VT-2372 BW - Razor Vitek - Free user manual and instructions

Product Type	Men's Electric Shaver
Model	VT-2372 BW
Brand	Vitek
Power Supply	Rechargeable battery via adapter (100-240 V ~ 50/60 Hz)
Adapter Output	2V DC, 930 mA
Charging Time	8 hours for initial charge; subsequent charges as needed
Shaving System	Rotary shaving block with floating heads
Trimmer	Pop-up trimmer for sideburns and detailing
Wet/Dry Use	Shaving block washable under running water (body not waterproof)
Cleaning	Detachable shaving block for brush cleaning or water rinse
Shaving Head Replacement	Replace every 2 years for optimal performance
Included Accessories	Shaver, power adapter, protection cap, pouch, cleaning brush
Safety Features	Do not immerse shaver body; use only supplied adapter; keep away from water
Repairability	Replaceable shaving heads and blades; trimmer lubrication recommended
Environment	Disposable battery; recycle according to local regulations

Frequently Asked Questions - VT-2372 BW Vitek

How long does it take to charge the Vitek VT-2372 BW shaver?

The initial charge requires 8 hours. Subsequent charges may take less time if the battery is not fully depleted.

Can I use the shaver while it is charging?

No, the shaver should not be used while charging. Switch it off and disconnect the adapter before use.

Is the shaver waterproof?

Only the shaving block can be washed under running water. The shaver body must not be immersed or exposed to water.

How should I clean the shaver?

Remove the shaving block by pressing the release button. Clean the block with the brush from inside and outside, or rinse it under warm water. Dry thoroughly before reassembly.

How often should I replace the shaving heads?

For best results, replace the shaving heads every 2 years. Follow the instructions in the manual for replacement.

Can I use the shaver with foam or gel?

The manual does not specify wet shaving with foam. For wet cleaning, only water is mentioned. It is likely designed for dry shaving only.

What accessories are included?

The box includes: the shaver, power adapter, protection cap, pouch, and cleaning brush.

How do I use the trimmer?

Switch off the shaver, press the trimmer lock, and slide the trimmer up. Clean it with the brush after each use and lubricate occasionally.

What should I do if the shaver stops working?

Check that the battery is charged. If the issue persists, contact the dealer for warranty service. Do not attempt to repair yourself.

How do I dispose of the shaver at the end of its life?

Discharge the battery completely, then remove it. Dispose of the shaver and battery according to local hazardous waste regulations.

USER MANUAL VT-2372 BW Vitek

ENGLISH

MEN SHAVED

Unit parts

1. Protection cap

2. Shaving block

3. Blacken-drive

4. Shaving block release button

5. Answer (which)

T. Charging indic

1. Power cord box

2. Trimmer lock

3. Power cord

4. Thermal

5. Cleaning bulb

6. Pouch

SUBSTUDUALTY

SAFETY MEASO (Before using the

fully and keep-the-line the unit for

(specified) in this

lead to its breakas

• Before sharp

make sure B

• Use the shaver

Do not leave th

• Shenzhen the other or what you are

• Do not charge

ty and temp- temperature

humidity so in

• To charge the supplied with

if the insolutia

- Do not place or open flame

Do not immers

- Mihen anplatz

not the-oxed.

- To avoid injury aged stations

Imp Blurles.

- Do not allow Keep the unit

• For Children's

- 40% of the

polyethylene

of surfactant • This unit is m

or disabled p

the Necessary by a perwaro

Up on safety

danger that of the unit.

Do not repair

(1) Action/Action

THE UNIT IS INT

ONLY

USING OF SHAK

After oral transposperaphyel is nec

hours at room to

Charging [mc. 1] Before using the

a long period of

charged for 8 hours • Insert the oven

tor (III) and co

the changing

two hours.

- Charge the ba (No SWG

- if you didn't use

Switch the shower off selling the switch (E) to the

-4+ position and close the transformer by pressing it.

CLEANING AND CARE

Catch the shaking block [2] and (very using of a ten several operation cycles of the shaver.

- For easy cleaning of the shaving block (2)

Remove it from the thicker body by opening it and pulling it upwards (pic. 3, 4).

- Using the brush (11) clean the shaving block

(2) both from the inside and outside, clean the blades drive (3) (pic. 5, 6).

- Install the shawing block (2) to its place, cover it

with the protection cap (1) and take no smaller range for storage.

It is recommended to clean the shaving heads every two months (bis. B, 31)

- Switch the shower off by setting the switch (E) to the 0.25 mm

Press the release button (4) and remove the

shaving block (2).

- Press and turn the frame clamp counterdoose-vice and remove the frame.

- Remove every stationary net together with the

Note: Be careful when removing the stationary

Note: Install the rotating blades to the same sets

after cleaning, otherwise tiring or rotating blades to the nets will take some time and this may affect the

quality of shaving.

- Clean the rotating blades and the stationary belt with the brush.

- Install the stationary nets into the shaving block;

and/or that both are forced; to fix that hot turn it clockwise-or counterclockwise.

- Insert the rotating blades into the stationary

- Install the locking frame, press the frame clamp

and turn it clockwise.

Mood: Match the edges on the shaving block left the openings in the locking frame; otherwise, you'll

not be able to install the locking frame.

- Imral the shaving stock on the issuer.

Attention!

You can wash the following block under a warm water jet (joic. 7), if the staving block (2) is detached from

the shaver body (5). Dry the shaving block (2) thor-

slightly before mounting it, provide that water doesn't get into the shaver body.

。

Trimmer - Clean the trimmer after every use.

- Switch the shower off.

- Press the 1/immer lack (8) cleaned. - Clean the 1/immer with the brush (11) supplied.

with the unit.

- Every till hotels lubricate the thinner left a drop of oil for sewing machines or hair diapers.

Replacement of shaving heads (pci. B, W) For the best shaving results replace the shaving

heads every 2 years.

Replacement of shaving heads is performed as described in chapter «Cleaning of shaving heads».

- Switch the shower off.

- Press the release button (A) and remove the sharing block (Q1).

- Tum the Name Clamp counterlockwise and

- Remove the frame. - Replace the shaving heads, install the lock-

ing frame, press the frame clamp and turn it.

clockwise. • Install the shaving block (Z) on the shaver.

Mode: After replacement of the shavingships they

ting of rotating blades to the nets will take sometime.

ENVIRONMENTAL PROTECTION

The shaver is provided with a disposable battery. Before you throw away the inoperative shaver dis-

charge the battery completely, remove it and dispose

or it according to the hazardous waste disposal regulations of your country.

Do not throw away the shower until you remove the

built-in battery.

DELIVERY SET

Mert diszielen – 1 pc. Power adaptor – 1 pc.

Protection cap - 1 pc. Pouch - 1 pc.

Cleaning brush – 1 pc.

TECHNICAL SPECIFICATIONS

Charger Power supply: 100-240 V \~ 50/60 Hz

Power output of the net adapter: 2V 930dB

Shamor Pruzet University, J.M.

1. 2017.10.24

The manufacturer preserves the right to charge the specifications of the unit without a complexity

the application of the main clinical & primary, acquisition.

Unit operating ITe is 2 years

(四)本说明会的召开方式

Guarantea Details regarding guarantee conditions can be

-obtained from the dealer from whom the appliance

was purchased. The fall of sale or receipt must be reproduced when making any claim under the laws

of this guarantee.

This product catalysts in the EMC-Re

requirements an laid down by the Council

CE Directive 2004/108/SG and to the Low Compliance Regulation (2006/96/SG)

（一）本次股东大会的召集和召开程序

[Non-Text]

[Non-Text]