Recon UI Board - Uncategorized SIMRAD - Free user manual and instructions
Find the device manual for free Recon UI Board SIMRAD in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | Interface Control Board |
| Brand | Simrad |
| Model | Recon UI Board |
| Category | Marine Electronics |
| Dimensions (L x W x H) | 150 x 100 x 25 mm |
| Weight | 200 g |
| Input Voltage | 10–30 V DC |
| Power Consumption | 5 W |
| Interface Protocol | NMEA 2000, CAN bus |
| Primary Function | User interface control for Simrad systems |
| Operating Temperature | -15°C to 55°C |
| Ingress Protection | IPX7 (waterproof up to 1m for 30 min) |
| Housing Material | ABS plastic |
| Mounting Type | Flush or surface mount |
| Connections | Multi-pin connector (included) |
| Compatible Software | Simrad OS |
| Warranty | 2 years |
| Cleaning Instructions | Wipe with a damp cloth; avoid solvents |
| Safety | Do not expose to extreme heat; disconnect power before cleaning |
| Spare Parts & Repairability | Contact Simrad support; board not user-serviceable |
Frequently Asked Questions - Recon UI Board SIMRAD
How do I install the Simrad Recon UI Board?
Mount the board using the provided bracket or flush mount kit. Connect the multi-pin cable to your Simrad display and power supply (10-30V DC). Secure with screws and ensure the seal is tight for waterproofing.
What is the power supply requirement?
The board requires 10–30 V DC input and consumes approximately 5 W. Use a circuit breaker rated at 1 A.
Is the Recon UI Board waterproof?
Yes, it has an IPX7 rating, meaning it can be submerged up to 1 meter for 30 minutes. Ensure the connector is properly sealed.
Which Simrad systems are compatible?
The board is compatible with Simrad NSS, NSO, and NSX series displays that support NMEA 2000 and CAN bus interface.
How do I connect the board to my Simrad display?
Use the supplied cable with a multi-pin connector. Plug one end into the board and the other into the display’s accessory port. Follow the display’s menu to configure the UI board.
What are the exact dimensions?
The board measures 150 mm x 100 mm x 25 mm (approx. 5.9 x 3.9 x 1.0 inches).
How much does it weigh?
The device weighs approximately 200 grams (0.44 lbs).
Can I mount the board outdoors?
Yes, the IPX7 rating allows outdoor mounting, but avoid direct prolonged sun exposure and ensure the cable entry is sealed.
Where can I download the user manual?
The manual is available for free on notice-facile.com in PDF format. You can also request a translated version via email.
What should I do if the board malfunctions?
First, check power and connections. If the issue persists, contact Simrad support for troubleshooting or warranty service. Do not attempt to open the board as it may void the warranty.
User questions about Recon UI Board SIMRAD
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Uncategorized in PDF format for free! Find your manual Recon UI Board - SIMRAD and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. Recon UI Board by SIMRAD.
USER MANUAL Recon UI Board SIMRAD
Manual assistant
Powered by Anthropic
Waiting for your message
Product information
Brand : SIMRAD
Model : Recon UI Board
Category : Uncategorized