate reading of the body temperature. They have been designed for rectal, oral and axillary measurements The device bears the mark CEO197 according to the European regulation for Medical Devices. The device isn't subject to the calibration obligation though a quality control in accordance with directive 93/42/EEC

Parts view

HOW TO USE

• Do not bend, drop the thermometer
• Do not boil probé to disinfect
• Do not disassemble, except in case of battery replacement
• The thermometer should only be used under the supervision of an adult. Prohibit children from biting, hitting and removing the battery cover, dislodging and potentially swallowing the battery
• Do not use the device in case of strong electromagnetic field such as microwave oven or cell phone

BODY TEMPERATURE

Body temperature can vary from 36.1°C to 37.2°C. The generally accepted “normal” temperature is 37.0°C. Usually your temperature is lower in the morning than in the afternoon. Normal temperature varies according to the location of the temperature reading. While oral temperature follows the guidelines previously described, rectal temperature is generally 0.5°C higher. Conversely, axillary temperature will be 0.5°C lower

HOW TO USE

Measure the temperature

1. Press On/Off button
2. You will hear a beep and the screen will display 1888.e., then will display the last reading and then the autotest temperature
3. Finally the screen will display Lo°C and the symbol °C start flashing
4. The thermometer will start to measure the temperature as soon as it is exposed to body heat
5. The °C symbol will continue to flash until completion of the temperature taking process
6. After the measurement, the thermometer will emit a sequence of acoustiv signals
7. Push On/Off button to turn the unit off. If you do not turn off the unit, it will switch off automatically

NOTE If the measured temperature is less than 32°C the screen will display Lo, if the measured temperature is higher than 42.9°C the screen will display Hi

Method of measurement

There are three methods of measuring body temperature. Slight temperature differences may occur depending on the method of measurement

1. Oral measurement: using the diagram, place the probe tip under the tongue as near as possible to the heat pocket. Close your mouth and breathe evenly through the nose to prevent the measurement from being influenced.

1. Axillary measurement: the thermometer should be placed under the arm so the probe tip is touching the skin. Hold the thermometer parallel to the body and position the arm on the chest so the tip is well covered by the arm. This insures the probe is not affected by the room's air.

2. Rectal measurement: rectal temperature should be taken when is impossible or impractical to take oral or axillary temperature. The probe should be inserted a maximum of 1-2 cm.

Replace the battery

1. The battery should be replaced when the screen display

2. Pull battery cover off as shown in Fig.

3. Use pointed object such as a pen to remove old battery. Replace with new 1.5DC button type

4. Position the battery cover on the thermometer

MAINTENANCE

The GRADO devices by Moretti S.p.A are checked carefully and supplied with EC mark, once launched on the market.

For patient and physician's safety we recommend to let check the device by the manufacturer or by laboratory authorized every 2 years.

In case of repair, use only original spare parts and accessories.

CLEANING AND DISINFECTION

Cleaning use a damp cloth Disinfection if you need to disinfect the device use isopropyl rubbing alcohol

NOTE Never use acids, alkalis or solvents such as acetone

CONDITIONS OF DISPOSAL

- General conditions of disposal

In case of disposal don't use the inserting container for municipal waste. We recommend to dispose the thermometer in the appropriate disposal areas for recycling.

TREATMENT OF BATTERIES (Directive 2002/96/EC)

At the end of its life, the product must not be disposed of along with other domestic waste. The users must dispose of this equipment by bringing it to a specific recycling point for electric and electronic equipment or at retailers that provide this service. By ensuring these batteries are disposed of correctly, you will help prevent potentially negative consequences for the environment and human health which could otherwise be caused by inappropriate waste handling of the battery. To remark the need to dispose of electrical equipment separately, the products is marked with crossed mobile waste bin the product bears the barred bin symbol.

DISPOSAL OF WASTE BATTERIES (Directive 2006/66/Ec)

This symbol on the battery or on the packaging indicates that the battery provided with this product shall not be treated as household waste. By ensuring these batteries are disposed of correctly, you will help prevent potentially negative consequences for the environment and human health which could otherwise be caused by inappropriate waste handling of the battery. The recycling of the materials will help to conserve natural resources. At the end of their life hand the batteries over to the applicable collection points for the recycling of waste batteries. For more detailed information about recycling of this product or battery, please contact your local Civic Office, your household waste disposal service or the shop where you purchased the product.

TECHNICAL FEATURES

WEIGHT (INCLUDING BATTERY)

RANGE

ACCURACY

MEMORY

BATTERY

BATTERY LIFE

DISPLAY

USING ENVIRONMENT

STORAGE CONDITION

CLASSIFICATION

DIMENSION

REGULATION

SIMBOLOGYV

REF

code

Warning

ECREP

date of production

disposal

€ 0197

CE mark

type B

LOT

Lot

manufacturer

instruction

11,8gr

+0.1°C, 35.5°C +0.2°C under 35.5°C or over 42°C at standard room temperature of 18°C to 28°C

H

RH

Moretti products are guaranteed from material or manufacturing faults for 2 years from the purchasing date, except possible exclusion or restriction as follows. The warranty shall not be applied in the possible damages caused by improper use, abuse or alteration, and the warranty will not be valid if the instructions for use are not strictly adhered to. The correct intended use is specified in this manual. Moretti is not responsible for consequent damages, personal injuries or whatever caused by or in relation to wrong installation or improper use. Moretti warranty does not cover damages resulting from: natural disaster, not authorized maintenance or repairs, faults caused by problems on electricity supply (when necessary), use of spare parts not covered by Moretti, improper use, not authorized alteration, shipment damages (different from original Moretti shipment), or in case of insufficient maintenance as indicated in the manual. The warranty doesn't cover components subject to wear and tear during the correct use of the device.

RECHARGEABLE BATTERIES WARRANTY

The original batteries and the spare batteries are covered by a 90 days warranty during a period of 6 month, with regards to manufacturing defeat or to what concern the law regulation. If charge batteries are unused for more than 3 consecutive months, the warranty is void. If exhausted batteries are unused for more than 3 consecutive days, the warranty is void.

REPAIRING

WARRANTY REPAIR

If a Moretti item presents material or manufacturing faults during the warranty period, Moretti will confirm with customer if the fault can be covered from warranty. Moretti, at its unquestionable discretion, can repair or replace the item, by a Moretti dealer or to Moretti headquarters. Labor cost can be charged to Moretti if the repair is covered by warranty. A repair or a replacement doesn't extend the warranty.

REPAIR NOT COVERED BY WARRANTY

A product out of warranty can be sent after Moretti authorization. The labor and shipping costs for good out of warranty are to be paid by the customer or by the dealer. The repairs are guaranteed for 6 months from the good received. NON-DEFECTIVE DEVICE

The customer will be informed if, after the device return and examination, Moretti declares that the device is not faulty. In this case the good will be sent back to customer, the shipping charge will be paid by the customer. SPARE PARTS

The original Moretti spare parts are guaranteed for 6 months from the receiving date.

EXEMPT CLAUSES

Moretti does not offer any other declaration, explicit or implicit warranty or conditions, , including possible declarations, warranties or conditions of merchantability, fitness for a specific purpose, non infringement and non interference, all but what expressly specified in this warranty. Moretti does not guarantee the nonstop and faultless usage. The duration of possible implicit warranties which can be imposed by the law is limited by the warranty period, in the limits of law. Some states or countries don't allow limiting the implicit warranty or the exclusion or the limitation for accidental damages. In such countries, some of those exclusions or limitation may not be applied to the user. The present warranty may be modified without prior notification.

MORETTI

WARRANTY CERTIFICATE

Product	Purchasing date
Authorized dealer	Street	Place
Sold to	Street	place

Hangzhou Sejoy Doctor Electronics & Instruments Co., LTD Building 2, No.202 Zhenzhong Road - West Lake Economy & Technology Zone 310030 Hangzhou China EC REP SHANGHAI INTERNATIONAL TRADING CORP. GMBH Eiffestrasse 80, 20537 Hamburg, Germany
Distribuito da / Distributed by:
MORETTI S.P.A.
Via Bruxelles, 3 - Meleto 52022 Cavriglia (Arezzo) Tel. [phone]
www.morettispa.com email: [e-mail]
MADE in P.R.C.

MORETTI®

Distribuito da / Distributed by:

Via Bruxelles, 3 - Mcleto