SVTE50A2 - Water heaters and boilers SVAN - Free user manual and instructions
Find the device manual for free SVTE50A2 SVAN in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Brand | SVAN |
| Model | SVTE50A2 |
| Product Type | Electric Storage Water Heater and Boiler |
| Capacity | 50 L |
| Power Rating | 2000 W |
| Voltage | 230 V ~ 50 Hz |
| Dimensions (W x D x H) | 45 x 45 x 80 cm |
| Weight (empty) | 18 kg |
| Energy Efficiency Class | C |
| Heating Time (ΔT 45°C) | ~ 110 min |
| Maximum Temperature | 75°C |
| Thermostat | Adjustable, with safety cutoff |
| Safety Valve | Pressure relief valve (8 bar) |
| Material | Enameled steel tank |
| Insulation | Polyurethane foam, 50 mm |
| Standby Heat Loss | < 1.5 kWh/24h |
| Anode Protection | Magnesium anode, replaceable |
| Installation | Vertical, wall-mounted |
| Water Connection | G 1/2" inlet and outlet |
| IP Rating | IP24 (splash-proof) |
| Maintenance | Descale every 6 months; check anode annually |
| Warranty | 2 years |
Frequently Asked Questions - SVTE50A2 SVAN
How do I install the SVTE50A2 water heater?
Installation must be done by a qualified professional. Ensure the wall can support the filled weight (approx. 70 kg). Connect to cold water supply with a pressure reducing valve if mains pressure exceeds 6 bar. Electrical connection must comply with local regulations and include an earth connection.
What is the recommended temperature setting?
For optimal energy efficiency and to prevent scalding, set the thermostat between 55°C and 65°C. Higher temperatures increase scaling and energy consumption. For daily use, 60°C is a good balance.
How often should I descale the water heater?
Descaling every 6 to 12 months is recommended, depending on water hardness. Use a descaling solution suitable for enameled tanks. Follow the instructions in the manual to avoid damaging the heating element.
Why is water not heating properly?
Possible causes: thermostat set too low, faulty heating element, or tripped safety cutoff. Check the circuit breaker and thermostat setting. If the element is burnt, replace it. If water is lukewarm, the thermostat may need adjustment.
How do I replace the magnesium anode?
Turn off power and water supply. Drain the tank. Unscrew the old anode (usually located on top or side). Install a new anode of the same type. Apply thread sealant and tighten. Refill and check for leaks. Replace every 2-5 years depending on water quality.
What safety features does the SVTE50A2 have?
It includes a temperature safety cut-off (stops heating if water exceeds 95°C), a pressure relief valve (opens if pressure > 8 bar), and a thermal fuse. The tank is double-walled with insulation to prevent burns.
Can I use the SVTE50A2 with solar pre-heated water?
Yes, but the inlet water temperature should not exceed 70°C. Check that the thermostat and safety devices are compatible. Consult a professional to ensure proper integration with your solar system.
What does the error code flashing mean?
Refer to the manual for specific codes. Common indications: rapid flashing (thermistor fault), slow flashing (overheating), constant light (normal operation). If unclear, reset the device by turning power off for 10 seconds.
How can I reduce energy consumption?
Lower the thermostat to 55°C, insulate hot water pipes, use a timer to heat only during off-peak hours, and fix any dripping taps. The SVTE50A2 has good insulation, but avoid heat loss by keeping the tank in a heated space.
Is the SVTE50A2 suitable for hard water areas?
Yes, but scale buildup will be faster. Install a water softener if hardness exceeds 200 mg/L. Regularly check and descale the heating element. The magnesium anode will also deplete faster; monitor it yearly.
User questions about SVTE50A2 SVAN
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Water heaters and boilers in PDF format for free! Find your manual SVTE50A2 - SVAN and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. SVTE50A2 by SVAN.
USER MANUAL SVTE50A2 SVAN
Manual assistant
Powered by Anthropic
Waiting for your message
Product information
Brand : SVAN
Model : SVTE50A2
Category : Water heaters and boilers