LC-2330 - Heating ZIBRO - Free user manual and instructions
Find the device manual for free LC-2330 ZIBRO in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Brand | ZIBRO |
| Model | LC-2330 |
| Category | Heating |
| Product type | Electric fan heater |
| Power supply | 220-240 V ~ 50/60 Hz |
| Maximum power | 2000 W |
| Recommended heating area | Up to 20 m² |
| Power levels | 2 (1000 W / 2000 W) |
| Adjustable thermostat | Yes, with integrated dial |
| Timer | No (depending on model) |
| Dimensions (L × H × D) | Approximately 45 × 25 × 20 cm |
| Weight | 2.5 kg |
| Material | Flame-retardant ABS plastic |
| Color | White / gray |
| Overheat protection | Yes, automatic shut-off |
| Tip-over protection | Yes, safety switch |
| Protection rating | IP21 (protection against water droplets) |
| Noise level | ≈ 45 dB |
| Installation type | Mobile device on a stable stand |
| Maintenance | Clean the grilles with a soft cloth |
| Cleaning | Unplug and allow to cool before cleaning |
| Spare parts | Available on request (thermostat, switch) |
| Repairability | Repairability index: 8/10 |
| Warranty | 2 years |
| General information | Complies with CE and RoHS standards |
Frequently Asked Questions - LC-2330 ZIBRO
How do I turn on the LC-2330 fan heater?
Plug the device into a 220-240 V outlet, then turn the thermostat dial clockwise to the maximum position. Finally, select the desired power level (1000 W or 2000 W) with the dedicated button. The device immediately starts blowing hot air.
How do I set the desired temperature?
Use the thermostat dial to set the desired temperature. Turn it toward the plus symbol to increase, and toward the minus symbol to decrease. The heater stops automatically when the room reaches the chosen temperature.
What should I do if the device suddenly turns off?
The automatic shut-off is a safety measure in case of overheating. Unplug the device, allow it to cool for 15 minutes, and check that the ventilation grilles are not obstructed. If the problem persists, contact after-sales service.
How do I clean the LC-2330?
Before any cleaning, unplug the device and allow it to cool. Use a soft, dry cloth to clean the exterior surface and the air outlet grilles. Never use water or abrasive products.
Can this device be used in a bathroom?
Yes, the IP21 protection rating allows use in a wet room, but at least one meter away from the bathtub or shower. Never install it near a water source.
Does the device make noise?
The noise level is approximately 45 dB, which is equivalent to a quiet conversation. It is therefore silent for domestic use, even at night.
What happens if the heater falls over?
The LC-2330 is equipped with a tip-over switch that immediately cuts off the power supply in case of a fall. You can then pick it up and turn it back on normally.
What is the power and recommended area?
This heater offers two levels: 1000 W and 2000 W. It is suitable for heating a room up to 20 m². Choose the power according to the room size and your needs.
How do I replace a spare part such as the thermostat?
For safety reasons, the replacement of the thermostat must be carried out by a qualified professional. Spare parts are available from the manufacturer. Contact ZIBRO customer service to obtain the appropriate part.
Where can I consult the full manual online?
The full manual for the LC-2330 is available for free download in PDF format on notice-facile.com. You can also view it directly on the page in the built-in viewer.
User questions about LC-2330 ZIBRO
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Heating in PDF format for free! Find your manual LC-2330 - ZIBRO and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. LC-2330 by ZIBRO.