Inicio FV1220 - Iron TEFAL - Free user manual and instructions

USER MANUAL Inicio FV1220 TEFAL

9. EN Self-cleaning (once a month) / ES Auto-limpieza

1800130466 FV12XX X0_110x154 TF 30/05/13 09:50 Page15IMPORTANT SAFETY INSTRUCTIONS Read all instructions before using the iron. When using your iron, basic safety precautions should always be followed, including the following:

1. Use iron only for its intended use.

2. To protect against a risk of electric shock, do not immerse the iron in water or other liquids.

3. Always turn the iron OFF before plugging or unplugging the iron from the electrical outlet. Never pull

on the cord to disconnect the iron from the electrical outlet; instead, grasp the plug and pull on the plug to disconnect the iron.

4. Do not allow cord to touch hot surfaces. Let iron cool completely before putting away. Loop cord loo-

sely around iron when storing.

5. Always disconnect iron from electrical outlet when filling with water or emptying and when not in use.

6. Do not operate iron with a damaged cord or if the iron has been dropped or damaged. To avoid the risk

of electric shock, do not disassemble the iron. Contact our Consumer Service Department for examination, repair or adjustment. Incorrect reassembly can cause a risk of electric shock when the iron is used.

7. Close supervision is necessary for any appliance being used by or near children. Do not leave iron unat-

tended while connected or on an ironing board.

8. Burns can occur from touching hot metal parts, hot water or steam. Use caution when you turn a steam

iron upside down - there may be hot water in the reservoir.

9. This appliance is only for domestic and personal use.

SPECIAL INSTRUCTIONS

1. To avoid a circuit overload, do not operate another high-wattage appliance on the same circuit.

2. If an extension cord is absolutely necessary, a 15 amp. cord should be used. Cords rated for less amper

may overheat. Care should be taken to arrange the cord so that it cannot be pulled or tripped over.

SAVE THESE INSTRUCTIONS

For your safety PLEASE READ THESE INSTRUCTIONS CAREFULLY AND KEEP THEM FOR FUTURE REFERENCE. This appliance complies with the technical rules and standards for safety currently in force (Electroma- gnetic Compatibility, Low Voltage, Environnement).

• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or ins- truction concerning use of the appliance by a person responsible for their safety. Children must be su- pervised to ensure that they do not play with the appliance.

During the first few uses, a harmless odour and a small amount of smoke may be given off. This has no effect on the use of the iron and will disappear quickly.

• Warning ! The voltage of your electrical installation must correspond to that of the iron (120V or 127 V). Connecting to the wrong voltage may cause irreversible damage to the iron and will invalidate the guarantee.

• If it is absolutely essential to use an extension cable, choose a 15 amp one.

• If the electrical cord becomes damaged, it must be immediately replaced by an Approved Service Cen- tre to avoid any danger.

• The appliance should not be used if it has fallen, if it has obvious damage, if it leaks or functions incor- rectly. Never dismantle your appliance : have it inspected by an Approved Service Centre, so as to avoid any danger.

• Never immerse your iron in water !

• Do not unplug your appliance by pulling on the cord. Always unplug your appliance: before filling or rin- sing the water tank, before cleaning it, after each use. 1800130466 FV12XX X0_110x154 TF 30/05/13 09:50 Page1617

• Never leave the appliance unattended when it is connected to a power source or if it has not cooled down for approximately 1 hour.

• Your appliance gives off steam, which may cause burns. Take extra care especially when you are iro- ning close to the edge or on a corner of your ironing board. Never direct the steam towards people or animals.

• Your iron should be used and placed on a flat, stable, heat-resistant surface. When you put your iron onto its iron rest, make sure that the surface on which you put it is stable.

• This product has been designed for domestic use only. Any commercial use, inappropriate use or fai- lure to comply with the instructions, the manufacturer accepts no responsibility and the guarantee will not apply.

• The auto-stop light will be lit during normal use! What water to use? Your appliance has been designed to function with untreated tap water. However, it is necessary to operate the Self-Clean function regularly in order to eliminate hard water deposits from the steam chamber. If your water is very hard (check with your local water authority), it is possible to mix untreated tap water with store-bought distilled or demineralised water in the following proportions : - 50% un- treated tap water, - 50% distilled or demineralised water. Types of water not to use? Heat concentrates the elements contained in water during evaporation.The types of water listed below contain organic waste or mineral elements that can cause spitting, brown staining, or pre- mature wear of the appliance : water from clothes dryers, scented or softened water, water from re- frigerators, batteries or air conditioners, pure distilled or demineralised water or rain water should not be used in your iron. Also do not use boiled, filtered or bottled water. Environment Environment protection first ! i Your appliance contains valuable materials which can be recovered or recycled. ‹ Leave it at a local civic waste collection point.

1800130466 FV12XX X0_110x154 TF 30/05/13 09:50 Page17If you have any problem or queries, please contact our Customer Relations team first for expert help and advice.

PROBLEM POSSIBLE CAUSE

SOLUTION Water drips from theholes in the soleplate.The iron drips when you start ironing.The chosen temperature is too low and does not allow for the ormation of steam. ou are using steam while the ironis not hot enough.You are using the Shot of Steambutton too often.There is too much steam.You have stored the iron horizon-tally, without emptying it andwithout setting it to You have removed the anti-scalerod to fill your iron.Position the thermostat in the steam range(from •• to MAX).Wait until the thermostat light goes out.Wait a few seconds between each use of thebutton.Reduce the steam.See the section "Storing your iron".Do not extract the anticalc valve when fillingthe iron.Brown streaks comethrough the holes in thesoleplate and stain thelinen.You are using chemical descalingagents.You are not using the right type ofwater.Fabric fibres have accumulated inthe holes of the soleplate and areburning.Your linen has not been rinsed sufficiently or you have ironed anew garment before washing it.Do not add any descaling agents to the waterin the water tank.Perform a self-cleaning operation and consultthe chapter "What water should I use?".Perform the self-cleaning operation and cleanthe soleplate with a damp sponge. Vacuumthe holes of the soleplate from time to time.Make sure that your laundry is rinsed sufficiently so as to remove any deposits ofsoap or chemical products on new clothes.The soleplate is dirty orbrown and can stain thelinen.Your are ironing with an inappro-priate program (temperature toohigh).You are using starch.Clean the soleplate as indicated above. Selectthe appropriate program.Clean the soleplate as indicated above.Always spray starch onto the reverse side ofthe fabric to be ironed.There is little or nosteam. The water tank is empty.The anti-calc valve is dirty.Your iron has a build-up of scale.Your iron has been used dry for toolong.Fill it.Clean the anti-calc valve.Clean the anti-calc valve and carry out a self-clean.Carry out a self-clean.The soleplate is scrat-ched or damaged.You have placed your iron flat on ametallic rest-plate or ironed over a zip. Always set your iron on its heel.Do not iron over zips.Steam or water comefrom the iron as youfinish filling the tank.The steam control is not set to theposition.The water tank is overfilled.Check that the steam control is set to the position.Never exceed the Max level.The spray does notspray. The water tank is not filled enough. Fill up the water tank. If there is a problem? 1800130466 FV12XX X0_110x154 TF 30/05/13 09:50 Page18RECOMENDACIONES IMPORTANTES Lea todas las instrucciones antes de utilizar su aparato. Cuando utilice su plancha respete las siguientes instrucciones de seguridad: