Drive 6S - Telephone Krüger&Matz - Free user manual and instructions

Product Type	Smartphone
Brand	Krüger&Matz
Model	Drive 6S
Ingress Protection Rating	IP68 (dustproof and water-resistant up to 1m for 30 minutes)
SIM Card	Dual Nano SIM (or 1 Nano SIM + microSD)
Memory Card Support	microSD (up to capacity not specified, but compatible)
Rear Camera(s)	13 MP + 0.3 MP
Front Camera	Yes (specification not detailed)
Fingerprint Scanner	Yes
Charging Port	USB Type-C
Headphone Jack	Yes (3.5mm)
Battery	Non-removable (specific capacity not provided)
Function Button	Assignable for Push-to-Talk or other functions
Camera Button	Yes (dedicated button for camera)
Operating System	Android (Google trademark)
Dimensions	Not specified (typical for rugged phone)
Weight	Not specified
Cleaning Instructions	Use soft dry cloth; avoid alcohol, thinner, benzene
Safety	Do not use while driving; switch off in aircraft and explosive areas; use approved accessories
Spare Parts and Repairability	Only qualified personnel should repair; warranty void if self-repaired
General Information	Manufacturer: Lechpol Electronics; Made in China; EU Declaration of Conformity at www.lechpol.eu

Frequently Asked Questions - Drive 6S Krüger&Matz

Is the Krüger&Matz Drive 6S waterproof?

The Drive 6S has an IP68 rating, meaning it is dustproof and can be submerged in up to 1 meter of water for 30 minutes. However, water resistance can decrease over time, and the warranty does not cover liquid damage. Ensure rubber plugs are closed when near water.

How do I insert the SIM and memory cards?

Use the provided ejector pin to open the card tray. Insert up to two Nano SIM cards or one Nano SIM and one microSD card with the chips facing upwards. Close the tray and rubber plug securely.

Can I use two SIM cards simultaneously?

Yes, the Drive 6S supports dual SIM in standby mode. Note that using two SIM cards may shorten standby time compared to single SIM usage.

What should I do if my phone overheats while charging?

Disconnect the charger, close any running apps, and wait for the device to cool down. Check the USB cable for damage. Use only original charging accessories to avoid overheating.

How do I clean the phone?

Use a soft, dry cloth to clean the phone, battery, and charger. Do not use alcohol, thinner, benzene, or other chemical agents, as they may damage the device.

Is the battery removable?

No, the battery is non-removable. Do not attempt to disassemble it. If the battery is out of use for a long period, ensure it is fully charged before reuse.

Does the phone have a fingerprint scanner?

Yes, the Drive 6S is equipped with a fingerprint scanner for secure unlocking and authentication.

What type of charging port does it have?

The phone uses a USB Type-C port for charging and data transfer.

What cameras does the Drive 6S have?

It features a 13 MP and a 0.3 MP rear camera, plus a front camera for selfies. A dedicated camera button allows quick photo capture.

Where can I find the user manual?

The user manual is available for download at www.krugermatz.com and other support pages. You can also request a translated version via email from the product page.

USER MANUAL Drive 6S Krüger&Matz

All the information in this manual are in accordance with the technical condition at the time of printing.

Producer reserves the rights to errors and misprints.

IMPORTANT: Water and dust protection rating is not permanent, and can decrease over time, as a result of everyday usage of the device. Despite the IP68 rating and strengthened casing, the device is not resistant to damages in certain situations. The warranty does not cover mechanical nor liquid damages.

Uwaga

INSTALACE SIM KARTY/PAMĚTOVÉ KARTY

1. Headphone jack
2. USB type-C port (charging)
3. Proximity sensor, light sensor
4. Speaker
5. Front camera
6. Rear camera (13 Mpx)
7. Rear camera (0,3 Mpx)
8. Fingerprint scanner
9. Volume control button
10. Power button
11. Microphone
12. Flash
13. SIM/SD card tray
14. Camera button
15. Function button
16. Receiver

GETTING STARTED

STEP 1: To eject the card tray, open the rubber plug, insert card tray pin into card tray hole and push lightly until the card tray pops up.

STEP 2: Retrieve the card tray and insert the nano SIM card and nano SIM card OR nano SIM card and microSD card as indicated (with the chip/pins facing upwards).

STEP 3: Close the card tray and the rubber plug.

SIM CARD/MEMORY CARD INSTALLATION

• Power off the mobile phone and disconnect it from charger before unmounting SIM cards.
• Before removing memory card, make sure it has been disconnected first!
  • Exercise caution when operating SIM card/memory card, as friction or bending may damage the card.
• Keep the mobile phone and its fittings such as the SIM cards/memory cards beyond children's reach.
• If the memory card cannot be read, please check whether it is has been inserted correctly.
• Producer does not guarantee compatibility with every memory card.
• Please note: Dual SIM in standby will shorten the standby time compared to single SIM.
• Make sure the battery is fully charged if it has been out of use for a long period. NOTE: The battery is not detachable. Do not attempt to disassemble the battery.

INGRESS PROTECTION RATING

This product is water-resistant and dustproof based on IP68 rating, which tests submersion up to 1 meter for up to 30 minutes.

Note: Despite this classification, your device is not impervious to water damage in any situation. Ensure the earphone and USB rubber plugs are perfectly closed while using near water, or in a humid environment, to ensure the phone remains waterproof and dust proof.

Maintenance after removing from water:

1. After removing from water, do not uncover the phone body until it is completely wiped dry by towels or tissue papers.
2. Carefully dry away water drops from the phone's speaker, earpiece and microphone after the entire phone has been removed from water, and then place to dry in open air. Do not use electric hair driers to dry the phone.

NOTE: Do not expose the device to salt water or ionized water. If the device is dropped or receives an impact, the water and dust resistant features of the device may be damaged.

IMPORTANT: Water and dust protection rating is not permanent, and can decrease over time, as a result of everyday usage of the device. Despite the IP68 rating and strengthened casing, the device is not resistant to damages in certain situations. The warranty does not cover mechanical nor liquid damages.

CHARGING

Charge the smartphone using the provided USB cable. Connect the cable to USB type-C port on the device. Other end of the cable plug into provided charger or compatible USB port.

• Make sure the phone is fully charged before turning it on for the first time.
- Use only original charging devices and batteries approved by the producer. Using other accessories may damage the device.

Overheating

While charging, the temperature of the device and the charger may get increased. This does not affect the device's lifespan or performance and is in the device's normal range of operation.

However, if there is an excessive increase in temperature or overheating, depending on the factor that caused it: device's performance may be significantly reduced, charging process may be stopped, the device may turn off or display notification about switching off for cooling. Function available only in selected models. Important: if the device displays notification about overheat, turn it off and do not turn it back on until completely cooled down!

In case of overheat during charging:

1. Disconnect the charger from the device.
2. Close any running apps.
3. Wait for the device to cool down, and then begin charging the device again. If the part of the device where the USB port is placed overheats, check for damage to the connected USB cable. Replace the damaged USB cable with a new authorized cable.

The device may also overheat during operation when using several battery consuming applications or functions. In case of overheat during usage:

1. Close any running apps.
2. Disconnect any connectivity (Bluetooth, Wi-Fi, data transfer etc.).
3. Lower the screen brightness settings.
4. Wait for the device to cool down before attempting to use it again.

E

Safety precautions concerning operation environment

In order to maintain battery's longevity, and to avoid overheat, follow basic precautions including provisions listed below:

1. Do not use / store the device in very hot or cold environments nor expose to direct sunlight (e.g. on a car's dashboard when using as a navigation).
2. Do not place the device on surfaces that may cause overheat e.g. electric heating mat.
3. Do not place near sources of heat e.g. radiators, microwave ovens, hot kitchen appliances nor high pressure containers.
4. DO NOT use damaged charger or battery!
5. Use only authorized chargers, batteries and cables! Using unauthorized accessories may damage the device or battery. Connecting charger with inadequate parameters may result with damage to the device and poses risk to the user.

TURN ON

Turn on: Press and hold the power button until the screen goes on.

Turn off: Press and hold the power button for about 2 seconds, then choose appropriate (Power off).

LANGUAGE

Once the phone is ON you can personalize it to your needs. To change language go to Main Menu, open Settings, go to Language and input, enter Language and select appropriate.

FUNCTION KEYS

Power button: Press and hold Power key to open the power key menu, where you can turn off the phone (Power off) or Restart.

Volume button: Press the volume keys to change the ring volume (on the home screen) or the earpiece volume (during a call).

Function button: can be as ascribed to Push-To-Talk function with pre-installed Zello app or to a desired function (with an third party application).

Camera button: when in camera mode, press to take a picture/start or stop recording a video.

Overview button: Press the button to display recently used apps menu.

Home button: Press Home to return to the home screen. Press and hold the button to open Google Assistant™ function.

Back button: Goes back to previous screen or closes keyboard (if open).

SAFETY ALERT AND CAUTIONS

Road safety comes first: Do not use a hand-held phone while driving. Use hands-free fittings when calls are unavoidable while driving. In some countries, dialing or receiving calls while driving is illegal!

Switch off in aircraft: Wireless devices can cause interference in aircraft. Please make sure that your mobile phone is powered off (or switch to flight mode) in flight.

Switch off before entering risky areas: Strictly observe the relevant laws, codes, and regulations on the use of mobile phones in risky areas. Turn off your mobile phone before entering a place susceptible to explosion, such as an oil station, oil tank, chemical plant or a place where a blasting process is under way.

Observe all special regulations: Follow any special regulations in force in any area such as hospitals and always switch off your phone whenever it is forbidden to use it or, when it may cause interference or danger. Properly use your mobile phone near medical apparatuses, such as pacemakers, hearing aids and some other electronic medical devices, as it may cause interference to such apparatuses.

Interference: The conversation quality of any mobile phone may be affected by radio interference. An antenna is built inside the mobile phone and located below the microphone. Do not touch the antenna area during a conversation, as the conversation quality may deteriorate.

Qualified service: Only qualified personnel may install or repair phone equipment. Installing or repairing the mobile phone on your own may bring great danger and violates the warranty rules.

Accessories and batteries: Use only approved accessories and batteries.

Use sensibly: Use only in a normal and proper manner, and only as indicated in this

instruction manual.

Emergency calls: Ensure the phone is switched on and in service, enter the emergency number, e.g. 112, then press the Dial key. Give your location and state your situation briefly. Do not end the call until told to do so.

Note: Similarly to other mobile phones, this device may not support every function described in this manual due to network settings or radio broadcast operator. Some networks may not support 112 emergency calls too. Therefore, you should not rely only on mobile phones in critical situations. In case of any doubts, it is advised to contact local operator.

CLEANING AND MAINTENANCE

• Please don't leave the phone, the battery, and the charger in the bathroom and other high humidity places, and prevent them from rain.
• Please clean the phone, the battery, and the charger using soft and dry cloth.
• Please don't wipe the phone using alcohol, thinner, or benzene and other chemical agents.

LEARN MORE

For more information on this device visit: www.krugermatz.com. | Read owner's manual carefully before using your smartphone. | Visit www.krugermatz.com website for more products and accessories. | In case of any doubts or questions reach out to our Frequently Asked Questions section.

Please note: illustrations and descriptions concerning operating system are for reference only, and may vary from actual software on your device!

IMPORTANT: The producer allows the possibility for minor variations in display brightness and color between individual devices. There may be visible light or dark spots on the display. Up to 5 defective pixels are acceptable to be present on the display of the device. Above mentioned cases concerning device's display are not covered under warranty nor statutory warranty rights.

Google and Android are trademark of Google LLC;

Lechpol Electronics Sp. z o.o. Sp.k. hereby declares that smartphone KM0481 | KM0482 is consistent with directive 2014/53/UE. Full text of the EU Declaration of Conformity is available at following Internet address: www.lechpol.eu.

English

Correct Disposal of This Product (Waste Electrical & Electronic Equipment)

(Applicable in the European Union and other European countries with separate collection systems) This marking shown on the product or its literature, indicates that it should not be disposed with other household wastes at the end of its working life. To prevent possible harm to the environment or human health from uncontrolled waste disposal, please separate this from other types of wastes and recycle it responsibly to promote the sustainable reuse of material resources. Household users should contact either the retailer where they purchased this product, or their local government office, for details of where and how they can take this item for environmentally safe recycling. Business users should contact their supplier and check the terms and conditions of the purchase contract. This product should not be mixed with other commercial wastes for disposal.

Made in China for LECHPOL ELECTRONICS Sp. z o.o. Sp.k., ul. Garwolińska 1, 08-400 Miętne.

A TERMÉK LEIRÁSA

SIM KÁRTYA/MEMÓRIA KÁRTYA TELEPITÉS

INSTALACJA KARTY SIM/KARTY PAMIĘCI

STOPIÉN OCHRONY (IP)

1. lesire casti
2. Port USB type C (încărcare)
3. Senzor de proximitate, senzor de lumina
4. Difuzor
5. Camera foto frontala
6. Camera foto spate (13 Mpx)
7. Camera foto spate (0,3 Mpx)
8. Cititor de amprenta digitala
9. Buton volum
10. Buton pornire
11. Microfon
12. Blit
13. Suport pentru card SIM / SD
14. Buton cameră
15. Buton Functie
16. Receptor

PORNIREA DISPOZITIVULUI

INSTALAREA CARTELEI SIM/ CARDULUI DE MEMORIE

INŠTALÁCIA SIM KARTY/PAMÄŤOVEJ KARTY

www.krugermatz.com

Krüger&Matz is a registered trademark