DLG2351W - Tumble dryer LG - Free user manual and instructions
Find the device manual for free DLG2351W LG in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Type | Electric Vented Tumble Dryer |
| Model | DLG2351W |
| Brand | LG |
| Cavity Depth (inches) | 25.5 |
| Cavity Height (inches) | 36 |
| Cavity Width (inches) | 27 |
| Weight (lbs) | 110 |
| Voltage | 240 V |
| Amperage | 30 A |
| Drying Capacity (cu. ft.) | 7.4 |
| Cycles | Sensor Dry, Timed Dry, Quick Dry, Delicates, Heavy Duty, Wrinkle Care |
| Features | Moisture Sensor, Reversible Door, End-of-Cycle Signal, Child Lock, Wrinkle Prevent |
| Lint Filter | Removable, clean after each load |
| Exhaust | 4-way venting (rear, left, right, bottom) |
| Spare Parts Available | Lint filter, belt, drum roller, heating element, thermostat |
| Repair Index | 8.2/10 (user rated) |
| Safety Features | Automatic shutoff, thermal fuse, door switch |
Frequently Asked Questions - DLG2351W LG
How do I clean the lint filter on my LG DLG2351W?
Open the door and pull the lint filter out from the bottom of the door opening. Remove lint by hand or with a soft brush, then rinse with water if needed. Dry thoroughly before reinserting.
What does the 'Sensor Dry' cycle do?
The Sensor Dry cycle uses moisture sensors to automatically stop drying when clothes are dry, preventing over-drying and saving energy.
Can I install this dryer in a closet?
Yes, but adequate ventilation is required. The room must have a vent to the outside and clearance of at least 1 inch on sides, 2 inches behind, and 4 inches above the dryer.
How do I change the door swing direction?
The door is reversible. Remove the door hinge screws, rotate the door 180°, and reattach on the opposite side. Refer to the manual for detailed steps.
Why does my dryer take too long to dry clothes?
Possible causes: clogged lint filter, blocked exhaust vent, overloaded drum, or low heat setting. Check and clean filter and vent, reduce load size, and select higher heat.
What do error codes like 'dE' or 'tE' mean?
dE indicates a door not properly closed; tE is a thermistor error. Try closing the door firmly or restarting the cycle. If persists, contact LG support.
How do I use the Wrinkle Prevent option?
Select the Wrinkle Prevent option before starting a cycle. The dryer will tumble without heat for up to 2 hours after drying to prevent wrinkles.
What is the maximum load size?
Do not exceed 7.4 cubic feet. A typical load is about 4-5 pairs of jeans or a full set of king-size bed sheets. Overloading reduces drying efficiency.
How do I reset the dryer after a power outage?
Unplug the dryer or turn off the circuit breaker for 1 minute, then plug back in. Open and close the door, then select a new cycle.
Where can I find replacement parts for the DLG2351W?
Authorized LG parts distributors, online retailers like Amazon or repairclinic.com, or directly from LG. Common parts: lint filter (ADQ72910201), belt (4986ER2009B), heating element (EGO 6617).
User questions about DLG2351W LG
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Tumble dryer in PDF format for free! Find your manual DLG2351W - LG and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. DLG2351W by LG.