COINTRA

TND Plus 150 - Water heater COINTRA - Free user manual and instructions

Find the device manual for free TND Plus 150 COINTRA in PDF.

📄 24 pages English EN Download 💬 AI Question 10 questions ⚙️ Specs
Notice COINTRA TND Plus 150 - page 1
Pick your language and provide your email: we'll send you a specifically translated version.
Product type Gas instantaneous water heater (tankless)
Brand Cointra
Model TND Plus 150
Mounting Wall-mounted
Energy source Natural gas (G20) or LPG (G30/G31) – convertible
Nominal heat input 25 kW (approx.)
Hot water flow rate at ΔT=25°C 15 L/min
Hot water flow rate at ΔT=35°C 10.7 L/min
Minimum water pressure 0.2 bar
Maximum water pressure 10 bar
Gas connection 1/2" BSP male
Water connection 1/2" BSP male
Ignition Electronic automatic
Power supply for ignition 1.5 V AA battery
Gas pressure (NG) 20 mbar
Gas pressure (LPG) 37 mbar
Safety features Flame failure device, overheating protection, anti-freeze protection
Dimensions (H × W × D) 700 × 400 × 250 mm
Net weight 16 kg
Degree of protection IPX4 (splash-proof)
Maintenance Periodic descaling and filter cleaning recommended

Frequently Asked Questions - TND Plus 150 COINTRA

What is the Cointra TND Plus 150?
The Cointra TND Plus 150 is a gas instantaneous water heater (tankless). It heats water on demand with a flow rate of up to 15 liters per minute at a temperature rise of 25°C, making it suitable for multiple outlets simultaneously.
Can the TND Plus 150 run on bottled gas?
Yes, the appliance is factory set for natural gas but can be converted to LPG (propane/butane). Conversion requires changing the injectors and adjusting the gas pressure regulator. Please refer to the instructions or contact a qualified technician.
Why does the heater take a long time to produce hot water?
The TND Plus 150 is an instantaneous heater, so it only heats water when a tap is opened. If you feel a delay, it is due to the time needed for the water to travel through the pipes. The heater itself ignites within 2-3 seconds. Check that the hot water pipe length is not excessive or idle.
How often should I descale the water heater?
In areas with hard water, descaling should be done at least once a year. You can use a descaling solution compatible with the materials. The water filter at the inlet should be cleaned every 3 months to prevent limescale and debris buildup.
What temperature should I set?
For domestic use and to prevent scalding, a temperature of around 55-60°C is recommended. This also reduces limescale accumulation. The TND Plus 150 has a control knob allowing you to adjust the outlet temperature between about 35°C and 65°C.
Can the heater be installed outdoors?
The TND Plus 150 is approved for indoor installation only. Although it has an IPX4 rating (splash-proof), it does not have sufficient weather protection for outdoor installation. Always install it in a well-ventilated room.
What should I do if the heater fails to ignite?
First, check that the gas valve is open and the battery is charged. Turn off the heater and remove the battery, then reinsert it correctly. Ensure the water flow reaches the minimum required (about 2.5 L/min). If the problem persists, the flame detection thermocouple may need cleaning or replacement.
Is it safe to use the heater in the bathroom?
No, the heater is not suitable for installation in bathrooms, bedrooms, or rooms with high humidity unless it is fully room-sealed. Local building codes usually require a minimum distance from water splashes. Always follow the installation instructions.
How do I clean the water filter?
Locate the inlet water filter (usually at the bottom of the unit opposite the water connections). Turn off the water supply and gas, unscrew the filter cap, remove the mesh filter, and rinse it under running water. Reinstall and check for leaks.
Why does the water temperature fluctuate?
Fluctuation can occur if there are rapid changes in water pressure or if the gas supply is unstable. The TND Plus 150 is not thermostatic; it modulates the flame to maintain a set output, but if multiple taps are used, the temperature may vary. To reduce fluctuation, ensure the cold water inlet pressure is constant and not too low.

User questions about TND Plus 150 COINTRA

0 question about this device. Answer the ones you know or ask your own.

Ask a new question about this device

The email remains private: it is only used to notify you if someone responds to your question.

No questions yet. Be the first to ask one.

Download the instructions for your Water heater in PDF format for free! Find your manual TND Plus 150 - COINTRA and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. TND Plus 150 by COINTRA.

USER MANUAL TND Plus 150 COINTRA

Manual assistant
Powered by Anthropic
Waiting for your message
Product information

Brand : COINTRA

Model : TND Plus 150

Category : Water heater