LX-380 - Hi-Fi System LUXMAN - Free user manual and instructions
Find the device manual for free LX-380 LUXMAN in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | Hi-Fi System |
| Brand | Luxman |
| Model | LX-380 |
| Dimensions (W x H x D) | 440 x 130 x 370 mm |
| Weight | 12.5 kg |
| Power Supply | AC 120V / 230V, 50/60 Hz |
| Power Consumption | 150 W |
| Output Power | 2 x 50 W RMS (8 ohms) |
| Frequency Response | 20 Hz - 20 kHz ±0.5 dB |
| Total Harmonic Distortion | < 0.05% |
| Input Sensitivity | 200 mV (line) |
| Signal-to-Noise Ratio | 90 dB (line) |
| Supported Media | CD, FM/AM tuner, AUX |
| Speaker Impedance | 4 - 16 ohms |
| Connections | RCA line in, speaker terminals, headphone jack |
| Remote Control | Included |
| Cleaning and Maintenance | Wipe with dry cloth; avoid solvents |
| Safety Precautions | Do not expose to moisture; use only specified power cord |
| Spare Parts and Repairability | Contact authorized Luxman service center |
| Warranty | 2 years (depending on region) |
Frequently Asked Questions - LX-380 LUXMAN
How do I connect my Luxman LX-380 to speakers?
Use the speaker terminals on the back. Connect the positive and negative wires to the corresponding terminals. Ensure the impedance is between 4 and 16 ohms.
Can I use the LX-380 with a turntable?
Yes, if your turntable has a built-in phono preamp. Otherwise, you need an external phono stage as the LX-380 does not have a dedicated phono input.
How to clean the LX-380?
Unplug the unit and wipe the exterior with a soft, dry cloth. Do not use any chemical cleaners or solvents.
What is the power consumption in standby mode?
The standby power consumption is typically less than 1 W.
Does the LX-380 have a built-in DAC?
No, the LX-380 is an analog amplifier. For digital sources, you need an external DAC with analog outputs.
Can I use the headphone output without speakers connected?
Yes, the headphone jack works independently. You can listen without speakers without any issue.
What type of remote control does the LX-380 use?
It uses an infrared (IR) remote control. Point it at the front panel sensor. Batteries are typically AAA.
How to reset the LX-380?
Press and hold the power button for 5 seconds while the unit is on. This restores factory default settings.
Is the LX-380 compatible with 4-ohm speakers?
Yes, it is rated for 4-16 ohm speakers. However, ensure adequate ventilation when driving low-impedance speakers at high volumes.
What should I do if the LX-380 does not turn on?
Check the power cord and fuse. Ensure the mains switch is on. If it still does not power up, contact a qualified technician.
User questions about LX-380 LUXMAN
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Hi-Fi System in PDF format for free! Find your manual LX-380 - LUXMAN and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. LX-380 by LUXMAN.
USER MANUAL LX-380 LUXMAN
Manual assistant
Powered by Anthropic
Waiting for your message
Product information
Brand : LUXMAN
Model : LX-380
Category : Hi-Fi System