HD100-D357BU1 - Tumble dryer HAIER - Free user manual and instructions
Find the device manual for free HD100-D357BU1 HAIER in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | Heat Pump Tumble Dryer |
| Capacity | 10 kg |
| Dimensions (H x W x D) | 850 x 596 x 600 mm |
| Net Weight | 48 kg |
| Energy Efficiency Class | A+++ |
| Annual Energy Consumption | 237 kWh |
| Noise Level | 66 dB(A) |
| Drying Programs | Cotton, Synthetics, Delicates, Wool, Shirts, Sports, Quick 30 min, Bed & Towel, etc. |
| Sensor Drying | Yes, with multiple dryness levels |
| Delayed Start | Up to 24 hours |
| Anti-Crease Function | Yes, up to 120 min |
| Heat Pump Self-Cleaning | Yes |
| Lint Filter Indicator | Yes |
| Water Tank Position | Top left drawer |
| Condenser Cleaning | Yes, accessible at front bottom |
| Child Lock | Yes |
| Display Type | LED with program status |
| Drum Material | Stainless steel |
| Power Supply | 220-240 V, 50 Hz |
| Rated Power | 1800 W |
| Door Hinge | Left, reversible |
Frequently Asked Questions - HD100-D357BU1 HAIER
How do I clean the lint filter?
Open the door and pull the lint filter out from the bottom of the door opening. Remove lint by hand or with a soft brush, then rinse under running water if necessary. Dry thoroughly and reinsert. Clean after each cycle for optimal performance.
What is the maximum load capacity?
The maximum load is 10 kg for cotton programs. For synthetics and delicates, reduce load to 4-5 kg. Overloading may cause poor drying results and increase energy consumption.
How to clean the condenser?
Turn off and unplug the dryer. Open the bottom front cover, pull out the condenser unit. Rinse with water (do not use detergent). Remove any fluff, then reinsert firmly. Clean at least every 2 months or when the indicator lights up.
Why is my dryer not starting?
Check that the door is fully closed and the child lock is not activated. Ensure the drum is not overloaded and the water tank is not full. Also verify the power cord is plugged in and the fuse is intact.
How to set a delayed start?
Select your drying program, then press the Delay Start button repeatedly to set the delay time (1-24 hours). Press Start/Pause to begin. The dryer will start at the set time. Cancel by turning the program dial to Off.
What does the anti-crease function do?
After the drying cycle ends, the drum rotates periodically for up to 120 minutes to prevent wrinkles. You can cancel it by opening the door or pressing any button. Useful if you cannot unload immediately.
Can I change the door hinge direction?
Yes, the door is reversible. Follow the instructions in the manual: remove the door, swap the hinge brackets, and reattach the door on the opposite side. Requires basic tools. Contact service if unsure.
How often should I empty the water tank?
Empty the water tank after each drying cycle. The Water Tank Full indicator will light up when it is full. Failure to empty may cause the dryer to stop. The tank holds approximately 4.5 liters.
What is the recommended installation clearance?
Allow at least 5 cm space on all sides for ventilation. If placing in a cupboard, ensure proper airflow. The dryer should be on a level, firm surface. Avoid direct sunlight or heat sources.
How to troubleshoot error codes?
Common codes: E1 (door open), E2 (water tank full), E3 (clogged lint filter). Refer to manual for full list. For persistent errors, reset by unplugging for 2 minutes. If problem persists, contact Haier service.
User questions about HD100-D357BU1 HAIER
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Tumble dryer in PDF format for free! Find your manual HD100-D357BU1 - HAIER and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. HD100-D357BU1 by HAIER.