MJLR-2001 - Electrical switch Nexa - Free user manual and instructions

USER MANUAL MJLR-2001 Nexa

(17) 1.2.3.4.5.6.7.8.9.10.11.12.13.14.15.16.17.18.19.20.21.22.23.24.25.26.27.28.29.30.31.32.33.34.35.36.37.38.39.40.41.42.43.44.45.46.47.48.49.50.51.52.53.54.55.56.57.58.59.60.61.62.63.64.65.66.67.68.69.70.71.72.73.74.75.76.77.78.79.80.81.82.83.84.85.86.87.88.89.90.91.92.93.94.95.96.97.98.99.100

RADERING AV ENSKOLD MINNESPLATS

RADERING AV ALLA MINNESPLATSER.

LED-inducing pA montageron blinker stable under 2 seconds.

MINNE

1. Wedward Section News Editorial

2. Wed origa manda System Nexa sondere

3. Wed Nexa Smart Hub

4. Kred News Bridge

ANYANONING

in Ibericamalári (Hoza

1. Trusk kori multi-caparous spas. NED ▼* Es all-storé öftricna

EAST LED 100mm, 250mm 300mm 400mm 500mm

KALIDRITING MED INLÄRD EJÄRBKONTROLL

In fact, the 14th European Union market was not fully available.

1. LED 104.1982 and 51.603.5.68X, 交换式转换

OBS

Gill injen Krajdyckes Bank from 30 sekundar man aktiening av

In the case of the 1980s, the case was

belastning: Asin, skin, and/or skin washing can be used.

morzaanis animalis belasting. De kuc lada till st. korstating she

god

Lysuppehåliande utrustning: Pravind akin, Texas produceri

Insuppehåande utrustning eller andra apparser der löl dier stomings

kan ta tshopande builder.

VSP INKORPLING AV DC MOTOR

VID INKOFFEING AV DO MOTOR Firmity: Du an att Dix DC motor lom varles in 61

The following section is also highlighted.

The following table provides the original data:

Kopplingsschema 230V AC Motor

Kopplingsschema 12-24V DC Motor

ENGLISH

Built-in receiver with potential-free relay contacts for permanent

installation; for placement in connection- or wall box. The MOLR 2001 features two potential free relay outputs with a shared input, which allows control of optional voltages. The receiver is fully compatible with other System Nexa products.

SAFETY

Read all the instructions carefully that. Call in a professional if necessary. Nesa cannot be held liable if the product is used for any purpose other than that for which it was designed, or if the associated instructions are not followed.

Never connect lights or any equipment that exceeds the maximum stated load of the receiver, as this can result in faults, short circuit or fire.

Do not attempt to repair the product. The product contains no

service points

INSTALLATION

Make sure that the wires are free from voltage by disconnecting

the current in the electricity panel. See the circuit diagram for the two of more that is to be used.

Use the color map can be the type of color with the color

PROGRAMMING

In order to control the MILR-2000 with a System Nexa remote control (or other unit), the transmitter and receiver must be connected as follows:

1. Correct power to the 21.5.2021

2. Quietly press the programming button: the LED projector will suit

with slowly

1. Press the "ON" button for the selected channel on a System Newa remote control within 12 seconds

CONFIRMATION OF PROGRAMMING

The LED indicator on the receiver dishes orally for 2 seconds.

DELIFE MEMORY SLOT

DELETE MEMORY SLOT 1. Concept power to the MUR-2001

1. Briefly press the "programming" button, the LED indicator will

start to finish slowly

1. Press the "OFF" button for the selected channel on a System

1. Connect power to the MOLR 2001

2. Press and how the program's tools for 5 seconds, the LED indicator will exist to 300 volts.

3. Reduce the weight of a protein, the

more

CONFIRMATION OF DELETION

The LED indicator on the receiver flashes slowly for 2

第42页

MEMORY

The MLR-2001 has 32 memory slots and can be controlled from up to 32 different units (remote controls, Bridge, etc.). If all memory slots are filled, the oldest slot will be deleted when a new channel is programmed.

CONTROL

The receiver can be controlled in several ways

1. With a programmed System Nova Remote Control

2. With other programmed System Next transmitters

3. With other English

4. With a Nella Smart-100

5. With Nova Group

USE

1534

with professional health centre, all pharmacists of next break

3.1.10.2017年1月1日

Stock direction LP 9500 ON 26-34 again

S. B. G. D. O. A. S.

Supercritical DOWN. Sent OFF signal again

CALIBRATION

There is a large selection of curvins, film screens and other motorized electronics on the market and for optimal function, maximum and minimum slot positions must be programmed into the receiver's memory.

CALIBRATION WITHOUT REMOTE CONTROL

1. Press and hand the calibration button for 3 seconds, both LED

industries steel bushing

1. Briefly press the receiver's "DOWN" button▼ to start the downward direction. How can be desired, action is reached, before, over the

"DOWN" burson▼ again.

1. Briefly press the member

direction. When the desired position is reached, bis-0_f proves the UP

button ▲ again.

1. Press and hold the calibration button for more than 2 seconds to end and save the calibration.

Both LEC indicators flush carefully for confirmation.

CALIBRATION WITH PROGRAMMED REMOTE CONTROL

1. Does not have the calibration button for 8 seconds, both LED

2. 1-20% is not a free basis. The real-time limit is a reasonable, but 1-P-D indications start fashion.

3. B=0.15, n=36, P=0.05

downward direction. When the desired position is reached, barely

press the OFF button again.

1. Briefly press the members "ON" human to start the upward direction.

When the desired state

If no button is pressed within 30 seconds of activating calibration

mode: the receiver returns to operating mode again.

SAFETY AND INFORMATION

Range Indoors: up to 30 m (optima conditions). The range is heavily dependent on local conditions, such as there are

Actively dependent on local conditions – such as if there are any

metals nearby. For example, the heavy metal coating in low- original energy layer has a negative impact on the range of the

cussion energy guess has a negative impact on the range of the radio signals. There may be limitations on the use of the unit outside

the EU. If appropriate, check that the unit complies with the local

regular ones.

Max. load: Never connect lights or equipment that exceeds the

maximum load of the receiver. This can result in faults, short circuit

Life-support equipment: Never use Nava products for the support

equipment or other devices where faults or disruptors can pass

ile-threatening consequences.

Disruptions: AI wireless units can be affected by disruptors that

may have an impact on performance and range. The minimum

distance between two receivers should therefore be at least 50 cm.

Repairs: Do not attempt to repair the product. It does not contain any receivable parts.

any serviceable parts. Waterproof: The

Water producing: The product is hot water/roof. Make sure that it is above day. Moisture will consist the electronic components inside

always dry. Measure will correct the electrical components here and may result in short circuit, faults and risks of electric shock.

Cleaning: Clean the product with a dry cloth. Do not use chemicals.

solvents or patent cleaning agents.

Environment: Do not expose the product to extreme heat or cold, on this way, however, the electronic cavity is exposed that is open

se this may damage the electronic closure of other their service life.

WHEN CONNECTING A DC MOTOR

Make sure that your DC motor can be connected to permanent

voltage and controlled according to the chart.

Circuit diagram, 230 V AC Motor

NORSK

Inrebygde motakere med potenslafte relékontakter for fast installasjon, plasseri i en utkobing eller enhetsbors. MJLR-2000 har to potenslafte nöhtulganger med en folles Ingang, som muligger kontrol av enher sponsing. Motakeren har full kompatilitas med andre produkter i System Nexa.

Sa kettigewertet for bilker, two water camp and outkes

of 103192669

REGISTRERING

1. It is a 100% of the total of the total of the total of the total of the total of the total of the total of the total of the total of the total of the total of the total of the total of the total of the total of the total of the total of the total of the total of the total of the total of the total of the total of the total of the total of the total of the total of the total of the total of the total of the total of the total of the total of the total

System 3684-100101112

BEKREFTE REGISTRERING

1. EC-indikator: μ5 mabibensin blaser mask, i 2 seconds

SLETTE EN MINNEPLASS

1. Transaktion H27 (362)

2. Tasks of reason to represent a plan for task at the

LEDmonokuloren begymer: a blinke langson!

SLETTE ALLE MINNEPLASSER

1. Susammell RJIS-2030

2. Tryks all registringsenappen og held den time 6 sekundet.

LED-indikator bagyne 3 hincen mask.

1. Slipp registrer inskredent, tryck den inn på nyt og stop den nekt.

2. No of the first three cases

BEKREPTE SCETTING

1.1.3.4.5.6.7.8.9.10.11.12.13.14.15.16.17.18.19.20.21.22.23.24.25.26.27.28.29.30.31.32.33.34.35.36.37.38.39.40.41.42.43.44.45.46.47.48.49.50.51.52.53.54.55.56.57.58.59.60.61.62.63.64.65.66.67.68.69.70.71.72.73.74.75.76.77.78.79.80.81.82.83.84.85.86.87.88.89.90.91.92.93.94.95.96.97.98.99.100

MINNE

click a link platform, by for 500 an off-spot the market are by minlvaic stepconsistencies programmes in l-matakomes minx

KALIBRERING UTEN FJERNKONTROLL

1. Trykk på mettakerons kalibreringsknepp i 3 sekundcy, beggo

LED-ndikasjana bogenor s blinks.

1. Trykkor, par olliskeres knapp "NEO" for a elare

redscysende rebring. Nat ensket posqun et insat, tryker du kett

1. Trinkovik vettakovice

c. Try a list of 10000000000000000000000000000000000000000000000

"HEPA"

1. Tryks ugbud une kahlmeriapskappen i mer erm 3 sekundet (in u

Begger LED - and Resonance Driver make for battery.

KALIDRERING MED REGISTRET EJERNKONTROL

1. Tafikonal memulatus D

2. 10% of the first major events are not a result that is

Ko-crep kler.

1. Inks of

Bogge LED - make anyone dinner base for best exercise.

OBS.

Hos det ikke byråkes på roten krapp innen 30 sekunden eller at kelbronningsmodusen bie aktiver, går motelakoren Hoeké II dritismodus ikjen.

SIKKERHET OG ANNEN INFORMASJON

Kobingsakjema, 12-24V DC-motor

SUOMI

MUISTIPAIKAN TYHJENNYS

Alaia NOSTO, Laiya PAA II-epi

[Unreadable]

Alpha ASKII, Lycera FGB

2016年1月1日

Pyskylu DASKU Lakhela POB signal under test

DC-MOOTTORIN LIITANTA

Vermis, etti DC-muchari vortisen litiša previsa iinnitteseen is

ohiata kasian mukasesi.

KALIBROINTIA YARTEN

Katsa englascinkelinen obie

TURVALLISUUS JA TIEDOT