Beli 035160130 - Lamp Lucide - Free user manual and instructions

Brand	Lucide
Model	Beli 035160130
Product type	Lamp
Use	Indoor use only
Supply voltage	220-240 V~
Frequency	50/60 Hz
Electrical class	I (with protective conductor)
Protection rating	IP20
Bulb type	According to the socket indicated on the product
Maximum bulb wattage	See marking on the product
Minimum distance to flammable materials	Observe the value indicated on the product
Warning	Do not use outdoors or in damp environments unless IP rating is suitable
Installation	By a qualified electrician, power off
Maintenance	Clean dry (dry cloth), no water or flammable products
Replacing the bulb	Disconnect power and let cool down
Warranty	2 years from the date of purchase
Warranty exclusions	Glass parts (14 days), normal wear, external damage
Important symbols	Crossed-out wheelie bin (recycling), IP20, safety distance, class I
Model number	035160130

Frequently Asked Questions - Beli 035160130 Lucide

How to install the Beli 035160130 lamp?

Installation should be carried out by a qualified electrician. Cut the power before starting. Follow the instructions in the manual and observe safety distances from flammable materials. Connect the wires according to the color code: phase (L), neutral (N) and ground (green-yellow) for class I.

Can I use this lamp in a bathroom?

This lamp is designed for indoor use only. Its IP20 rating does not protect against moisture. It is not suitable for the bathroom unless you choose a model with an appropriate IP rating.

What bulb should I use?

Use a bulb of the type and maximum wattage indicated on the product. Check the socket (E27, E14, etc.) and the wattage. Never exceed the specified maximum wattage.

How to clean the lamp?

Clean it with a dry, soft cloth. Never use water, solvents, or flammable products. Make sure the lamp is switched off and cooled down before cleaning.

What to do if the glass of the lamp is broken?

If the protective glass is damaged, replace it immediately. The warranty covers broken glass parts only within 14 days of purchase. Contact your dealer or the manufacturer.

Does the lamp heat up?

Yes, the lamp and bulb can become very hot during operation. Let it cool down before touching. Observe the minimum safety distance from flammable objects.

How to replace the bulb?

Turn off the power supply. Let the bulb cool down. Remove the used bulb and replace it with a new bulb of the same type and with a wattage less than or equal to the maximum indicated wattage.

What to do in case of failure or malfunction?

First check the power supply and the bulb. If the problem persists, contact a qualified electrician. For a warranty claim, keep the purchase receipt and contact your dealer.

What is the duration of the warranty?

The Lucide warranty is 2 years from the date of purchase by the end user, covering material and workmanship defects. Broken glass parts are only warranted for 14 days. Normal wear and external damage are excluded.

Can I repair the lamp myself?

It is not recommended to repair the lamp yourself. Any intervention must be carried out by a qualified electrician. If the external cable is damaged, replacement must be done by the manufacturer or an approved professional.

USER MANUAL Beli 035160130 Lucide

Thank you for purchasing a Lucide original!

This manual will hopefully guide you easily through the installation process. We aim to inspire and illuminate our clients by offering trendy, high-quality and affordable lighting.

Welcome to the community of #illuminatesyourworld

DISCOVER OUR COLLECTION!

Visit our website and discover our entire collection

CURIOUS ABOUT OUR BRAND?

Our brand video gives you a glimpse behind the scenes at Lucide

ILLUMINATESYOURWORLD

Take a look at how others around the world use Lucide products

L U ĉ i D E

Close-up of a perforated lampshade with a glowing light source, no text or symbols visible.

Item number: 03516/01/30

EAN code: 5411212030832

BELI

Close-up of a single incandescent light bulb with filament, shown against a plain white background (no text or symbols)

RECOMMENDED LUCIDE LIGHT SOURCE

49020/05/60

Dimmable: Yes

Included: No

General

Dimensions LxW xH: 12cm x 12cm x 30cm

Main material: Metal

Color: Black

Style: Modern

Shape: Cylinder

Weight: 0,85kg

Warranty: 2 Years

Specifications

Dimmable: No

Light direction: Around (Diffuse)

Adjustable in height: Not In Height Adjustable

Directional: Not Directional

Cable: Yes, Cable With Plug On Product

Cable length: 150 cm

Sensor: Without Sensor

Control: On/Off Switch - In The Cord

Power supply: Adapter/Power Grid

IP-Class: 20

Electric Class: 2

Number of light sources: 1

Lamp socket: E27

Wattage: 1 x 60W

Power requirements: 220-240V\~50Hz

BELI

Item number: 03516/01/30

EAN code: 5411212030832

12 cm 30 cm

BELI

Item number: 03516/01/30

EAN code: 5411212030832

Diagram showing a light bulb being placed on a cylindrical container with a wire and plug, labeled with step number 1.

IP20 0.5m

IP20 0.5m

Please read this notice carefully and keep it during the lifetime of this product. Follow the instructions for a safe and correct installation and functioning of the light fixture. The manufacturer does not accept any responsibility for damage caused by improper installation and service. Installation should always be done by a qualified electrician.

Always isolate the power before commencing installation, maintenance or repair.

In case of doubts, please contact a qualified electrician.

Please pay attention to locations where the item can be installed (indoor, outdoor, bathroom (for outdoor and bathroom installation, please see further). Indoor items cannot be used in humid places. Do not put the item in contact with water or any liquids or inflammable products. Always respect the minimal distance (indicated on the light) to inflammable products.

During installation, make sure that the cables will not be squeezed or damaged by sharp edges. If the external flexible cable is damaged, it needs to be replaced exclusively by the manufacturer, his service agent, or a qualified electrician.

This is to avoid all risks.

Because the temperature of the item and the bulbs can get very high, they must cool down before being touched. Always use the correct bulb (respect type and maximal wattage as indicated on the product).

Explanation of the symbols which can appear on the fixture

Vertical sequence of icons and labels, including house, circuit, water level, square, diamond, IP20, email, and light bulb with 0.5m scale indicator.

This item is only suitable for indoor use, exclusive bathroom

(except if a higher IP degree permits that the item can be used in the bathroom).

Legislation requires that all electrical and electronic equipment must be collected for reuse and recycling. Electrical and electronic equipment marked with this symbol indicating separate collection of such equipment must be returned to a municipal waste collection point.

Class I: The item has an earth connection. The earth wire (green-yellow) needs to be connected to the earth connection (marked with this symbol).

Class II: The item is double insulated and must not be connected to the earth wire.

Class III: The item is only suitable for lower voltage supply and must not be connected to the earth wire.

IP 20: Protection against contact with a finger

If the protection glass is damaged or broken, it needs to be replaced immediately.

Please respect the minimum distance from the bulb to inflammable objects.

Sicherheitshinweise

Vertical sequence of icons and labels, including house, grid, water level, square, IP20 symbol, and light bulb with 0.5m scale indicator.

Vertical sequence of icons and labels including house, circuit, water level, square, IP20 symbol, and directional arrows with distance annotation

Warranty declaration:

Lucide NV warrants that the products supplied will be free from defects in material and workmanship for a period of

2 years from the date of purchase by the end user, if the item is installed and maintained properly as mentioned in the user manual.

Exclusions for the warranty:

1. Broken glass parts of the fixture will only be replaced within 14 days after purchasing by the end user.

2. Normal wear and tear, discoloring as a result from normal use.

3. Damage caused by external causes like fire, water, wrong use/installation or maintenance of the product.

For warranty claims the customer needs to hand over defective fixture/part and the original purchase ticket.

Garantieverklaring:

Further explanations can be found on our website.

LUCiDE

ILLUMINATES YOUR WORLD

LUCIDE NV

LUCIDE NV BISSCHOPPENHOFLAAN 145, 2100 DEURNE, BELGIUM

info@ lucide.com tel: [phone]

www.lucide.com