Forza EH-A9022ST(SS) - Range hood Elba - Free user manual and instructions

Product Type	Range Hood
Model	Forza EH-A9022ST(SS)
Brand	Elba
Mounting Type	Wall-mounted
Width	90 cm (36 inches)
Depth	50 cm (approx.)
Height (without chimney)	15 cm (approx.)
Weight	12 kg (approx.)
Material	Stainless Steel
Control Type	Electronic push buttons
Number of Speeds	3 / 4 (typical)
Lighting	LED lights (2 x 1.5W)
Extraction Capacity	600-800 m³/h (estimated)
Noise Level	55-65 dB (approx.)
Filter Type	Aluminum grease filter (washable)
Air Discharge	Top or rear (150mm diameter)
Power Supply	220-240V, 50 Hz
Power Consumption	150-250 W (including lights)
Energy Class	B (estimated)
Installation	Professional recommended
Maintenance	Clean filters monthly; replace charcoal filters (if recirculating) every 3-6 months
Accessories Included	Chimney, mounting kit, instruction manual
Warranty	2 years (check local regulations)

Frequently Asked Questions - Forza EH-A9022ST(SS) Elba

How do I install the Elba Forza EH-A9022ST(SS) range hood?

Installation is best performed by a qualified professional. Ensure proper ducting to the outside. Refer to the manual for mounting height (typically 65-75 cm above cooktop).

How often should I clean the grease filters?

The aluminum grease filters should be cleaned every month with warm soapy water or in a dishwasher. Dry them thoroughly before reinstalling.

Can I use the range hood in recirculation mode?

Yes, you can use it without external ducting by installing charcoal filters (sold separately). Recirculation returns filtered air back into the kitchen.

What is the noise level of this range hood?

The noise level varies by speed, typically between 55 and 65 dB, which is comparable to a normal conversation.

How do I replace the LED lights?

Switch off power, remove the light cover, and replace the LED module. If needed, contact Elba support for the correct replacement part.

What are the dimensions of the Elba Forza EH-A9022ST(SS)?

The product width is 90 cm, depth about 50 cm, and height (without chimney) around 15 cm. Chimney height is adjustable.

Does the range hood have a remote control?

The standard model does not include a remote control; it is operated via buttons on the front panel.

How do I adjust the fan speed?

Press the speed buttons on the control panel to cycle through low, medium, and high settings. Some models have an additional boost speed.

What should I do if the hood is not extracting properly?

First, clean the filters. Check for blockages in the ducting. Ensure the damper/flap is opening. If problem persists, contact a professional.

Is the stainless steel surface easy to clean?

Yes, wipe with a soft cloth and mild detergent. Avoid abrasive cleaners to prevent scratching. Dry with a lint-free cloth.

USER MANUAL Forza EH-A9022ST(SS) Elba

Exterior view of a stainless steel kitchen air conditioner unit (no text or symbols visible)

ELBA

DESIGNER HOOD

MODEL: FORZA EH-A9022ST(SS)

Owner's Manual

Please read this manual carefully before operating your set.

Retain it for future reference.

Record model number and serial number of the set.

See the label attached on the set and quote this information to your dealer when you require service.

Please read this instruction carefully. It is advisable to keep this instruction manual in a safe place for future reference.

SAFETY PRECAUTIONS

1. Keep electrical appliances out of reach from children. Do not let them to operate the appliances without supervision.
2. To protect against the risk of electrical shock, do not immerse the product, cord or plug into water or any other liquid.
3. This product is for household and indoor use only.
4. This product is not intended for use by person (including children) with reduced physical, sensory or mental capabilities unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
5. If the power cord or plug in damaged, it must be replaced by the service centre or a qualified service technician to avoid hazard.
6. Before installation, check if the mains supply voltage is matched with the voltage stated on the rating plate of the hood.
7. There must be adequate air ventilation of the room when the cooker hood is used with the cooking appliances with burning gas or other fuels.
8. Ensure that the installation of exhaust complies with the standard of local building, gas and electrical authorities.
9. Do not ignite flames in the pans.
10. There is a risk of fire if cleaning is not carried out in accordance with this instruction.

ASSEMBLY INSTRUCTIONS

Please check the following before installation:

• Installation of hood must be carried out by an authorized or qualified technician.
• For optimum air extraction, avoid having too many windows surrounding the cooker hood which will cause air convection.
• Make sure the hood is in level after installation to avoid oil spill over from the oil cup collectors.
• The optimum height for the installation is between 300 to 350mm which measure from the bottom of the hood to the top of the hob.

1) Before installing, determine the height between the bottom of the cooker hood to the top of the hob.
2) Mark the wall to suit all bracket locations.
3) Drill 4 holes with diameter of ∅10mm and 60mm deep. Insert the screw anchors into the holes. Tighten the screw with the mounting bracket.
4) Hang the hood on the mounting bracket and make sure the hood is in level.
5) Fix the exhaust ducting on the hood with the screws provided.
6) Install the telescopic exhaust cover to the height required.
7) Install the oil cups on the cooker hood.
8) Before connecting to the mains supply, ensure that the mains voltage corresponds to the voltage on the rating plate inside the cooker hood.

PRODUCT DESCRIPTION

1. On/Off Button – To switch the cooker hood in standby mode and turn off the cooker hood.

2. Fan Delay Off Function – Press this button to schedule a delay to turn off the cooker hood.

3. LED Light Illumination – To switch on/off the LED light.

4. Normal Fan Speed – Press this button to activate normal fan speed.

5. High Fan Speed – Press this button to activate high fan speed.

OPERATING INSTRUCTIONS

1. Press the button and press the button to operate the cooker hood in normal speed. Press the button to operate the cooker hood in high speed.

2. When the motor is running, press (button to turn off the cooker hood. (This function does not relate to the LED illumination)

3. Press the button to turn on the LED light of the cooker hood. Press again to turn off. (This function does not relate to the cooker hood motor)

CLEANING AND MAINTENANCE

• The hood must always be disconnected from the electricity supply before carrying out the maintenance.
• Clean the hood with damp cloth with hot water and mild detergent. Do not use chemical, steel, wooden or abrasive cleaners to clean the hood.
• Clean the oil cups when they are more than half filled to avoid the oil from spilling.
• Remove the filter, wash in hot soapy water, dry and fit back into the hood. Do not use the hood without the filter installed.

MAIN SPECIFICATION

Rated Voltage : 220-240V/50Hz

Light : 2W x 2

Suction Power : 1,200m³/hr

Motor Power : 220W

Product Dimension : 900mm(W) x 940-1340mm(H) x 399mm(D)

NOTICE

This product must not be disposed together with domestic waste. It has to be disposed at an authorized place for recycling of electrical and electronic appliances. By collecting and recycling waste, you help to save natural resources and make sure the product is disposed in an environmental friendly and healthy way.

ELBA