JS6504 - Loudspeaker JENSEN - Free user manual and instructions
Find the device manual for free JS6504 JENSEN in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Type | Bookshelf loudspeaker |
| Configuration | 2-way bass-reflex |
| Woofer | 5.25" (13.3 cm) cone driver |
| Tweeter | 1" (25 mm) dome tweeter |
| Power Handling (RMS) | 60 W |
| Peak Power | 120 W |
| Impedance | 8 ohms |
| Frequency Response | 50 Hz – 20 kHz |
| Sensitivity | 90 dB (2.83 V/1 m) |
| Recommended Amplifier Power | 20 – 100 W per channel |
| Dimensions (W x H x D) | 200 x 320 x 230 mm |
| Weight | 3.4 kg per speaker |
| Enclosure Material | MDF with vinyl finish |
| Finish | Black wood-grain texture |
| Grille | Removable cloth grille |
| Connectors | Gold-plated binding posts |
| Placement | Bookshelf, stand or wall-mount |
| Cleaning | Wipe with a soft, dry cloth |
| Safety | Keep away from moisture and heat sources |
| Repairability | Drivers can be replaced; internal wiring accessible |
Frequently Asked Questions - JS6504 JENSEN
How do I connect the Jensen JS6504 speakers to my amplifier?
Use speaker wire. Strip 12-15 mm of insulation, unscrew the binding posts, insert the wire, and tighten. Ensure correct polarity (+ to +, - to -).
What cable gauge should I use?
For lengths up to 5 m, use 16 AWG; for longer runs, 14 AWG or thicker is recommended for minimal signal loss.
Can I place the speakers on any surface?
Bookshelf speakers work best on sturdy stands or shelves at ear height. Avoid direct contact with walls; keep at least 15 cm from rear and side walls for optimal bass.
How do I clean the speaker grille?
Remove the grille and gently vacuum using a soft brush attachment, or wipe with a microfibre cloth. For stains, use a mild upholstery cleaner sparingly.
What is the maximum power I can feed these speakers?
The RMS rating is 60 W, but they can handle 120 W peaks. Use an amplifier delivering 20-100 W per channel; don't exceed this to avoid distortion or damage.
Do I need a subwoofer?
The 5.25" woofer provides reasonable bass down to 50 Hz for music. For deep home-theater effects, adding a powered subwoofer enhances low frequencies below 50 Hz.
Can I use these speakers with a TV?
Yes, connect them to an AV receiver or amplifier with a TV audio output. Ensure the receiver is compatible with 8-ohm speakers.
How should I break in new speakers?
Play them at moderate volume for 20-30 hours with varied music. This settles the suspension and allows the drivers to reach their full potential.
Why do my speakers distort at low volume?
Check if your amplifier is clipping due to inferior input. Or the source may have low-quality recording. Also verify proper wire connection to avoid partial shorts.
Are these speakers magnetically shielded?
No, they are not shielded. Keep them at least 30 cm away from CRT televisions and magnetic media to avoid interference.
User questions about JS6504 JENSEN
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Loudspeaker in PDF format for free! Find your manual JS6504 - JENSEN and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. JS6504 by JENSEN.
USER MANUAL JS6504 JENSEN
Manual assistant
Powered by Anthropic
Waiting for your message
Product information
Brand : JENSEN
Model : JS6504
Category : Loudspeaker