Ana2 - Synthesizer Mystic Circuits - Free user manual and instructions
Find the device manual for free Ana2 Mystic Circuits in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | Eurorack Synthesizer Module |
| Brand | Mystic Circuits |
| Model | Ana2 |
| Width | 8 HP (40.3 mm) |
| Height | 3U (128.5 mm) |
| Depth | 30 mm |
| Weight | Approx. 100 g |
| Power Requirements | +12V: 50 mA, -12V: 30 mA |
| Power Connector | 10-pin ribbon cable (Eurorack standard) |
| Main Functions | Dual analog logic, comparator, slew limiting, CV processing |
| Inputs | 2x CV inputs (0-10V), 1x gate input |
| Outputs | 2x CV outputs, 1x gate output |
| Controls | 4 knobs (offset, threshold, slew, mix), 2 toggle switches |
| LED Indicators | 4 LEDs for signal activity and level |
| Construction | PCB with aluminum front panel |
| Mounting | Eurorack rails with included screws |
| Compatibility | Any Eurorack case with standard power supply |
| Maintenance | Wipe with dry cloth; avoid moisture |
| Safety | Disconnect power before installation; avoid short circuits |
| Spare Parts & Repairability | Contact manufacturer for replacements; user-serviceable only with guidance |
| General Information | Analog module for complex modulation and logic operations |
Frequently Asked Questions - Ana2 Mystic Circuits
What is the Ana2 module used for?
The Ana2 is a dual analog logic module designed for processing control voltages in a Eurorack synthesizer system. It can perform functions like comparison, slew limiting, and mixing.
How do I power the Ana2?
Connect the module to your Eurorack case using the included 10-pin ribbon cable. Ensure correct polarity: the red stripe aligns with the -12V rail on the bus board. Power consumption is approximately 50 mA on +12V and 30 mA on -12V.
What are the input and output voltage ranges?
Inputs accept 0-10V CV signals. Outputs typically range from 0-8V depending on settings. Gate input thresholds are 2.5V.
Can I use the Ana2 with audio signals?
While primarily designed for CV, the module can process audio-rate signals for creative effects like wave shaping or logic-based audio mixing.
How do I calibrate the module?
The Ana2 is factory-calibrated. No user calibration is required. If you suspect drift, refer to the manual for trimmer adjustment under the front panel.
What is the module's depth?
The depth is 30 mm from the front panel to the rear of the PCB. Ensure your case has at least 35 mm clearance to accommodate the power cable.
Can I chain multiple Ana2 modules?
Yes, you can connect outputs of one Ana2 to inputs of another for more complex logic chains or cascading operations.
What do the LEDs indicate?
The four LEDs show signal presence and polarity for each channel. Brighter LEDs indicate higher voltage levels.
How do I clean the module?
Disconnect power first. Use a soft, dry cloth to wipe the front panel. Avoid liquids or abrasive cleaners.
Where can I find the full manual and support?
Download the manual from notice-facile.com or the Mystic Circuits website. For support, contact them via their official channels.
User questions about Ana2 Mystic Circuits
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Synthesizer in PDF format for free! Find your manual Ana2 - Mystic Circuits and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. Ana2 by Mystic Circuits.