2MR - Uncategorized ORTOFON - Free user manual and instructions
Find the device manual for free 2MR ORTOFON in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | Moving Magnet Phono Cartridge |
| Model | 2MR |
| Brand | Ortofon |
| Output Voltage | 5.5 mV (1 kHz, 5 cm/sec) |
| Channel Balance | < 1.5 dB |
| Channel Separation | > 22 dB (1 kHz) |
| Frequency Response | 20 Hz – 20,000 Hz ± 3 dB |
| Tracking Force Range | 1.6 – 2.0 g (recommended 1.8 g) |
| Stylus Type | Elliptical |
| Stylus Replacement | Ortofon 2MR Stylus |
| Cartridge Weight | 7.2 g |
| Dimensions (W x D x H) | 17.0 x 15.0 x 12.0 mm |
| Recommended Load Resistance | 47 kΩ |
| Recommended Load Capacitance | 150 – 200 pF |
| Mounting | Standard 1/2 inch (12.7 mm) spacing |
| Compliance | 20 µm/mN (dynamic, lateral) |
| Tracking Ability | 70 µm (at 1.8 g tracking force) |
| Care & Maintenance | Clean stylus gently with brush; avoid solvents |
| Included Accessories | Mounting hardware, stylus brush, screwdriver |
Frequently Asked Questions - 2MR ORTOFON
What is the recommended tracking force for the Ortofon 2MR cartridge?
The recommended tracking force is 1.8 g, within a range of 1.6 – 2.0 g.
How do I replace the stylus on the Ortofon 2MR?
To replace the stylus, gently pull the old stylus forward and off. Align the new Ortofon 2MR Stylus onto the cartridge body and push until it clicks into place.
What load impedance is required for the Ortofon 2MR?
The recommended load resistance is 47 kΩ and load capacitance between 150 – 200 pF.
Is the Ortofon 2MR compatible with any turntable?
The 2MR uses standard 1/2 inch mount and is compatible with most turntables that accept moving magnet cartridges. Verify tonearm effective mass for optimal performance.
What is the output voltage of the Ortofon 2MR?
The output voltage is 5.5 mV at 1 kHz, 5 cm/sec, which is typical for moving magnet cartridges.
How do I clean the Ortofon 2MR stylus?
Use the included brush to gently wipe the stylus from back to front. Avoid touching the stylus tip and never use solvents.
What is the weight of the Ortofon 2MR cartridge?
The cartridge weight is 7.2 g, and it includes mounting hardware.
Can I use the Ortofon 2MR with a 78 RPM record?
No, the 2MR is designed for 33 1/3 and 45 RPM vinyl records. For 78 RPM, use a dedicated stylus.
What type of stylus is used on the Ortofon 2MR?
It uses an elliptical stylus for improved tracking and reduced wear.
How do I align the Ortofon 2MR cartridge on my tonearm?
Use a protractor to align the cartridge so that the stylus tip is square to the groove. Adjust overhang and offset angle per the turntable's specifications.
User questions about 2MR ORTOFON
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Uncategorized in PDF format for free! Find your manual 2MR - ORTOFON and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. 2MR by ORTOFON.
USER MANUAL 2MR ORTOFON
Manual assistant
Powered by Anthropic
Waiting for your message
Product information
Brand : ORTOFON
Model : 2MR
Category : Uncategorized