IWH-1.5 - Water heater Camec - Free user manual and instructions
Find the device manual for free IWH-1.5 Camec in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | Electric Water Heater |
| Brand | Camec |
| Model | IWH-1.5 |
| Capacity | 1.5 gallons (5.7 liters) |
| Power Consumption | 1500W |
| Voltage | 120V AC |
| Current | 12.5A |
| Dimensions (H x W x D) | 12 x 12 x 12 inches |
| Weight | 10 lbs (4.5 kg) |
| Tank Material | Stainless Steel |
| Insulation | Polyurethane Foam |
| Temperature Range | 80°F - 140°F (27°C - 60°C) |
| Thermostat | Adjustable |
| Safety Features | Overheat Protection, Pressure Relief Valve |
| Installation Type | Wall-Mountable |
| Water Connection | 1/2 inch NPT |
| Maintenance | Annual Flushing Recommended |
| Certifications | UL Listed |
Frequently Asked Questions - IWH-1.5 Camec
How do I install the Camec IWH-1.5 water heater?
Installation should be performed by a qualified professional. The heater must be mounted on a wall, connected to cold water supply and electrical outlet. Ensure the pressure relief valve is properly installed and the unit is level.
How do I adjust the temperature?
Locate the thermostat dial on the front panel. Turn it to your desired temperature, typically between 80°F and 140°F. Wait a few minutes for the heater to reach the set temperature.
Why is there no hot water?
Check the power supply and ensure the circuit breaker is not tripped. Verify the temperature setting is above 120°F. If the reset button on the thermostat has tripped, press it to reset.
How do I drain the water heater?
Turn off power and cold water supply. Attach a hose to the drain valve at the bottom. Open the valve and a hot water faucet to allow air in. Drain completely, then close valve and refill before restoring power.
What maintenance is required?
Annually, flush the tank to remove sediment. Check the pressure relief valve by lifting the lever briefly. Inspect all connections for leaks. Replace the anode rod every 3-5 years.
Is the water heater safe for indoor use?
Yes, the IWH-1.5 is designed for indoor use with proper ventilation. It includes overheat protection and a pressure relief valve for safety.
What are the electrical requirements?
The unit requires a 120V AC power supply, 12.5A, on a dedicated circuit. Use a GFCI outlet if required by local codes. Do not use an extension cord.
Can I use it with a solar water heating system?
Yes, it can be used as a booster or backup heater. Connect the solar pre-heated water to the cold inlet. Ensure the thermostat is set appropriately.
What should I do if the pressure relief valve leaks?
First, check if the valve is fully closed. If it continues to leak, it may be faulty or there may be excessive pressure. Replace the valve or install a pressure regulator.
How long should the water heater last?
With proper maintenance, the IWH-1.5 can last 10-15 years. Regular flushing and anode rod replacement extend its lifespan. Corrosion is the main cause of failure.
User questions about IWH-1.5 Camec
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Water heater in PDF format for free! Find your manual IWH-1.5 - Camec and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. IWH-1.5 by Camec.