CD-BT1MKII - Portable CD recorder TASCAM - Free user manual and instructions

USER MANUAL CD-BT1MKII TASCAM

TEAC Professional Division

CD-BT1MKII

Portable CD Bass Trainer

PORTABLE CD BASS TRAINER CD-BT1MKII TASCAM TIME/ESC PREV UP NEXT DOWN PULL LOOP I/O TUNER TMP/KEY EQ EFFECT S TROP C D F F OUT OUT ▶/II ▶/II CUE ▶/II ▶/II ▶/II ▶/II ▶/II ▶/II ▶/II ▶/II

This appliance has a serial number located on the rear panel. Please record the model number and serial number and retain them for your records.

Model number ____ Serial number ____

OWNER'S MANUAL (EN / F / D / I / E)

CAUTION

RISK OF ELECTRIC SHOCK DO NOT OPEN

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

The lightning flash with arrowhead symbol, within an equilateral trinagle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

FOR U.S.A.

TO THE USER

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following countermeasures.

a) Reorient or relocate the receiving antenna
b) Increase the separation between the equipment and receiver.
c) Connect the equipment into an outlet on a circuit other from that to which the receiver is connected.
d) Consult the dealer or an experienced radio/TV technician for help.

CAUTION

Changes or modifications to this equipment not expressly approved by TEAC CORPORATION for compliance could void the user's authority to operate this equipment.

1 Read these instructions.
2 Keep these instructions.
3 Heed all warnings.
4 Follow all instructions.
5 Do not use this apparatus near water.
6 Clean only with dry cloth.
7 Do not block any ventilation openings. Install in accordance with the manufacturer's instructions.
8 Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
9 Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.
10 Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.
11 Only use attachments/accessories specified by the manufacturer.
12 Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.

Symbolic icon of a person using a large tool inside a circle (no text or symbols)

13 Unplug this apparatus during lightning storms or when unused for long periods of time.
14 Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.

• Do not expose this apparatus to drips or splashes.
• Do not place any objects filled with liquids, such as vases, on the apparatus.
• Do not install this apparatus in a confined space such as a book case or similar unit.
• The apparatus draws nominal non-operating power from the AC outlet with its POWER switch in the off position.

Safety Information

This product has been designed and manufactured according to FDA regulations "title 21, CFR, chapter1, subchapter J, based on the Radiation Control for Health and Safety Act of 1968", and is classified as a class 1 laser product. There is no hazardous invisible laser radiation during operation because invisible laser radiation emitted inside of this product is completely confined in the protective housings. The label required in this regulation is shown here.

CAUTION

• DO NOT REMOVE THE PROTECTIVE HOUSING USING A SCREWDRIVER.
• USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE.
• IF THIS PRODUCT DEVELOPS TROUBLE, CONTACT YOUR NEAREST QUALIFIED SERVICE PERSONNEL, AND DO NOT USE THE PRODUCT IN ITS DAMAGED STATE.

Optical pickup: Type KSM-900AAA Manufacturer: SONY CORPORATION Laser output: <1 mW play on the objective lens Wavelength: 775—816 nm

CERTIFICATION THIS PRODUCT COMPLIES WITH DHHS RULES 21 CFR SUBCHAPTER J APPLIC- CABLE AT DATE OF MANUFACTURE. TEAC CORPORATION 3-7-3, NAKA-CHO, MUSASHINO-SHI, TOKYO, JAPAN MANUFACTURED : DTA CLASS 1 LASER PRODUCT LUOKAN 1 LASERLAITE KLASS 1 LASERAPPARAT CERTIFICATION THIS PRODUCT COMPLIES WITH DHHS RULES 21 CFR SUBCHAPTER J APPLIC- CABLE AT DATE OF MANUFACTURE. TEAC CORPORATION 3-7-3, NAKA-CHO, MUSASHINO-SHI, TOKYO, JAPAN MANUFACTURED : DTA SUB 1 LASER PRODUCT LEASER LEAVES LEASER APPARAT

CONSIGNES DE SÉCURITÉ IMPORTANTES

Symbolic icon of a person pushing a large object through a circular frame, with no text or symbols present.

Illustration of hands pressing a circular object with an upward arrow, no text or symbols present

Line drawing of a hand holding a CD or DVD disc with a pointed tip (no text or symbols)

Four-panel diagram showing a heart-shaped object with cross marks, each containing a small circle and an X symbol.

Simple line drawing of a battery pack with electrodes and a switch (no text or symbols)

AVERTISSEMENT

13) Touches Track Skip/Search

Saut de plage:

FINDERS LINE OUT OUTVENT HUNT LINE R BAS 16 FOUNT headphones 3.2 3.2 3.2

graph LR
    EQ --> EFFECT
    EQ --> EDIT
    EFFECT --> EDIT

graph LR
    EQ --> EFFECT
    EQ --> EDIT
    EFFECT --> EDIT

BIBLIOTHEQUE D'EFFETS

1	DLY
2	FLA-DLY
3	CHO-DLY
4	WAH-DLY
c1	COMPL-COMPH
c2	COMPL-COMPH-DLY
c3	COMPL-COMPH-FLA-DLY
c4	COMPL-COMPH-CHO-DLY
c5	COMPL-COMPH-WAH-DLY
c6	COMPL-COMPH-OCT-DLY
c7	COMPL-COMPH-TECH-DLY
d1	DIST-HCUT
d2	DIST-HCUT-DLY
d3	DIST-HCUT-FLA-DLY
d4	DIST-HCUT-CHO-DLY
d5	DIST-HCUT-WAH-DLY

graph LR
    EQ --> EFFECT
    EQ --> EDIT
    EFFECT --> EDIT

5 Marlin House, Croxley Business Park Watford Hertfordshire WD18 8TE UNITED KINGDOM

[phone]

www.tascam.co.uk

TEAC EUROPE GmbH