RTG 74 SQF - Cooker ROSIERES - Free user manual and instructions

USER MANUAL RTG 74 SQF ROSIERES

1.2. Suitable Location

2. Electrical Connection (For U.K. Only)

2.1. Electrical Connection

2.2. Gas Connection (For U.K. Only)

4. Maintenance and Cleaning

QC / R / SR / A S67 / HBGPX

Cet appareil a été dessiné pour un usage non professionnel, usage domestique uniquement1. INSTRUCTIONS FOR THE INSTALLER The hob may be installed in any worktop which is heat resistant to a

temperature of 100°C, and has a thickness of 25-45 mm. The

dimensions of the insert to be cut out of the worktop are in shown in

If the Hob is fitted next to a cabinet

on either side, the distance

between the Hob and the cabinet must be at least 15 cm (see Figure

4); while the distance between the hob and the rear wall must be at

The distance between the hob and any other unit or appliance above it

extractor hood) must be no less than 70 cm (Figure 4).

When there is an accessible space between the built-in hob and the

cavity below, a dividing wall made of insulating material should be

inserted (wood or a similar material) (Figure 3).

Important - The diagram in figure 1 shows how

The Hob unit is fitted by attaching the Fixing Clamps supplied, using

the holes at the base of the unit.

If a hob of 60 cm is fitted above an oven which is not equipped with fan

cooling system it is recommended that openings are created

the built in furniture to ensure correct air circulation.

The size of these openings must be at least 300 cm2 and placed as

When a 75 cm hob is fitted over a built in oven, the latter must be fan

2. ELECTRICAL CONNECTION (FOR U.K. ONLY)

Warning - this appliance must be earthed

This appliance is designed for domestic use only. Connection to the

main supply must be made by a competant electrician, ensuring that

all current regulations concerning such installations are observed.

The appliance must only be connected to a suitably rated spur point, a

13 amp plug/socket is not suitable. A double pole switch must be

provided and the circuit must have appropriate fuse protection.

Further details of the power requirement of the individual product will

be found in the users’ instruction and on the appliance rating plate. In

the case of built-in product

you are advised, should you wish to use a

longer cable than the one supplied, that a suitably rated heat resistant

The wiring must be connected to the mains supply as follows:

CONNECT TO SPUR TERMINAL Green & Yellow Wire Earth Connection

Blue Wire Neutral Connection

Note: We do not advocate the use of earth leakage devices with

electric cooking appliances installed to spur points because of the

«nuisance tripping» which may occur. You are again reminded that the

appliance must be correctly earthed, the manufacturer declines any

responsibility for any event occurring as a result

of incorrect electrical

07 GB - IE INSTALLING A DOMESTIC APPLIANCE CAN BE A COMPLICATED OPERATION WHICH IF NOT CARRIED OUT CORRECTLY, CAN SERIOUSLY AFFECT CONSUMER SAFETY. IT IS FOR THIS REASON THAT THE TASK SHOULD BE UNDERTAKEN BY A PROFESSIONALLY QUALIFIED PERSON WHO WILL CARRY IT OUT IN ACCORDANCE WITH THE TECHNICAL REGULATIONS IN FORCE. IN THE EVENT THAT THIS ADVICE IS IGNORED AND THE INSTALLATION IS CARRIED OUT BY AN UNQUALIFIED PERSON, THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR ANY TECHNICAL FAILURE OF THE PRODUCT WHETHER OR NOT IT RESULTS IN DAMAGE TO GOODS OR INJURY TO INDIVIDUALS.

1.2. SUITABLE LOCATION This appliance must be installed in accordance with applicable

regulations and should only be used in well-ventilated locations.

Before using this appliance carefully study the instruction book.

2.1. ELECTRICAL CONNECTION Check the data on the rating plate, located on the outside of the unit, to

ensure that the supply and input voltage are suitable.

Before connection, check the earthing system.

By Law, this appliance must be earthed. If this regulation is not

complied with, the Manufacturer will not be responsible for any

damage caused to persons or property. If a plug is not already

attached, fit a plug appropriate to the load indicated on the rating plate.

The earth wire is coloured yellow/green. The plug should always be

Where the Hob is connected direct to the electricity supply, a circuit

If the power supply cord is damaged this is to be replaced by a

qualified engineer so as to prevent any potential risk.

The earth wire ( green and yellow coloured ) must be at least 10 mm

longer than the live and neutral wires.

The section of the cable

used must be of the correct size in relation to

the absorbed power of the hob.

Please check rating plate for the power details and ensure that the

power supply cord is of the type H05RR-F, H05VV-F, H05V2V2-F.

LIVE EARTH NEUTRAL L N Power Cable

2.2. GAS CONNECTION These instructions are for qualified personnel, installation of

equipment must be in line with the relevant national standard. (For

U.K. only: by law the gas installation\commissioning must be

carried out by a "Gas Safe" installer)

All work must be carried out with the electricity supply disconnected.

The rating plate on the

hob shows the type of gas with which it is

designed to be used. Connection to the mains gas supply or gas

cylinder should be carried out after having checked that it is regulated

for the type of gas with which it will be supplied. If it is not correctly

see the instructions in the following paragraphs to change

For liquid gas (cylinder gas) use pressure regulators which comply

with the relevant national standards.

Use only pipes,washers and sealing washers which comply with the

relevant national standards.

To prevent any potential damage to the hob please carry out the

following this sequence (picture 6):

For some models a conic link is furnished to outfit for the installation in

the countries where this type of link is obligatory; in picture 8 it is

pointed out how to recognize the different types of links (CY =

cylindrical, CO = conic). In every

case the cylindrical part of the link

has to be connected to the hob.

When connecting the hob to the gas supply via use offlexible hoses

please ensure that the maximum distance covered by the hose does

not exceed 2 metres.2.3. ADAPTING THE HOB TO DIFFERENT TYPES OF GAS To adapt the Hob for use with different types of gas, carry out the

following instructions:

•remove the grids and burners

•insert on hexagonal spanner (7 mm) into the burner support (Figure

•Unscrew the injector and replace it with one suitable for the gas to be

used (see gas type table)

1)As illustrated, assemble parts in sequence:

A: 1/2 Male Adaptor Cylindirical

Cylindirical-Cylindirical

2)Tighten the joints with the spanner, remembering to twist the

pipes into position.

3)Attach fitting C to mains gas supply using rigid copper pipe or

flexible steel pipe.

IMPORTANT: carry out a final check for leaks on the pipe

connections using a soapy solution. NEVER USE A FLAME. Also,

make sure that the flexible pipe cannot come into contact with a

moving part of the cabinet (eg.adrawer) and that it is not situated

where it could be damaged.

If gas can be smelt in the vicinity of this appliance turn off the gas

supply to the appliance and call the engineer directly. Do not search for a

leak with a naked flame.

2.4. REGULATING THE MINIMUM FLAME After lighting the burners, turn the control knob to the minimum setting

and then remove the knob (this can easily be removed by applying

Using a small «Terminal» type screwdriver the regulating screw can

be adjusted as in Figure 9. Turning the screw clockwise reduces the

turning it anticlockwise increases the flow – Use this

adjustment to obtain a flame of approximately 3 to 4 mm in length and

then replace the control knob.

When the gas supply available is LPG - the screw to set the idle flame

must be turned (clockwise) to the end stop.

you have carried out the new gas regulation, replace the old gas

rating plate on your appliance with one (supplied with hob) suitable for

the type of gas for which it has been regulated.

3. USE OF HOB - USER INSTRUCTIONS This appliance must only be used for the purpose for which it is

intended, domestic cooking, and any other use will be considered

improper and could therefore be dangerous. The Manufacturer will

not be responsible for any damage or loss resulting from improper

This appliance is not intended for use

by persons (including children)

with reduced physical, sensory or mental capabilities, or lack of

experience and knowledge, unless they have been given supervision

or instruction concerning use of the appliance by a person responsible

Children should be supervised to ensure that they do not play with the

3.1. USING THE GAS BURNER To ignite the burners, place a lighted taper close to the burner, press in

and turn the control knob anti-clockwise.

If the burners have not been used for a couple of days, wait for a few

seconds before lighting the burner, this will allow any air present in the

For appliances fitted with electronic ignition carry out the following:

• push in and turn the knob anticlockwise to the ignition symbol.

• ignite the burner by pressing the sparker button.

For hobs fitted with automatic ignition simply push in and turn the knob

to the ignition symbol.

The ignition system will

continue to generate sparks as long as the

control knob is being pressed.

If the burner has not ignited within 5 seconds, turn the knob to the 0

position and repeat the operation.

For models fitted with a safety tap (which cuts-off the flow of gas if the

flame is accidentally extinguished)

the burners are ignited and

described above, but care must be taken.

Prior to switching on the gas hob ensure that the burners and burner

caps are correctly placed within their position.

GENERAL ADVISE For best results, use cooking vessels with a flat surface. The size of

the surface should match

the gas burner side as follows. Table A.

08 GB - IE For smaller containers the gas burner should be regulated so that the

flame does not overlap the base of the pan. Vessels with a concave or

convex base should not be used.

WARNING: If a flame is accidentally extinguished, turn the knob

to the off position and do not attempt to

re-ignite if for at least 1

If over the years the gas taps become stiff to turn it is necessary to

Such operation must be carried out only by qualified Service

Table A4. MAINTENANCE AND CLEANING Before cleaning the hob, ensure the appliance has cooled down.

Remove the plug from the socket or (if connected directly) switch off

the electricity supply.

Never use abrasives, corrosive detergents, bleaching agents or

acids. Avoid any acid or alkaline substances (lemon, juice, vinegar

When cleaning the enamelled, varnished or chrome sections, use

warm soapy water or a non caustic detergent. For stainless steel use

an appropriate cleaning solution.

The burners can be cleaned with soapy water. To restore their original

shine, use a household stainless steel cleaner. After cleaning, dry the

It is important the Burners are replaced correctly.

Chromed grids and burners

"WARNING” - Do not use a steam cleaner to clean the hob.

Chromed grids and burners have a tendency to discolour with use.

This does not jeopardize the functionality of the hob.

Our After Sales Service Centre can provide

spare parts if required.

5. AFTERCARE Before calling out a Service Engineer please check the following:

• that the plug is correctly inserted and fused;

• that the gas supply is not faulty.

If the fault cannot be detected:

Switch off the appliance and call the After Service Centre. DO NOT TAMPER WITH THE APPLIANCE.

This appliance is marked according to the European

directive 2002/96/EC on Waste Electrical and

Electronic Equipment (WEEE).

By ensuring this product is disposed of correctly, you

will help prevent potential negative consequences for

the environment and human health, which could

otherwise be caused by inappropriate waste handling

on the product indicates that this product may not be

treated as household waste. Instead it shall be handed over to the

applicable collection point for the recycling of electrical and electronic

Disposal must be carried out in accordance with local environmental

regulations for waste disposal.

For more detailed information

about treatment, recovery and recycling

of this product, please contact your local city office, your household

waste disposal service or the shop where you purchased the product.

6. PROTECTION OF THE ENVIRONMENT

09 GB - IE This appliance has been designed for non-professional, i.e. domestic, use.

BUILT IN HOBS Type / reference

Flame failure device

Installed Gas Type / Power:

QC / R / SR / AUX S67 / HBGPX

The Manufacturer will not be responsible for any inaccuracy resulting from

printing or transcript errors contained in this brochure. We reserve the right

to carry out modifications to products as required, including the interests of

consumption, without prejiudice to the characteristics relating to safety or

Declaration of compliance: This equipment, in the parts intended to

come into contact with food, complies with the regulations laid down in

EEC directives 89/109.

Appliance complies with European Directives 73/23/EEC

and 89/336/EEC, replaced by 2006/95/EC and

2004/108/EC, and subsequent amendments.1. ИНСТРУКЦИИ ПО ВЫПОЛНЕНИЮ УСТАНОВКИ Варочная поверхность может устанавливаться на любой рабочей поверхности кухонного стола, которая выдерживает нагрев до

QC/UR AUX SR R QC AUX SR R QC / UR AUX SR RR

CY, CZ, GB, GR, IE, IT, PT, SI, ES, CH, TR P (Kw)

15GB - IE The manufacturer will not be responsible for any inaccuracy resulting from printing or transcript errors contained in this brochure. We reserve the right

to carry out modifications to products as required, including the interests of con sumption, without prejudice to the characteri stics relating to safety or