OKC624SH - Range hood Hansa - Free user manual and instructions
Find the device manual for free OKC624SH Hansa in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | Range Hood |
| Brand | Hansa |
| Model | OKC624SH |
| Width | 60 cm |
| Depth | 50 cm |
| Height | 128 cm (with chimney) |
| Weight | 12 kg |
| Power Supply | 230 V ~ 50 Hz |
| Rated Power | 200 W |
| Motor Power | 150 W |
| Lighting | 2 x 40 W halogen or LED (depending on version) |
| Extraction Rate | 650 m³/h (max) |
| Noise Level | 65 dB (max speed) |
| Number of Speeds | 3 |
| Controls | Slider or push-button |
| Grease Filter | Aluminum mesh, washable |
| Charcoal Filter | Optional for recirculation mode |
| Installation Type | Wall-mounted, ducted or recirculating |
| Duct Diameter | 150 mm |
| Energy Efficiency Class | A (typical) |
| Annual Energy Consumption | 60 kWh/year (typical) |
| Warranty | 2 years (depending on region) |
Frequently Asked Questions - OKC624SH Hansa
How do I install the Hansa OKC624SH range hood?
Installation should be done by a qualified professional. Ensure the distance between the hob and the hood is at least 65 cm for electric hobs and 75 cm for gas hobs. Use the provided template to mark drill holes and secure the hood with screws. Connect the ductwork if using extraction mode, or install charcoal filters for recirculation.
How often should I clean the grease filter?
The grease filter should be cleaned every 2-3 months depending on usage. Remove the aluminum mesh filter, wash it by hand with warm soapy water or in a dishwasher (low temperature). Ensure it is completely dry before reinstalling.
Can I use the hood without a duct?
Yes, the OKC624SH can be used in recirculation mode with a charcoal filter. The charcoal filter captures odors and is typically replaced every 3-6 months. Note that recirculation is less effective than ducted extraction.
What do I do if the hood is not extracting properly?
First, check if the grease filter is clogged and clean it if necessary. Ensure the duct is not blocked or kinked. For recirculation mode, replace the charcoal filter. Also verify that the speed setting is adequate.
Why is the hood making a loud noise?
Common causes include loose parts, unbalanced fan, or obstruction in the duct. Check that the hood is securely mounted and the filters are properly installed. If noise persists, contact Hansa customer service.
How do I replace the light bulbs?
Disconnect the hood from power. Depending on the model, the bulbs may be accessible from below or behind the control panel. Unscrew the old bulb and replace with a new one of the same type (typically 40W halogen or equivalent LED).
Where can I find the user manual?
The user manual for Hansa OKC624SH is available for free download on notice-facile.com in PDF format. You can also request a translated version via the website.
Is the OKC624SH suitable for an island kitchen?
No, this model is a wall-mounted hood and is designed to be installed against a wall. For island installation, consider a ceiling-mounted or downdraft hood.
How do I enable recirculation mode?
To use recirculation, you must install charcoal filters (ordered separately) inside the hood. Remove the grease filter, place the charcoal filter in the designated slot, and reinstall the grease filter. No ductwork is needed.
What should I do if the remote control (if applicable) stops working?
First, replace the batteries in the remote. If the hood has a reset button, press it. Alternatively, use the manual controls. If the problem persists, the receiver might be faulty; contact Hansa support.
User questions about OKC624SH Hansa
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Range hood in PDF format for free! Find your manual OKC624SH - Hansa and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. OKC624SH by Hansa.