Frequently Asked Questions - CFT611NW CANDY
How to install the CANDY CFT611NW range hood?
Mount the hood at a minimum height of 65 cm above an electric hob and 70 cm above a gas hob. Use the provided template to mark fixing holes, drill and secure the wall bracket. Connect the exhaust duct or install a charcoal filter for recirculation mode. Finally, connect the electricity supply and test the functions.
How often should I clean the grease filters?
The aluminium grease filters should be cleaned every 2-3 months, or more frequently with heavy cooking. Remove them from the hood and wash by hand in warm water with a mild detergent or in the dishwasher at low temperature. Dry thoroughly before reinserting.
How do I replace the LED lights?
First, switch off the range hood and disconnect it from the power supply. Gently pry out the LED light module with a flat-head screwdriver. Disconnect the wiring, fit the replacement LED module (1.5 W, same type) and reconnect. Push the module back into place until it clicks.
Can the CFT611NW be used in recirculation mode?
Yes, this hood supports recirculation mode. You need to install an activated charcoal filter (not included) at the top or side of the hood. This filter absorbs odours and must be replaced every 4-6 months depending on usage.
How do I change the charcoal filter?
Remove the aluminium grease filters first to access the charcoal filter. Take out the saturated activated carbon filter and insert a new one. Ensure it locks securely. Replace the grease filters and run the hood for a minute to test.
Why is my range hood noisy?
Noise can increase if the grease filters are clogged, if the duct is blocked, or if the hood is not properly mounted. Check and clean filters, verify the duct is free, and ensure all screws are tightened. Excessive vibration may also occur if the hood touches the wall; adjust the spacers.
How can I adjust the fan speed?
Use the electronic touch controls on the front panel. Press the fan speed button repeatedly to cycle through the three speeds (1, 2, 3). Some models also have a boost function; press and hold the button to activate.
What is the best way to clean the exterior surface?
Wipe the exterior with a soft, damp cloth and a mild cleaner. Avoid abrasive sponges or harsh chemicals that may damage the finish. For stainless steel areas, use a dedicated cleaner and rub in the direction of the grain. For painted surfaces (as in this model), a damp cloth is sufficient.
Does the hood include a bulb?
Yes, the hood is equipped with integrated LED lighting (2 x 1.5 W). These are low-energy LEDs that produce bright, cool light. They have a long lifespan, but when they fail, they can be replaced individually.
What should I do if the control panel does not respond?
First, reset the unit by turning off the power for 10 minutes. Check the wiring and ensure the power cable is connected. If the issue persists, the electronic control board may be faulty. Contact CANDY customer service or a qualified technician for repair.
USER MANUAL CFT611NW CANDY
Websted: https://corporate.haier-europe.com/
Kundeservice:
Navn: Candy Hoover Group contact
Websted: https://corporate.haier-europe.com
E-mail: eprel_info@haier-europe.com
Telefon: +3903920861
Adresse:
Via Comolli 16
20861 Brugherio
Italien