MP-180 - Receiver Omnitronic - Free user manual and instructions
Find the device manual for free MP-180 Omnitronic in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | Receiver |
| Brand | Omnitronic |
| Model | MP-180 |
| Dimensions (W x H x D) | 430 mm x 100 mm x 300 mm |
| Weight | 5.2 kg |
| Power Supply | AC 230 V, 50 Hz |
| Power Consumption | 50 W |
| Tuner Bands | AM, FM |
| Output Power | 2 x 100 W (RMS) at 8 ohms |
| Inputs | 3x RCA, 1x AUX, 1x Phono |
| Outputs | 2x Speaker terminals, 1x Subwoofer pre-out |
| Frequency Response | 20 Hz - 20 kHz ±1 dB |
| Signal-to-Noise Ratio | >85 dB |
| Remote Control | Included |
| Display | LED segment display |
| Cooling | Convection |
| Operating Temperature | 5°C to 35°C |
| Housing Material | Metal chassis with plastic front panel |
| Cleaning | Wipe with dry cloth; avoid solvents |
| Protection Features | Short-circuit, overheat, overload protection |
| Safety Compliance | CE, RoHS |
| Spare Parts Availability | Contact Omnitronic support for service |
| Warranty | 2 years |
Frequently Asked Questions - MP-180 Omnitronic
How do I connect speakers to the MP-180 receiver?
Use high-quality speaker cables. Strip the insulation, insert the bare wire into the speaker terminals (red for positive, black for negative), and tighten the binding posts securely.
Can I play music from my phone via Bluetooth?
The MP-180 does not have built-in Bluetooth. Use an AUX cable connected to the AUX input or an external Bluetooth adapter plugged into the AUX port.
How do I set the FM radio stations?
Press the TUNER button to select FM. Use the tuning knob to find a station. Press and hold the MEMORY button, then select a preset number (1-30) with the knob and press MEMORY again to save.
What should I do if the receiver turns off automatically?
Check for overheating. Ensure proper ventilation. If the protection circuit activated, let the unit cool down for 15 minutes. Also verify speaker impedance is not below 4 ohms and that there is no short circuit.
How to clean the receiver?
Unplug the unit. Use a soft, dry lint-free cloth. Do not use chemical cleaners or water. For the front panel, slightly dampen the cloth if needed, but avoid moisture entering the device.
Is the remote control universal?
The included remote is designed specifically for the MP-180. It controls volume, input selection, tuner functions, and power. It uses two AAA batteries (not included).
Can I connect a turntable?
Yes, if your turntable has a phono output (no built-in preamp). Connect it to the Phono input. For MM cartridges, the receiver has a built-in phono preamp. For MC cartridges, you may need an external preamp.
Why is there no sound from one speaker?
Check the speaker connections. Swap the speakers to isolate if it's the speaker or amp. Ensure the balance control is centered. Also verify the input source is not mono or defective.
How to reset the receiver to factory settings?
Turn off the unit. Press and hold the POWER button for 5 seconds. The display will flash 'RESET' and the unit restarts. All presets and settings will be erased.
Does the receiver support 4-ohm speakers?
Yes, it is designed to drive speakers with impedance from 4 to 16 ohms. For 4-ohm speakers, ensure adequate ventilation as the amplifier will run warmer.
User questions about MP-180 Omnitronic
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Receiver in PDF format for free! Find your manual MP-180 - Omnitronic and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. MP-180 by Omnitronic.
USER MANUAL MP-180 Omnitronic
Manual assistant
Powered by Anthropic
Waiting for your message
Product information
Brand : Omnitronic
Model : MP-180
Category : Receiver