SC-HS60002 - Styler Scarlett - Free user manual and instructions

Product Type	Hair Styler
Brand	Scarlett
Model	SC-HS60002
Power Supply	220-240 V, 50-60 Hz
Power Consumption	Approx. 50 W
Plate Material	Ceramic
Plate Type	Interchangeable: straightening and big crimping plates
Heat Settings	Single heat level (max. temperature approx. 200°C)
Heating Time	Few minutes (approximately 2-3 minutes)
Continuous Use Limit	15-20 minutes
Auto Shut-Off	No
Indicator Light	Yes (pilot light)
Cord Type	Swivel cord (cord protection swivel)
Cord Length	Approx. 1.8 m
Dimensions (approx.)	Length: 30 cm, Width: 3 cm, Height: 5 cm
Weight (approx.)	350 g
Safety Features	Do not use near water; unplug after use; RCD recommended for bathroom circuits
Included Attachments	Straightening plates, big crimping plates
Cleaning	Wipe with damp cloth; do not use abrasive cleaners
Storage	Cool, dry place; do not wrap cord around appliance

Frequently Asked Questions - SC-HS60002 Scarlett

What is the Scarlett SC-HS60002 styler used for?

The SC-HS60002 is a hair styler that can straighten or wave hair using interchangeable straightening plates and big crimping plates.

Can I use the styler on wet hair?

No, the device should only be used on dry clean hair or towel-dried hair. Using it on wet hair can damage the device and cause injury.

How do I change the plates?

Press the plate release button on the handle and pull the plate upwards to remove. To attach, align the new plate and press until it clicks into position.

How long does it take to heat up?

The heater takes approximately 2-3 minutes to reach operating temperature. The pilot light indicates when it is ready.

What is the maximum continuous usage time?

Do not use the appliance for longer than 15-20 minutes continuously to avoid overheating.

Is the styler safe to use in the bathroom?

It can be used in a bathroom but must be unplugged after each use. Keep away from water; never immerse. Install an RCD for extra safety.

How do I clean the styler?

Allow the device to cool completely, then wipe the plates and body with a damp cloth. Do not use abrasive cleaners or immerse in water.

Why does the indicator light stay on?

The pilot light stays on while the device is switched on and heating. It does not turn off automatically; switch off the appliance after use.

What should I do if the power cord is damaged?

Do not use the appliance. The cord must be replaced by the manufacturer or an authorized service center to avoid hazard.

Can I use the styler on extensions or wigs?

The manual does not specify, but it is designed for natural hair. For synthetic hair, use at your own risk; test on a small strand first.

USER MANUAL SC-HS60002 Scarlett

Product image of a SCARLETT Ceramic Beauty Pro tool with teal and white body (no text or symbols visible on the device itself)

www.scarlett.ru

GB DESCRIPTION

1. Body
2. Pilot light
3. On/Off switch
4. Plate release button
5. Straightening plate
6. Big crimping plate
7. Cord protection swivel

UA ОПИС

GB INSTRUCTION MANUAL IMPORTANT SAFEGUARDS

• Please read this instruction manual carefully before use and keep in a safe place for future reference.
• Before the first connecting of the appliance check that voltage indicated on the rating label corresponds to the mains voltage in your home.
• For home use only. Do not use for industrial purposes. Do not use the appliance for any other purposes than described in this instruction manual.
• Do not use outdoors.
  • Always unplug the appliance from the power supply before cleaning and when not in use.
• To prevent risk of electric shock and fire, do not immerse the appliance in water or any other liquids. If it has happened DO NOT TOUCH the appliance, unplug it immediately and check in a service center.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliances by a person responsible for their safety.
• If the appliance is used in a bathroom, it should always be unplugged after use, because nearness of water is dangerous even if the appliance is switched off.
• For additional protection, the installation of a residual current device (RCD) having a rated residual operating current not exceeding 30 mA is advisable in the electrical circuit supplying the bathroom. Ask your installer for advice.
• Children should be supervised to ensure that they do not play with the appliance.
• Do not leave the appliance switched on when you do not use it.
• Do not use other attachments than those supplied.
• If the power cord is damaged it should be replaced by the manufacturer or authorized servicing center or qualified professional for safety reasons.
• Do not attempt to repair, adjust or replace parts in the appliance. Repair the malfunctioning appliance in the nearest service center.
• To protect against the risk of burn, do not touch detachable plates.
• Keep the cord away from sharp edges and hot surfaces.
• If the product has been exposed to temperatures below 0°C for some time it should be kept at room temperature for at least 2 hours before turning it on.
• The manufacturer reserves the right to introduce minor changes into the product

design without prior notice, unless such changes influence significantly the product safety, performance, and functions.

CAUTION:

• Be careful, the device becomes very hot during operation.
• The device is to be used only on dry clean hair or towel-dried hair.

ATTENTION! Do not use the device de the bathrooms, swimming pools and r vessels containing water.

- Production date mentioned on the unit and/or on the packing materials and documentations.

USAGE RECOMMENDATIONS

• Wash the hair before setting it. For achieving the best result thoroughly wash the hair after using hair conditioner. Dry the hair with a towel.
• It is recommended to use a detangler before operating the device.
• Do not manipulate the same strand of hair for too long.
• When setting your hair manipulate hair strands evenly.

INSTRUCTION FOR USE

• Fully unwind the cord.
• Attach the plate to the appliance and press until it clicks into proper position.
• To remove the plate, press the plate release button, then pull upwards to remove it from the attachment place.
• Insert the plug into the power supply.
• Switch on the appliance; the indicator light should light up. Allow the appliance to heat a few minutes.
• Divide hair into locks.
• To straighten hair, place it between straightening plates and pull straightly 2-4 times.
• To curl hair, place it between plates and keep pressed for 2-3 seconds.
• The set includes:

- STRAIGHTENING PLATES: allows to straighten curly hair;

— BIG CRIMPING PLATES: for wavy style;

• Do not comb hair just after curling, wait until it cools down.
• When finished, switch off and unplug the appliance from power supply.
• NOTE! Do not use the appliance longer than 15-20 minutes continuously.

CARE AND CLEANING

• Before cleaning switch off the appliance, unplug it from the power supply and let it cool completely.
• Do not use abrasive cleaners.

STORAGE

- Make sure the hair crimper is completely cool and dry.

• Do not wrap the cord around the appliance, as this may cause damage.
• Keep the appliance in a cool, dry place.

• The symbol on the unit, packing materials and/or documentations means used electrical and electronic units and battery's should not be toss in the garbage with ordinary household garbage. These units should be pass to special receiving point.
• For additional information about actual system of the garbage collection address to the local authority.
• Valid utilization will help to save valuable resources and avoid negative work on the public health and environment which happens with incorrect using garbage.