BDPB8010W - Tumble drier BEKO - Free user manual and instructions
Find the device manual for free BDPB8010W BEKO in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | Condenser Tumble Dryer |
| Capacity | 8 kg |
| Energy Class | A++ |
| Annual Energy Consumption | 561 kWh |
| Drying Programs | Cotton, Synthetics, Delicates, Mix, Shirts, Sport, Jeans, Quick (30 min), Warm, Cold Air |
| Number of Programs | 15 |
| Dimensions (H x W x D) | 85 x 60 x 60 cm |
| Weight | 42 kg |
| Power Supply | 230 V ~ 50 Hz |
| Current | 10 A |
| Motor Type | Inverter (Brushless) |
| Drying Technology | Condenser with Heat Pump |
| Noise Level | 64 dB (A) |
| Condenser Efficiency | Energy efficiency ratio B |
| Condenser Cleaning | Automatic condenser cleaning system |
| Filter Indicator | Lint filter cleaning reminder |
| Water Tank Indicator | Full tank alert |
| Drum Material | Stainless steel |
| Reverse Tumbling | Yes, anti-crease feature |
| Child Lock | Yes |
| Delay Timer | Up to 24 hours |
| Suitable for Installation | Standalone or under counter (requires ventilation) |
| Accessories Included | User manual, warranty card, water drain hose |
Frequently Asked Questions - BDPB8010W BEKO
How do I clean the lint filter?
Open the door, pull the lint filter upward from the door seal, remove lint by hand or with a soft brush, and rinse under running water if necessary. Dry thoroughly and reinsert. Clean after every cycle for optimal performance.
Why is my dryer not starting?
Check if the door is fully closed, the power cord is plugged in, and the circuit breaker is on. Also ensure the delay timer is not set. If the problem persists, inspect the child lock function (press and hold a specific button).
What does the water tank full indicator mean?
The water tank indicator lights up when the condensation water container is full. Pull out the tank (bottom drawer), empty it into a sink, and reinsert it properly. The dryer will resume automatically.
How often should I clean the condenser?
Clean the condenser unit every 3-5 cycles or when the condenser cleaning indicator lights up. Open the lower flap, pull out the condenser, rinse with water (avoiding electronics), let dry, and reinstall.
What is the maximum load capacity for cotton?
For cotton programs, the maximum dry load is 8 kg. Overloading may cause poor drying results, longer cycles, and wear on the machine.
Can I install the dryer under a worktop?
Yes, the dryer can be installed under a counter as long as there is adequate ventilation (min. 2 cm gap at sides and top). Use the supplied vent kit if needed.
What should I do if the dryer stops mid-cycle?
First, check for error codes on the display (e.g., E01, E02). Common causes: water tank full, blocked filter, overheating. Reset the dryer by turning it off and on after 5 minutes.
How to select the right drying program?
Choose a program based on fabric type: Cotton for durable items, Synthetics for polyester/acrylic, Delicates for lingerie, and Quick for small loads (30 min). Refer to care labels.
Where is the model number located?
The model number (BDPB8010W) is printed on the rating plate behind the door (inside frame) or on the back panel. Also on the original packaging.
What spare parts are commonly replaced?
Commonly replaced parts include door hinges, door seal, lint filter, condenser unit, drive belt, heating element, and control board. Use genuine Beko parts for safety.
User questions about BDPB8010W BEKO
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Tumble drier in PDF format for free! Find your manual BDPB8010W - BEKO and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. BDPB8010W by BEKO.